Having problems with your Fantom Vacums FM741 Twister Bagless Upright Vacuum ?

Find a Hepa replacement filter for a Fantom FM741B Vacuum


Answers :

Repair Help & Product Troubleshooting for Fantom Vacums FM741 Twister Bagless Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Find a Hepa replacement filter for a Fantom FM741B Vacuum


... Fantom Vacums FM741 Twister Bagless Upright Vacuum

I need to replace the hepa filter on my Typhoon vacuum cleaner model T4505, however I cannot find a supplier of spare filters. Vacuum no longer picks up efficiently


... Typhoon Vacuums

Bad Motor I have purchased two of the Kenmore direct drive beltless systems with Progressive systems. The first died after a year, the vacuum motor start making a grinding noies. I pulled the side HEPA filter and could see a fine coating of graphite like dust. Took it to a vacuum repair shop. They said the brushes were going and thus the motor was shot. I liked the vacuum and bought a second, 1 year later the motor is making a slight noise that and removing the HEPA filter I find a slight metall


That dust is from the carbon brushes on the motor. You may need to check them, and also clean out the motor compartment. A slight noise could be a motor bearing starting to go. Does the smell like rubber or electrical. If rubber, then the belt h ... Vacuums

We have a Kenmore Grab-N-Go Upright Vacuum with a Hepa filter. We lost the yellow filter canister that goes in the top of the vacuum and need to replace it and the filter that goes in it. Is there somewhere we can purchase a replacement part?


... Kenmore 34722 Grab-N-Go Upright Vacuum

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK. Mine is so loud I can't use it very long-high pitch screech. Can this be fixed or does the whole vacuum need to be replaced? It still cleans gr


Sounds like a bad motor. Could be either foot motor or main motor either way cost will be more than half of the unit. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

I Have two questions concerning my AIRVAC AV2500 Red Series Vacuum System. How do you replace the light in the floor power head sweeper and can you replace the permanent fabric filter? We had the system installed in 2004 and the light in the sweeper head just went out and can not find any manual on line on how to replace it. The filter if not torn but avter 6 years it probably needs some kine of cleaning or replaced even though it says permanent. Any help would be appreciated. Jim McCluskey


... Vacuums

Hi, I have a sanyo SC164R/185R vacuum cleaner and just wanted to know if it has a HEPA filter? I can't find any info on this; the instruction manual just talks about cleaning the filter but doesn't specify what the filter is. I have a child that has just been diagnosed with a dust mite allergy and apparently a HEPA filter is what we need to help iliminate them.


... Sanyo Vacuums

Vacuum filter I bought a vacuum from Walmart that works really well, but I cannot find a replacement filter for it. The lable on the bottom of the vacuum reads "Excellent Solutions LTD" Model C 2006B also has 31CX E306773 numbers on it. 120V-60Hz 10Amps I have searched the internet but no luck so far....any suggestions?


We bought one a couple years ago too, no filters. Now, WalMart carries replacement filters for other vacuums that will fit. Go back to WalMart and pick up the Durabrand CF2006 - it's in an orange box, works like a champ, I think it was around $5. ... Vacuums

I just bought this vacuum at a second hand store. My girlfriend told me to grab it as it such a quailty product. How ever I can't find a model number or anything else. I need a manual please. Does it take bags? Do I need to replace the filter or just wash the one I have? It is black and silver, cannister. It also says big gary's vacuum system warehouse in surry British Columbia, Canada. It also says to use filter pow-r-nozzle 96. I have no idea of the year.


I suggest you google what you know. I dont think anyone here can suggest where you can get a manual for a machine you dont even know the name of.\015\012\015\012You ask about a bag ... I dont know ... is there one in it now? You ask abo ... Vacuums

Fantom Twister Our Fantom Twister is not picking up dirt. There does not seem to be any blockage in the hoses and I replaced the hepa filter and the second filter that sits just below the canister where the dirt is collected. It is still not working. Any suggestions yuo have will be appreciated. William Moran


When cleaning everything change the main filter which it's the filter inside the yellow mesh holder. the filter number is 1010fs. One filter is 26.90 with s&h. This needs changing every 2 years.\015\012call customer service number above. ... Fantom Vacums FM741 Twister Bagless Upright Vacuum

Where do i find a filter replacement for my Eureka vacuum


You can get your filters and spares of the link belowhttp://evacuumstore.com/s-1171-4700a-1.aspx ... Eureka 4700A Maxima Bagless Upright Vacuum

Hepa media filter replacement for vacuum


... Kenmore Vacuums

I have a Kenmore Elegance vacuum and need a part number for a replacement hepa filter. Vacuum model is 116 30306400C. Thanks.


