Having problems with your Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum ?

My shark steam mop handle broke, is there anyone who sells the replacement parts for these?


Answers :

I know of a great site that sells all kinds of shark parts check it out\015\012
\015\012http://stores.ilikenew.com/-strse-Replacement-Parts/Categories.bok
I know of this great site, that sells replacement parts <a rel='nofollow' href="http://stores.ilikenew.com/-strse-Replacement-Parts/Categories.bok">iLikeNew</a>
Repair Help & Product Troubleshooting for Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My shark steam mop handle broke, is there anyone who sells the replacement parts for these?


I know of a great site that sells all kinds of shark parts check it out\015\012\015\012http://stores.ilikenew.com/-strse-Replacement-Parts/Categories.bok ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I had a house fire and lost most of my belongings. But I had just purchased a Shark Steam mop 3501. Loved it. Well it did not get destroyed in the fire but someone managed to break the handle off. Just the handle itself was broke off the rest of the handle rod is ok. I'm trying to see if I can replace the handle and not the whole shaft. Can you help me.


Yes you can replace jus the handle, the replacement part for the handle is available at the manufacturer's web site in the Parts and Accesories section. Enter M/N: S3501 to confirm it's the same as on your unit.\015\012\015\012 ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Model number U5763900 Serial Number 090400013588 Handle broke off just above the four screws that attach it ti the boby of the vac. Hoover does not list parts for models that are more than two years old. The vac operates perfectly but without a handle my wife cannot use it, where can I find a part replacement. easy to remove four screws and replace. dont want to drive 100 or more miles to find a authorized repair shop. Oh yes, this is a Hoover Preferred Wind Tnnel Bagless


Get over it and buy a new one!!! ... Vacuums

I broke the handle part of the shark steamer #53101. I don't have the book to try to tell you the parts I need. Can you send me a picture or a copy of the steamer. It is purple. The above number may not be the correct one. It is broken in the center part. It has a little small circular piece that joins the two pieces which are broken. The beginning of the handle at the bottom of the steamer and the next session which has the steam release. The top of the handle is okay . It the middle and bottom


Hi,Ann there are very few parts for these...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

The handle on my steam pocket mop broke into - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,There is a year warranty..Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Eu ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

My shark steamer has stopped working after a year of having it (I have already replaced one, I'm a idiot!). My problem; however, is that it will steam, but the steam stops traveling through the actual "mop" part. I plugged it in, wait seconds and start pumping, but the steam builds up until it's hard to pump. I had to press the button really hard for the bottom to come off and it shot off like a rocket! I tried to stick something through the tubing, but it did nothing. What am I doing wrong? I


\012\012\012Hi,Here\012is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it\012may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Part replacement we have one of your "Shark steam cleaners", that while moving from one room to another, was dropped. The head separated from the part that holds the water and broke in the process. Can this part be purchased.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

VACUUM REPAIR I have a Hoover Savvy upright, windtunnel, bag/bagless vacuum (model U8150-900). The Handle Release Foot Pedal - Part #38434026 broke soon after purchase but I finally found a source to replace this item. The problem is that now that I have the repair part I cannot figure out how to remove the old pedal and install the new one. The housing appears to be one piece of solid plastic. Any ideas, PLEASE! Peter


There are 2 tabs that stick out on the release, they fit in slots, so from the top look down and you can see them, using a flatblade screwdriver that will fit in there, push the side in to release it, which isn't easy, but it can be done. When you g ... Vacuums

The handle on my h2o steam mop broke. Where can I find a new handle?


We have no resources to find parts, sorry if u didn't understand that, that said based on my experience you will not be able to buy parts for this, this type of product is considered "throw away" ... Vacuums

I need to replace the cord on an older Hoover upright, model S660, about 1986 vintage. The cord broke where it enters handle. Handle comes apart easily. Just not sure how to pop the switch out without breaking it. Was looking for a manual online to see parts diagram and/or instruction on disassembly and cant seem to find one for that old of vacuum.


Check ebay. those vacuums are worth fixing. I loved them. they would **** the carpet off of the floor! those cords aren't hard to replace.just remember the way you got the old one out. ... Vacuums

Hoover F8212-900 Agility steam vacuum - problem reassembling handle parts (clean spurge button, spring, etc.) after replacing lower short hose.


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Replacement parts for steam mop


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Need a replacement handle modle S3101C - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,Look under the manuals link... they sell replacement handles...\012\012Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Need replacement thermal fuse for Shark steam mop Model:S3101W PART SEFUSE SF188E 192 DEG C 10A ET250V 00795 Joe Cook 502-839-6634


SE Fuse is a one time link. If it pops it must be replaced. Found them at Goodman thermal fuses for $1.25 ea. Not sure why it failed, unit is 6 yrs old, always used distilled water, never had a problem, it just quit. Circuit seems to be fine, will ... Euro-Pro S3325 Handheld Steam Vacuum

When pressing steam does not come out. need to get pump. Need to replace the oump. Do you sell parts???


Hi,No parts, but check the manuals link...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a euroflex multi cyclone monster, the handle broke off of the attachment. Where can I get a replacement part?


... Euro-Flex SC60 Canister Steam Cleaner

Can a replacement handle be purchased for a Shark Steam Mop?


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I purchased my Shark EuroProX Steam mop model s3203 at Bed,Bath,Beyond a year ago. Because of health problems I've only used the appliance once. While using it today (2nd time), the handle rod broke into - there is no way to fix it. Please give me your advice. Thank you. Carole


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Bought Hyundai steam mop sliding seal ring seems to be missing from handle where can I has anyone else had this problem Maureen


... Vacuums

The handle release lever (Part N. 38434-021) on my Hoover WindTunnel upright vacuum (uses Y bags) broke. How do I install the replacement release lever (pedal) that I purchased?


You can buy Hoover Handle Release Lever 38434-021 at \015\012http://partsreadyonline.com/item.php?ItemID=798 ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Ive a dyson DC05 in perfect working order, but the telescopic tube and the handle are broken, how much roughly should it cost to replace them? And does anywhere sell second hand parts?


Hi there SmartAlec from NelsonVacuums.com.au your post doesn't say where you are from but if you are in Australia then the rod is about $50 and the handle $20. If you are l ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

I need a replacement tube for a Shark s3101w steam mop. Where can I get parts?


Hi,There are parts on the manuals link , but I don't think that part is one of them...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I broke the handle on the S3101 Shark Steme mop. How can I get parts?


Hi,Check the link for manuals...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Parts replacement We have a Hoover Steam Vac that has a broken part #10 in your picture or Part # 37271035. Does this part cover the whole top section of the Vac? Is it hard to replace? Where can you get the best prices on Hoover parts? I have been on Hoovers website and they don't even recognize this Steam Vac. which is hard to believe they don't even recognize their own unit? Thanks Ray


This the hood or top cover. There some screws on the bottom as well as on the top, then it comes off. ... Vacuums

I need the part that go's on to the steam handle for the other attchments to work. Let's see that's steam handle missing part then Other Attchments this is the only way I can name it, I hope you can understand what part I need. THANK'S


Hi,\015\012\015\012I have a better solution. Here is the parts diagram for the S3325. Please tell me which number relates to the part you need and I will find suppliers for you and the correct price. If your vacuum is not the S3325, pl ... Euro-Pro S3325 Handheld Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0704 seconds