Having problems with your Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum ?

Where can i purchase the reinforced small bore plastic pipe that connects the boiler to the outlet on a Shark S3501?

Answers :

Repair Help & Product Troubleshooting for Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where can i purchase the reinforced small bore plastic pipe that connects the boiler to the outlet on a Shark S3501?

... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Shark steam mop,s3501,small plastic steam valve from the machine to head is broken,

Depend if the parts is plastic or metal. You can use gum for to fix it. If Not possible you must order the new ones. Specially if the parts is working hard. God bless you ... Vacuums

I have a Beam Rugmaster Plus power head Model BM1 393 Type AB and the connection were the metal pipe meets the plastic swivel broke close to the unit. It appears like a manufacture defect in that is broke in two small places and not the entire unit. Can this piece be replaced or glued??

This is most likely repairable. Lots of the Beam parts are available. I would recommend checking out any local vacuum shop or searching online for a central vacuum store that sells beam products. ... Beam Industries 750 Classic Bagless Central System Cyclonic Vacuum

I'm using Miele Medivac vacuum and I just sucked in a small plastic eye drop container by accident(I sometimes take off the brush part to **** in 'small enough' articles). And it is jammed in the part where the plastic hose connector bends. I think I can take it out if I can just disconnect the long necked plastic hose connector that connects the metal wand part and the hose part. Is it designed to be disconnected or should I not even try it?

I love the fact that the filter bleeped out s.u.c.k ha ha! ... Vacuums

I have the Hoover SteamVac Dual Model F7246-900 Serial AA12.0. In the Clean Water Tank the small black plastic check valve leaks water as machine is in use even when the on-off switch is not on. Can I purchase a new valve?

... Hoover Vacuums

Small blue piece of plastic is broken of a metal rod that appears to connect to the belt turning causing a ver loud noise. Is this the motor assembly and is it an easy fix or should it be taken in for repair?

Try to dismantle the motor assembly and remove the broken plastic that connect to the belt maybe it is the one create loud noise. ... Royal RY9750 Bagged Upright Vacuum

I have a Shark EP754C vacuum cleaner, the powerhead connector from the hose to thepowerhead (plastic) is broken. Is there any way to get a new powerhead or have this plasic connection fixed??

... Vacuums

Poor design Our Shark was bought in Dec. This morning my husband started it up and while doing the steps the handle snapped off at the plunger site.. It is sooooo poorly made that it was only attached by a small plastic weld. The design is definately flawed and for the cost of the machine it is disgusting. As far as we can see, there is no repair that can be done.

Hi,Your right on all counts...is it less then a year...check for warranty..Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a karcher 259m would you be able to tell me where i can purchase a part,its where you connect the garden hose to the unit, a clear hard plastic fitting with a right angle entering the bottom.thank you mark

... Vacuums

I have an electolux EL7001 canister vacuum. When I attach the large power nozzle....the one for the carpets not the small one for the floors...the nozzle is not powered unless I strap it on with duct tape. Is there some piece I can purchase that will secure the connection between the wand and the power nozzle head so that it is powered without the duct tape?thank you.

... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Leaking water from shark steamer S3501 - Shark S3501 Steam Pocket Floor Mop With 5 Cleaning Pads & 2 Quick R

... Shark S3501 Steam Pocket Floor Mop With 5 Cleaning Pads & 2 Quick R

Can't open plastic case of Shark Professional steam cleaner

Yes these are a pain....but if you use a box cutter (razor knife) you can open it right up. It's a must have around the house! ... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

Want to replace connection pipe part #KC92PBZTZV06 that goes into the cannister. Want to seperate it from adapter #4370325 without breaking it. I have the new connection pipe.

... Kenmore Vacuums

Electrical cord electric cord connection to cannister boby on filter queen is fixed by a plastic grommet or connection - how does this go into place without breaking or forcing plastic part?

It has a **** shell like closure on the inside and can normally be popped out by squeezing with pliers. It will have a slightly oval appearance, you must squeeze it round and pull. ... Filter Queen Majestic Canister Vacuum

Can the two inlet pipes be connected to one line? The central vacuum I have is probably from 1993/4. It has one exhaust pipe and two inlet pipes. It was initially under my stairs. I would like to move it and have in fact moved it to the garage but am now fitting the pipes. I would like to join the two pipes that were previously going to the two inlets into one pipe. Can I do it? Also would I then join the wires? Would I put a plate on the other inlet? THANKS. It is a SMART president's choice vac

