Having problems with your Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum ?

Need video or large diagram instructions for what to put together

\015 Bought Shark S3501 Steam pocket mop to clean near new hardwood floors. Need diagram instructions for what to put together to use Shark steam pocket mop, including which pocket or cover for hardwood. Pamphlet that comes with it is long and small print and diagrams not good enough. Do you know of a video that shows how to do this?\015

Answers :

Before using steam mop, vacuum up or run dust mop over floors to release all loose dust and debris. Notice if anything like tar or stuck on food that sticks up a bit from floor and remove. (The stea, mop can clean surface drips but not something that you can feel sticks up by running finger over it; remove from floor first).
\015\012Attach the rectangular attachment to the bottom of the steam mop as seen in diagram showing it all put together; this is the main pic for the steam mop.
\015\012Then choose the purple pocket, (the shaggy latex looking one with the 'little fingers or knobs) and attach to the rectangular attachment. You may have to open the velcro along the top first, but then slide it up from bottom toward where the rest of the mop is, as if putting a pillow on a pillow case. Tug a bit at the top so you can fasten the velcro tabs together over the top of the attachment.
\015\012Unscrew knob that is on the front at about waist high on the mop. Fill the cup provided with water to the fill mark. Pour water into the water holder and replace knob and turn just a bit until tight.
\015\012Plug the cord into an electric outlet.
\015\012Place mop in area to be cleaned.
\015\012Wait about 1 minute and then start pushing the mop on your floors. You will need to use a scrubbing motion back and forth as it is this motion that releases the steam. The mop is not self propelled; it takes some muscle to scrub/mop the floors with steam coming out.
\015\012Mop one small area at a time and go back over it to clean that area. i.e. in a relatively small room, clean two boards at a time from one end to the other; in a larger room or hallway, clean about a 3-4 foot section at a time.
\015\012If you have a fairly large area or more than 2 small-medium rooms, you may have to refill with water, but not usually. If you do need to refill, be sure to unplug mop first, then repeat from start of mopping.
\015\012Remember as you are cleaning that you can flip the mop foot over and use the other side of the pocket. For example, after cleaning a 10'x10' surface.
\015\012This should work for you. I know I had to look up video just to see what they were cleaning with on each surface although no directions. (The one below does not show the purple pocket in use for wood floors but that is the one you use; you could probably use a white quilted one on lamintate floors so presume that's what they were doing here and that was not hardwood):
\015\012Hope this helps

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.


Repair Help & Product Troubleshooting for Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need video or large diagram instructions for what to put together

Before using steam mop, vacuum up or run dust mop over floors to release all loose dust and debris. Notice if anything like tar or stuck on food that sticks up a bit from floor and remove. (The stea, mop can clean surface drips but not something tha ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I bought new belts to replace the old ones (one had broken and the water would not feed) My cousin took it apart and now I need to put the new belts on and get it back together - do you have instructions or a diagram?

There are different variations with Bissell. They have the ProHeat series and a Power Turbo series. Below is a link with instructions and diagrams for the Belt Access Door. If this doesn't solve your problem or isn't the correct model, please post ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have an electrolux epic series 2500 SR that is in pieces and I need to put it back together, I need to get a diagram to make sure it goes together correctly.

... Electrolux Vacuums

Need to open rotating brush part of vacumm as motor functioning but roller not turning...perhaps belt broken put need to get into ..inside brush box ...Need help need instruction with diagrams Thanks for help Robert

... Panasonic MC-V9638 Bagged Canister Vacuum

While putting on a new belt for my Turbo 4000 Hoover upright vacum cleaner, the parts for the height adjustment (slide bar)fell apart. I'm hoping that you might have a diagram or detail instructions on how to put together again. Thank you

... Vacuums

Hoover u5753900 i took the hoover u5753900 apart just need a diagram on a couple parts to put it together..... just wondering where to get a diagram real quick...

