Having problems with your Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum ?

Worked once..next time,no power,no lights,no heat


Answers :

Hi,
Return it under warranty.. check the manuals link...

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101
Repair Help & Product Troubleshooting for Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Rv Dometic over the range microwave does not heat..the light works the turn table spins the hood/stove light works the fan works but it does not heat.


... Vacuums

DZ9080 IRON IS NOT VERY OLD, BUT HAS HEATING AND STEAMING PROBLEMS. IT MAY BE ALL HEATING RELATED! MY WIFE WILL SOMETIMES JUST LEAVE IT "ON" FOR TWO HOURS AND THEN IT WILL START STEAMING AGAIN. I CANNOT MAKE SENSE OF THE HEATING INDICATORS; SOMETIMES IT WILL STAY GREEN NO MATTER WHERE YOU SET THE DIAL ---- AND IT DOES NOT FEEL HOT! WHEN I TRIED IT AGAIN TODAY, THE SHOT-OF-STEAM WORKED FOR A WHILE (AND THE SPRAY WORKED), BUT THEN ALL IT WOULD DO IS DRIP WATER AT THE TIP WHEN TIPPED DOWNWARD.


I couldn't find any warranty information on this iron, but I suspect that the heating element either has a faulty connection or part of it has cracked, making contact at time, but poor contact at other times. The unit will have to be taken apart an ... Rowenta Vacuums

Shark Steamer model S3325 will not power on; switch appears to be working but will not indicate on and will not heat tank. I can hear it try to start the heating element (secondary clicks) however, does not seem to work.


There's a thermal fuse inside. If it gets too hot, the fuse will blow and the thing won't turn on.\015\012\015\012It has a 216 C temp limit. You can find thermal fuses at radio shack for less than 5$. If you're adventurous enough, you can fi ... Euro-Pro S3325 Handheld Steam Vacuum

My Charmglow Electric heater is not working. The problem is when i turn on all the buttons which includes blower fan, heat 1,heat 2, and firebackround motion. Only the fire backround motion goes on nothing else. I did notice that the fan button is not working properly


... Vacuums

We have a dyson dc 07 animal the machine was working fine then switched off after returning to the machine minutes later it wouldnt switch on, i removed on off switch cover and used a short piece of wire across the brown wires flicked the wall switch and it worked, aha i thought faulty switch aquired a new one to no avail and now even the short piece of wire trick doesnt work, has the motor died do you think, it wasnt over heating or making strange noises prior to refusing to work


It could be the motor. I'm having to replace the brushes on my DC 05. It appears that you can only get brushes for the YDK motors in the DYSON, not the Panasonic motor. Which might be saying something about the YDK motors. What happens is that the ca ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

I cant detect where the damage but it dosn't work or even the light indicator didn't open, no heat even in maximum level, i plug in for almost an hour but the iron is not responding or not really working and still cold.... how can we fix to make this appliances work again? tanx,


If it's an old iron, then maybe there is some loose wire inside, which could be fixed with proper tools and some knowledge of electricity, but if you are not familiar with taking apart electric appliances - you should just replace it, because it is p ... Vacuums

Bissell Pro heat stopped working


It sounds to me like you may have a bad brush and/or pump belt. Since you are having a simultaneous problem of the brushes not spinning, as well as the solution not spraying, this is the most logical explanation of your problem. Especially if ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a new (couple of months) Cuisinart Espresso Maker EM-100C. One has to turn on the power button on the front in order for the unit to heat the water. The button will only work if the two manual knobs are in a certain position. Very occasionally, it took a few tries to get the button to turn on. Now it usually does not work but will once in a while. Any ideas what we could do to repair this problem?


... Vacuums

My steamer stopped working, won't heat up at all. Haven't had it longer than 3 months! I plug it in and it won't heat up.


... Eureka Enviro Steamer 310 Stick Vacuum

I have had my RCA microwave model # RMW1108 for about 8 months now. It was working fine until yesturday evening. I went to warm up some food for 2 minutes, the microwave itself was on and everything appeared to be working except my food did not get warmed up. I plugged it out and checked all over it for any damage but i could not find anything wrong. What would cause it to just stop heating up the food? Is this type of problem covered in the 1 year manufacturer's warranty.


... Vacuums

I have a shark steam mop and it will not get hot and steam the water so I can clean the floor. The green light works on the front and that is all that works. It there an element or something inside that heats the water. It is under warranty they should have to replace it.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

We have a GE Advantium 120 microwave. all sounds like the unit is working all controls work. it does not heat at all. I have the shelds off and do not see any problems. what do you think is the problem and how do I test for it? thank you for your help.


