Having problems with your Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum ?

I have a shark steam mop s3202 and it seems to be clogged - no steam. I hear if you put white vinegar in it it should help unclog it. Are you suppose to let it sit awhile. Should it be plugged in?


Answers :

Hi,
Yes, plug it in...

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101
Repair Help & Product Troubleshooting for Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a shark steam mop s3202 and it seems to be clogged - no steam. I hear if you put white vinegar in it it should help unclog it. Are you suppose to let it sit awhile. Should it be plugged in?


Hi,Yes, plug it in...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro S ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Omc specs 1989 rinker boat 4 cylinder gm/omc i need specs for: plugs, points,idle, prop size,etc. boat had been sitting for a while, i changed oil,points,plugs, new gas,etc. i can crank it, but it's a little rough and won't idle below 2000 rpms. any advice or help would be appreciated. thanks. tommy


You will need to repost this in the correct section, this one is for vacuum cleaner repairs. ... Vacuums

The pump motor in my Bissel Proheat 2x Plus seems to have failed. It was seized so I sprayed WD-40 in it and let it sit for 3 days. Now I can turn it by hand, but when plugged into the unit it still doesn't spin. Here's a picture: http://bbay.dreamhost.com/bissel_proheat_2x_plus/P1070021.JPG I wanted to take the motor out and hook it into another power source to see if I can get it going but it has 3 wires. I'm used to only 2 (+ and -). How can I hook the motor up to another power source,


... Bissell Vacuums

My Infinity nv29 vacuum stopped working suddenly while vacuuming. I followed the directions in the manual and unplugged it and let it sit for over an hour and then tried plugging it in and turning it on. It still will not turn on. Any suggestions?


... Euro-Pro NV31 Infinity Vacuum

Bissell proheat I cleaned a thin carpet and it won't pick up the water. We cleaned the unit and let it sit for a few days and tried again. The water will dispense but the machine will not extract the water from the carpet. Help


Where the lip of the tank sits on the clear window, is the gasket there? If it is missing, it won't suck up the water. It is black, oblong (#24)and sits in a slot on the clear window providing a seal for the tank. Is the filter clean(#62), should ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Hoover mach 3 cyclone vacuum shut off during useage. can't turn it on. cleaned it out and let it sit thinking overheated? this is 2 months old. help?


I had same problem. Turned out to be the filter that sits above the waste cannister. Remove the waste cannister. There is a little orange lever that releases the filter. It was caked with dirt not allowing any air flow causing the motor to overheat. ... Vacuums

Hi - I have a sinkmaster premium special edition 3/4 horsepower which seems to have slowed down and the water is just sitting in the sink. I have tried to find a red button on the bottom to see whether pressing it will unclog the system but can't find it. Can someone help?


... Vacuums

Hoover S3765 I have a Hoover S3765 (serial # 040600024465) and the unit stops working for no apparent reason. The light on top of the unit goes off when it shuts down, so I don't believe it's a problem between the hose, the tube and the floor unit. Sometimes I have to let it sit for over one hour before it will come back on. I've tried different electrical plugs too. Still won't turn on. Any ideas or suggestions? Thanks


If you light and nozzle motor both go off at the same time, you might have a bad power cord. Mine had this problem which I could verify by jiggling/twisting the cord near the strain relief on the nozzle. It would go on and off as I did this. ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

Hi, I have been given a beautiful Husqvarna Prisma 980 and the power seems to have stopped getting to the machine.. The first time I plugged it in it worked, all the lights came up where they are supposed to, then the second time nothing =( Some help would be appreciated as I would like to fix it instead of throwing it in the bin Thanks Vicky


If you're really serious about getting this machine running, you need a service manual. Here is a .pdf download manual:\015\012 ... Vacuums

I have the same problem as discussed above. My Hoover Pet Cyclonic upright stops working while using it. The bottom feels hot when this happens. When it first occurred, I emptied the canister and even tried a different plug. It did not turn back on for over an hour. When it did turn back on, it would die again after about 3-5 minutes of use. I don't know what else to try. I have washed the secondary filters, let them air dry and replaced them and this did not help the problem. My friend,


... Dirt Devil Hoover Uh70085 Pet Cyclonic? Upright Vacuum

Vaccum overheating I have a hoover u5458-900 wind tunnel and the auto shot off has kicked in for overheat protection. i've cleaned the entire thing and let it sit like i was supposed to but it still won't fully turn on and stay on. it will turn on for a few minutes and then shut off and just cycle like that for a few times. is there anything i can do to fix this or should i just clean it more (if possible)?


Either the motor protector is bad, or you have a clog in the hose or the dirt inlet by the brush roll. Are the filters clean? It is also possible that there is a problem with the motor. ... Vacuums

My hoover elite rewind does not pick up dirt like it should. how do i check for a clog? I can hear it picking stuff up but when I empty the cannister there isn't much in it. today it shut off like it threw a breaker. I let it sit and plugged it back in and it started working again. don't know if the problems are related or not. any suggestions??


