Having problems with your Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum ?

It leaks the nozzle at the bottom jam and burnt around the hole ,can this grey part be replaced or toss the hole thing out


Answers :

\012
\012
\012

Hi,

Here\012is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it\012may not be getting steam to the head...

Euro-Pro\012Shark Steam Mop Problem

Here\012also is a link to get any of the
Shark\012Manuals\012that you need.

heatman101

;ll;,.

Repair Help & Product Troubleshooting for Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

It leaks the nozzle at the bottom jam and burnt around the hole ,can this grey part be replaced or toss the hole thing out


\012\012\012Hi,Here\012is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it\012may not be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Dear Sir or Madam, I own a black 23 x 47 x 7 mm Rowenta lighter. It has a screw on bottom that I cannot remove. What is it hiding ? Is this lighter refillable ? Is there a flint to replace ?. I've found on your site the following : "By jbbiii on Apr 06, 2009 Father died and left me a Rowenta lighter purchased in Stutgart in 1952. It has a screw on bottom with spring to replace the flint, but I cannot figure out how to open the bottom to replace the cotton wadding which I can see through the hole


Hello \015\012The flint should be near the striker.Or the thumb roller,usually below it.\015\012As old as it is you may not see it beacause its worn down.\015\012\015\012Maybe taking it to an antique store or a smoke shop woul ... Vacuums

Hoover Upright U8185-900 agitator brush stopped working...took hood off...PCB display bridge fried...ordered new one & installed...that burned up in 15 seconds...ordered another PCB and new agitator motor...and since I was in there every **** thing else replaced also...took whole thing apart and cleanded even tho agitator brush was not jammed...put all back together...**** thing just sits there with red led lights displayed...this is ridiculous


... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

Envirosteamer 300 leaking water. Older yellow model. I put water in it and as soon as it heats up, all the water leaks out the bottom, and it barely gets warm! It worked fine before. Could it be seals need replacing or something? Thanks!!


... Eureka Enviro Steamer 370 Upright Vacuum

We've plugged up open holes but the carpet cleaner still leaks from the bottom and we're not sure where the leak is coming from


Hello,What you need to do is to but the carpet cleaner on, and in that process you will turn it upside down, make sure there is no dirt inside.put your face close to the cleaner and try the fill the breeze of the hole, from th ... Eureka Atlantis 2591A Upright Steam Vacuum

My Bissell Quicksteamer Model 1960-R won't spray cleaning solution. I have cleaned it and taken apart the whole thing. I can't find any problems. The holes are not cloged where the water comes out as I disconnected it and blew through it to be sure. The lines show water trying to go through. It is as if it doesn't have enough power to pump the water out when I squeeze the trigger. I am thinking it is the pump thing but can't find a replacement part for it.


... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

Replacing filter Got a Filter Queen Majestic vacuum from my inlaws when they moved overseas. I am in middle of vacuuming, got a weird noise, so opted to check and clean the filter for first time. UGH. The lower 'pot' that's the bottom part of the thing was full of gunk, but the filter pristine clean against the cone that's attached to the upper part of the unit. In other words, I am shocked to see that the dirt goes not INTO the filter, but outside of it into the bottom portion (that I call the


Its normal operation so don't worry ... Filter Queen Majestic Canister Vacuum

Should I replace the vacuum hose or simply shorten it if a hole developed near the vacuum canister base? What are the disadvantages of this? For now I am doing duct tape, which is not so elegant as dust and things stick to the tape.


You can just shorten it as long as there is not a underlying power supply in the hose itself. after you shorten it use a "hose clamp" to hold the shorten hose in place. :) ... Kenmore 22822 Canister Vacuum

The bearing mounted gear/cutter assembly at the bottom of my 6 month old GE 169188 blender has gone bad; it's very loose and leaks fluid. The part is easily replaced. Only problem is that I can't find the part anywhere I've looked online. What is the deal? Why dont they make such a simple part available for a nearly new cheap appliance????


Cannot find that model number.. However.. Contact GE parts and service.. here.. https://www.geapplianceparts.com/GEApplia ... Vacuums

I have an older model F6056-900 Hoover steamvac Spin Scrub Cleaner. My first problem was that I loaned it out to a friend. Anyway she ran over the hose (used for attachments) with her car. I tried using the cleaner for carpet cleaning this morning but when I tried to put the solution tank into place...its loose...won't snap back in like it used to. When I can get it somewhat in place the solution just complete drains out through the bottom fo the tank. The leak is where the small hole on the bot


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Delonghi DSS50 steam floor cleaner water reservoir has a broken valve on the bottom where it fits into the steam unit. It leaks water rather than producing steam. I would like to find the valve and replace it or buy a new water reservoir with the valve in it. I cannot find the part I need. Can you help me?