... Vacuums

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK.


Sounds like a bad motor bearing. If it is, then you would have to replace it. Could be the brush roll, did you check the ends to make sure they turn easily? ... Vacuums

Noisy vacuum I have a eureka capture that I bought in april it's making a horrible high pitched squeal type noise, I have made sure my roller is clean, my filters are clean, i replaced my hepa filter and there are not any blockages I don't know what else the problem might be. Could you please offer other suggestions to fix this?


... Vacuums

I have a Bissell Lift-off Revolution Turbo vacuum and the brush doesn't spin on its own anymore. Does this mean the motor is busted because there's no noise when you press the brush button. We've just replaced the belt, hepa filter and a new brush. But its still the same. What's wrong with my vacuum?


Its probably the motor. remove the covers with a #2 phillips head screwdriver and cut the wires to the motor ( unplugged ). purchase some crimps at radio shack to resplice the wires together in the same fashion. ... Bissell Vacuums

I have cleaned the filters on my dust buster. The vacuum works for a minute then the battery seems to wear out and the power weakens until it stops. How do I replace the battery on this vacuum? Do I need just one 9.6V battery? What screws do I loosen to insert the battery? I can't find my instruction booklet. Tank you for your help.


... Black & Decker 15.6 Volt DustBuster Vacuum

Should the arrow point in towards vacuum or out on the replacement exhaust hepa filter for my kenmore prgressive 400 series vacuum?


I'm assuming the arrow you are referring to is on a new dust bag. If that's the case, the arrow should be pointing down toward the bottom of the machine.Jim Hart ... Kenmore 34613 Bagged Upright Vacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!


... Miele Vacuums

Do I need to replace the HEPA filter? - Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue


BISSELL User’s Guides can be downloaded at www.bissell.com\012On the front page under Customer Service click on User’s Guides and enter the model number of your unit.\012User Guide will be displayed as a PDF file. ... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

Hi, I have a oreck dual power sweeper vacuum DP460 and I am looking for replacement filter for it. Does anyone know where I can find one?


Have you tried this site click the link belowhttp://www.vacpartswarehouse.com/Oreck-DP460-Electric-Broom-s/2975.htm ... Oreck Dual Power Electric Floor Sweeper Bagless Upright Vacuum

Replacement filters for Durabrand Canister Vac with HEPA Model# DB9191


The Durabrand filter can be found at http://www.totalvac.com/accessory/parts/H19030.html ... Vacuums

I HAVE A DYSON DC07 I HAVE CHECKED ALL HOSES AND PLASTIC ATTACHMENT SECTIONS , CANNOT FIND ANY BLOCKAGE ANYWHERE IN THE SYSTEM .THE BELT IS GOOD AND THE BEATER BAR IS ROTATING WELL , BUT THIS VACUUM WILL NOT PICK UP ANY THING. I DID NOTICE THAT THE HEPA LIFETIME FILTER IS BLACK AND NOT SURE IF IT CAN BE WASHED OR CLEANED. THANKS BOB!


I have just cleaned mine just a half an hour ago - SAME PROBLEM !!\015\012ok take the dust cylinder off the vacuum cleaner and take the plastic clear cylinder off - there is a clear clip one side and you might need a small knife to unclip other ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Where can I find a belt for my Fantom Fury vacuum and how do I replace it?


You can get replacement belts and view the manual here:Fantom Fury Replacement Belts and Manual ... Vacuums

Where would I find replacement filters for my Shark Bagless Spectra, Model: EP708? I need both the hepa and the one in the dust bin. I can no longer tap clean it good enough, it is a mess.


Here is euro-pros number they carry parts for shark\015\0121-800-361-4639 or 1-519-842-8691 ... Euro-Pro S3325 Handheld Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0933 seconds