Check google images. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

I have a Hoover Slider, Model #S2105, Serial #050500084989, and I need instructions on putting it back together; with parts and assembly of parts. I took it apart because it was making a noise, and I believe one of the belts had come off. However, when I took the screws out of the bottom to check the belts, the whole thing fell apart. Now I can't get back together properly. It will not come on, and I believe it is because the switch that makes it come on when you lower the handle is not posi

Greetings from GoVacuum,\015\012\015\012Please see the link below for a parts schematic to your Hoover Slider, hopefully this will help you put the machine back together. If you find a part that is missing, and would like to order one, j ... Vacuums

We had to take the bottom of the vacuum apart to remove dirt that had plugged the hose. We cannot put it back together so that the smaller round belt stays tight. I need a diagram of how this belt is supposed to fit.

Most vacuum manufacturers avoid putting their shop manual in the public domain. There are various reasons for this, some good ones.\015\012But I did find this. Maybe it'll help.\015\012 ... Hoover U6441-940 WindTunnel Bagged Upright Vacuum

My bonjour cookie factory came without instructions and I need help figuring out how to put it together for use.

... Vacuums

There were no instructions included with purchase. I have viewed the assembly video but have nothing else to go by. I believe I have not put it together properly now as it makes a whale sound with each rotation and now the reset switch is pushed in and not working.

What sort of a Vacuum is it? and where is the 'Whale' sound coming from?With each rotation?-- of what-- the power nozzle-- or the vacuum-- or what?Please tell us more, so we can understand what is wrong-- and with what? ... Vacuums

I am trying to install new belt. I got the bottom of the vacuum off, but now I need a diagram on how to put it back together.

... Eureka 431A Optima Bagless Upright Vacuum

How to Install part #KC64EDTEZV06 in the Kenmore canister vacuum cleaner model # 116.22512504 I need a diagram please put pu all the correct wires and parts back together

... Vacuums

Continued problem At this point I have hopelessly disassembled the unit and I have no idea how to put it back together I need a diagram or a source to have it done for my. Any ideas?

Remove the rubber strip from each side. Open to access the bag. Slip a thin srcewdriver between the case and the small strip (that runs the lenght of the case) about 3/8 of an inch in. You should then be able to slip the strip out. Be careful whe ... Electrolux Epic 6500 Vacuum

Need diagram to put switches back together

... Vacuums

Park-o-meter made by rockwell manufacturing, in Pittsburg,Pa.. Aprox.age ,built in the 60"s. Need instructions book or chart on how the inside mechanism is put together.

... Vacuums

I need to know how to put together a Hoover Slider vaccum. I had to take it apart and now i need to put it back together.

... Hoover S2105 Slider Bagless Stick Vacuum

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm

I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I lost the instruction manual and dont know how to put the string in or how to put anything together can u please explain to me how to put the brother xl3750 sewing machine together

Here is a link to your manual:homeappliance.manualsonline.com/manuals/mfg/brother/xl3750.htmlAll you have to do is ... Vacuums

Need help putting my bissell carpet shampooer back together

The side that is dragging needs the roller that the brushes are on ,to be precisly pushed back up in it's place,it will take a few minutes and it will not slide back in place easily just use a little force as for the hose diagram, bissell.com,enter m ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

My daughter pulled to hard on the ceiling fan pulling out the chain. i have taken it off and apart, nothing appears to be broken but im trying to figure out how to put it together so it retracks, i assume it has something to do with the tension of the small spring inside of it, but not sure how to put it back together im wondering if there is a internal diagram of this ???

Don't even bother to repair the pull chain switch, get a new one at KMart, HomeDepot or similar store for less than $2.\012\012Two times I've repaired one, it comes apart when I need it the most.\012\012Good Day! Don't forget to rate thi ... Vacuums

Bissell 7901 hoses need to be put back together

We don't have the diagrams, but our service centers can help you with your problem. Find the nearest one to you at:http://www.bissell.com/service-centers/?cid=ccsocial ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I own a singer sewing machine model 4562 and tension assembly came unscrewed and now I don't remember how to put the pieces back together. Do yo have a diagram that can be emailed to me so I can put it back together? Thanks

... Vacuums

I need to put my kenmore vaccum back together I took apart the lower unit to get the roller it got gunky and all around the roller got gunky, Now it;s a bear to put back together

Remember the last thing you took off and start there,work your way in reverse towards the first thing you took off ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I need to know how to put bissell proheat 2x back together

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I took my durabrand toaster oven model t0-80 apart and i need the wire diagram to put wires back on it cause it needed cleaning.

... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0711 seconds