If the unit works but it doesn't heat then the magnetron isn't working. The only way t test it is to measure the 2 voltages that power it: the heating coil - 5 volts AC and the high tension - 5000 volts DC. While you can measure the heating voltage ... GE Vacuums

Bissell Pro-Heat 7901-1 no cleaning solution is pumped out. The flow indicator is spinning and the belt is spinning the beater bar. Have cleaned the flow indicator, checked vavles in the solution tank and water tank and they are working properly. Also checked the trigger to make sure it works okay. Any ideas?? Moody Fan


Bissell Pro Heat shampooer - Fill the soap dispenser with extremely hot water and shampoo with only water for a few minutes. There is often dried soap in the lines. Make sure that all filters are clean. Press the soap container and the water conta ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I purchased a brand new Techno 1000 Fog Machine last Halloween. It worked fine, but once I ran the cleaning fluid through the fog machine only heated up and produced no fog. A year later and now won't even heat up at all, even after replacing the fuse!


... Vacuums

I have a bissel pro heat carpet cleaner that doesn't spray cleaner solution, everything else works, but I don't know whether it's the pump or the heat unit.I'm assuming that the pump unit must be bad since all the connections are in place, but from the view of the pump I am not sure what drives it.


I have a bissell steam cleaner 1698. I have had it for a few years. First and last time I used it I was sorely disappointed. How was the word steam integrated into the name. I saw no steam. Ended up soaking my couch, soaked spots on my rug and n ... Bissell 1693 PowerSteamer Upright Vacuum

My Shark Steam Cleaner has stopped heating water to make steam, how do I repair this? This is an older model and no longer under warranty, but when it was working it was GREAT and I want it to work again.


... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

My bissell pro heat 2x does not **** up the water from either the upholstery cleaner or carpet cleaner. Any thoughts as to why? The water and heat functions work it just does not pick up


First check the motor duct gasket. The motor duct gasket is visible once the tank is removed. It is located underneath the handle on the top of the base of the machine. It has a black rubber coating around it. If there is no suction there please let ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Sharp R-1480. Microwave would not start - jarred door, and it heated and worked. Replaced bottom of the 3 inter-lock door switches. Turns back on - all seems normal. No heat (it does overall sound louder). Thanks, Mark [email protected]


Hi Mark,It sounds like you have a magnetron problem now or at very least a rectifier that is shorted. The elevated sound level comes from one of those two components. But since you had a door switch problem I would lean toward ... Vacuums

My bissell pro heat carpet cleaner is not working properly...the scrubby bar is not turning... the belt is intact and working and it is turning the knob inside but the brush bar does not turn


How are the bearings? Maybe the motor that drives the belt is burnt out. ... Vacuums

Stopped working new item given as a gift, used once, in the middle of cleaning then died. Did as manual stated for over heating, empty canister, clean all filters and allow to cool for an hour. Left over night, tried the next day but does'nt work???? What can i do???


... Vacuums

I have a bissell pro heat model 7901-B that has power but no water circulation. I was told that the previous owner used it without water and that she couldn't get it the power on. I bought it off of her and cleaned it out and now the power works, but there is no water circulation. The brushes run and heater works, just can't seem to get it to circulate water. Thankyou for your time, Don


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

The Eureka Environ Steamer won't heat up. It feels lukewarm and no steam is emmitted. It worked perfectly the first 3 times I used it but now, nothing! There is water in the tank, and the electrical outlet is working. The green light is lit on the unit, but it doesn't get warm.


... Eureka Enviro Steamer 310 Stick Vacuum

I bought a used vacuum seal machine (hobart model ht-120) it does excellent vacuum but it doesnt seal correctly all the time. it seems like there is something wrong with the valve that activates the bar that goes up and makes pressure and heats the bag for complete sealing. The heating is perfect but what is not working is what make the bar go up and down.


... Vacuums

Heat dry feature not working on hoover spinbrush steamvac. It worked the first few times I used it , but now after sucking up the water the carpet is cold, not warm like it had been on other occasions.


If you are not mechanically able, then you best take it to a service place because it could be the heat element neesd replacement, or the selector switch that turns on the element, or a wiring connection that got loose or burned. Goodluck,Macgivor ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Bissell Pro Heat Select 2X does not pull up the dirt from the carpet into the water. The water just slowly disappears. The first time I used it the water got really dirty. The very next time I used it it worked differently and the water just disappeared until it was all gone. I've only used it a couple times and I don't see where it is working. Has anyone else had this problem?


Inside the plastic suction lid is a little red plastic filter that has to be cleaned out every time you use it because it sounds like your vaccum is not picking up all the hair and debri before you clean the carpet causing the water to be injected in ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0501 seconds