Have you cleaned the inside filter? Open the cup hold on to the yellow piece in the center and twist it to unlock (there are arrows on the pieces to show how far to twist). Take the filter out and try to clean as much of the debris off of it. ... Vacuums

How do I unclog a bissell vaccum? I'm not just talking about unclogging the hose, I need to unclog the complete vacuum cleaner. HELP!!!


Well firstly, whats the model number and do you have the user manual to hand? If the main hose has been unblocked, then it could be the main dirt channel which is blocked just after the moving roller brush panel. A long pipe cleaner or wi ... Vacuums

My sunbeam water cooler model #YLR2-5-67H3 has been sitting unplugged for 3 years. I moved, plugged it in and put a water bottle on top and water went all over the floor. I unplugged it, (read the instructions on the front, duh) and it still leaks on the floor. What should I do? I put it over the sink, emptied it, checked the drain plug, tried running a glass full of tap water through each tap. Only the room temperature one would work.


One of the rubber connecting hoses inside it has dried and aged so the pressure of the water from the bottle made it burst.\012\012\012You will need to open it, find the defective hose and replace it - a 2 hour relatively easy job. The hardest ... Sunbeam Vacuums

I recently purchased a Sunbeam Artista EM5900 model coffee machine. I plugged it in and pressed the 'Power' button only to find the power go out. I understand this is short circuiting, so I went and turned the power back on. I then moved the machine to a different powerpoint and plugged it in - the same problem happened and I have tried it countless times on various other powerpoints. Help please?


Try it in a different part of the house. If it works then you have too many things running in the kitchen.\015\012If it still blows a breaker then it is shorted out and needs to be returned. ... Vacuums

I need a manual on a trim a home christmas tree set its a aspen pine with 600 lights it has a series of steps on how to plug in the numerous plugs on it so that all the lights light up...lost manual need help


... Vacuums

When I plug in my dyson dc14 it's just stays on it only shuts off when i take out the plug. Help?


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Our kenmore progressive model #11634922 was working fine today. And then - it's not. Plugged in - nothing is working on it. We let it cool down (though it didn't seem hot). Still nothing - no light, no motor. Tried it in some other plugs that we know are functioning well - and still nothing. Any idea what might be wrong with it? It's six years old but doesn't get heavy use. Thanks so much ~ Susan Golden


Hi, it could be a number of things, cord may be bad as well as a problem with the motor. There also is a fuse that could have blown. If you go to sears.com, click on parts, put in your model number, when the page loads, click on the first link ... Kenmore Vacuums

Hello, I've had my purple Dyson for several years. Now however the area to turn on and off won't work. I plug it in to run it then unplug it to turn it off. However I see electricity at the plug and that is scary. Help


The switch must have failed and melted. take the switch cover off and inspect the switch. You will probably need to replace it. I have a video of how to do this. let me know if you need it and ill send you the link to my adrive.com account so you can ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I got a vacumn from a friend who ungraded and though i used at her home when i got it home it would not turn on when plugged in and i check everything and no use. my friend lost her manual. im in my 60's and on a disability fixed income so cant afford to take to repair but got lots of men at church who would help if they know how to trouble shoot it. and would really appreciate any help. thank you , ann


Hi\015\012In the UK we have similar machines but they are made by Vax. If you can't source the correct user manual from Hoover.com consider the following - it is a free download.\015\012\015\012http://www.vax.co.uk/downloads/pdf/vzl-60156016_v2 ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

Help ok the diagram is helpful but i have a black wire that came loose from somewhere it has a little prong on it does it click back in opposite from the white let me know please


I am not sure what exactly you are referring to but I think that it may be a motor lead. See pictures below (shown is white but second wire to the motor is black) ... Rainbow E series Canister Wet/Dry Vacuum

G4 plug i'm trying to replace the plug just don't kow which wire is which? can u please help


Brown wire to fuse (Live), blue wire to left pin (Neutral), Green and Yellow wire (If fitted) to top pin (earth). ... Kirby G4 Bagged Upright Vacuum

I had plugged it in to use it, turned it on and instantly it made a pop sound, smelled of electrical, and would not turn on after. i even waited for a while let the smell go away and tried a different plug in the house and still no operation of any kind. Is there an internal fuse that i could check on this? where is it located?


Sorry there is no fuse in the vacuum. It sounds like there is a short somewhere when they manufactured it. There is no way to fix yourself you will need to take to a repair shop\015\012\015\012Good luck ... Vacuums

Miele s7000 I clicked my upright into sitting position and accidently bumped the foot release knob. The body fell back and now I can not get it to click back into upright sitting position. Something is now in the way of it locking into place. This happened last year and it was under warranty. it no longer is and I would like to be able to fix it myself in the future. Can you help me? Thank you. Kacee in Oregon


... Vacuums

While using my mop yesterday, it stopped letting steam come out. Tonight I plugged it up again and you could hear it trying to steam. I push the button in to release the square frame and it pushed out a burst of steam and pushed the head off. Put it back together and it still will not let steam out. No matter how much water is in it.


\012Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Ste ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0626 seconds