There is no real reason why not...As long as you have enough "****" then that should be fine, you will need to "Y" join and NOT a "****" joint. ... Vacuums

Hooked everything up per directions. I plugged it in to the closest electrical outlet and nothing happened. The lights did not light up, the connected wall control and sensors leds do not light up. It appears the unit doesn't have power. The electrical outlet socket is fine as everything else I plug into it works fine. I have tried every other electrical outlet available. The unit won't power on from any outlet, and all of those outlets run other things, like power tools an refrigerators

Dear Davehibshman,Firstly; dismantle the plug and replace the fuse with the same rating as the one you have just taken out. Replace the plug cover, put the plug into the socket and try again. If this doesnt work, there may be a problem wi ... Vacuums

Rainbow shampooer The soap dispenser on my Rainbow is not dispensing soap when I flip the switch to 'soap' mode. All connections are intact. All plastic hoses are intact. What do you think is going on? The soap bottle connects to a little straw that appears to be free of obstruction, however, it connects into a sealed casing on the hose.

The little "wash/rinse" switch on some of the Aquamate units shuts off the soap flow by kinking the tube inside the housing. If you leave the switch in the rinse position (therefore, kinked) when you're done using it, it may dry in the kinked positi ... Rainbow E series Canister Wet/Dry Vacuum

I need technical spec's for the Shark Steam Mop. Boiler volume Time between boiler refills Steam temperature Steam pressure Steam dryness Boiler construction

... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a new Euro-Pro shark model S3101. Used it one time and while I was doing my tile floor in my kitchen I reached under a cabnet to clean and hit the floor kick kind of hard and broke the head off of the shark. I have only the T shaped end on the shark now with the cleaning head broken off and looks unrepairable. I did kind of hit the floor kick hard but the plastic broke like glass. Can I put a new head on the remaining piece or is it repairable? thanks Angie

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Pro ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I shipped my brother PE 770 embroidery machine purchased sept of 2010, to a lady who perchased it on ebay. Had used only once. Everything worked fine.I shipped in the original formed styrofoam box. I removed the embroidery arm, releasing the locking plastic hook holdind the machine and the arm together. When to lady removed the machine first in the original plastic shipping bag, two parts fell out. Her photo she emailed showed a black plastic piece with two holes or pivot points.also a silver me

This is a link to the manual for this machine. Do you see a picture in the manual of the parts you are describing? Reply with a part number and I will do my best to help. ... Vacuums

Kenmore Canister Vacuum Model 116.23912300 Hose Connection Pipe (KC92PBZTZV06)

To remove the cover. There are two tabs on the connection pipe that hold the hose connector onto the connection pipe, one on each side located on the section of the connection pipe just next to where it bends. They are visible under the lip of the co ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I just purchased a used bissell from a thrift store and i do not know how to use it or connect it to use it can you please tell me how to get machine connected right thank you?

If it is a 1672 wet dry vac, I need the end part that is connected to the hose and wand, the suction and spray part....you interested in parting it out or selling the whole thing? ... Bissell 1672 BIGgreen Wet/Dry Vacuum

I need a Dyson DC 17 Total Clean exploded parts diagream that shows the switch assembly. There are two small springs and a small plastic part that were loose inside the switch assembly. This caused the vacuum to shut off in the full upright position which is the position you use when using the wand.

I don't have a full diagram for you, but I do have a photo of how they are meant to be assembled: ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a Royal 7910 extractor and even though I vacuum before cleaning the carpet, by black cocker spaniel's hair gets pulled into the plastic pick-up attachment and I cannot find an easy way to clean it out. I have tried taking the screws out to separate the halves, but it seems as though they might be glues together. I have run water from a sink sprayer though the openings with some degree of success, but it still is pretty cruddy. I have tried snaking pipe smokers pipe cleaners up the pick

One person wrote this in a review:\015\012Most home carpet extractors are very difficult to take apart for cleaning and maintenance. The Royal 7910 is the exception. No tools are needed to take the front housing off to clean out all the pet hai ... Royal CE7910 Wet/Dry Vacuum

Need Charger for Shark: Charger # KA12D090015023U and Im sick and tired of looking for it. It shouldn't be this hard This shark was purchase by my mother who is 85 years old from HSN, she bought 2 one for a gift and one for her self. Somehow the charger got damaged and I cannot find one any where please assist me in finding this item. This Vacuum has been used one time. I hate to contact Home Shopping Network

Call 1-800-798-7398 the person I talked to was knowledgable. The cost of the charger KA12D090015023U is $14 including shipping and takes 2 days to deliver. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0561 seconds