... DeLonghi DSS50 Scopa Upright Steam Vacuum

Kirby shampooer my shampooer used to work great, but now it won't pump the bubbles. I've replaced the filter, and filled it to the top line with water, but no bubbles. the only thing I can think is that the gasket is leaking.


You are missing the wee round suds screen that fits over the small hole on the tank where the hose fits on. Without this screen it will not make foam.  ... Kirby Heritage II Vacuum

Sears progression kenmore canister va. Model 11623612300 on the wand, the plastic piece broke off, there is one long wand with two piece to it well the plastic piece, not on the bottom, where it hooks into the beater bar thing, but the other plastic in the middle. Can this be replaces?


Hi.The part is probably available as replacement.Please click here ... Kenmore Vacuums

Hoover steamvac when I use it it leaks out of bottom. when it off an water in tank leaks out of bottom,when its off an I pull the triggar it flows big time out of bottom. tank doesnt leak when off sitting with water in it


Let me start out with an apology. I did not ask my question very well - and you did not answer it as I needed.\015\012If you wish, we MAY be able to communicate in your native language. We can do most indian languages, Turkish, Ukranian and s ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Water leaking out from bottom of 7901


That part can go bad, but I have found more often the a water line came loose. Take out the 6 screw and the flow indictor cap, remove the top, then inspect that area. If you find what the problem is, fix it then when you put the top back on, make s ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Clean solution leaking out the bottom


If you don't put back the tie-wraps that secure the hoses, it will leak. ... Bissell 1400 Little Green Pro Canister Steam Vacuum

Sorry I have water Leaking from the bottom of the brushes on my vax carpet washer the model is W90-RU-P rapide ultra 2


... Vacuums

Not sucking from bottom into bag, but blows out the side filter,..yet it DOES **** FROM HOSE ATTACHMENT. How can this be?...the.belt is fine recently replace, the rollers clean..I can feel anything i


Here is a diagram ,it's probably the hose behind the brush bar thats blocked.http://www.vacsite.com/en/bissell-parts-1/bissell-parts/3522-powerf ... Bissell 3522 PowerForce Bagged Upright Vacuum

H2o steammop x5 ..water leaking at the bottom from a holefrom the tank


... H20 x 5 Mop

The rollers at the bottom of the sweeper have things stuck around them


You need to start with a pair of scissors and patience. Sit on the floor with the vacuum roller visible and accessible. Snip a string and pull it off. If the roller stops, cut string at that point. Try again. this is time consuming, but necessar ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Bissell spotbot: leaking the dirty water from bottom. I took the bottom plate off and there is a really crappy rubber seal. I think it is leaking from there.


I had the same issue. After some research, I determined I was missing a black "duckbill" gasket on the bottom of the dirty water collection tank.\015\012\015\012This caused reduced suction, and for the water to pool at the botom of the s ... Bissell SpotBot Robotic Wet/Dry Vacuum

Hoover steamvac F5826-900 leaks from bottom wheni put tank on ple


You may need to replace the gasket.if that dont work replace the whole tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a hayward 1HP superpump with an Ao Smith UST 1102 motor on it. Last year I had a leak in the pump, and I believe I got some water in the bearings of the motor. Over the winter I replaced all the seals in the pump, and have no leaks this year, but the pump is sounding pretty loud since opening the pool this year. I have (2) fold question: (1)I can not find any information on the where I can find a replacement bearing for this pump. (2) I can not find a procedure on HOW to go about


Hello. I get my parts here http://www.poolcenter.com/parts_pumps_hayward_superpump.htm\015\012\015\012Joe ... Vacuums

Leaking out of hole


That is the valve asm. to release the water when it is depressed when you squeeze the trigger. Best to replace it, usually it comes with a new seal, hard insert, spring and valve. Check under neath the seal to make sure that the tank is ok, if a h ... Vacuums

Rainbow Series E is leaking. Not sure if water is leaking from the water bin (doesn't appear to be cracked/broken). If not the bin, where else might water be leaking from and what are repair options? Have replaced belt on carpet attachment, cleaned the opening where hoses attach to the canister, etc


You need to clean the separator. ... Rainbow E series Canister Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0858 seconds