Having problems with your Fantom Vacums Lighting Canister Vacuum ?

My Fanom 12.0 has a high shrill to it. It pick up and I have cleared the hose, but still the noise level is unbearable


Answers :

It sounds like it could be the fan assy. I would ck. with a vacuum repair shop with free estimates. That should save you some time and some $$$$
Repair Help & Product Troubleshooting for Fantom Vacums Lighting Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Fanom 12.0 has a high shrill to it. It pick up and I have cleared the hose, but still the noise level is unbearable


It sounds like it could be the fan assy. I would ck. with a vacuum repair shop with free estimates. That should save you some time and some $$$$ ... Fantom Vacums Lighting Canister Vacuum

35922, sounds like there is a clog , have cleared hoses, put new bag in loss of suction, still hear loud clogged noise near rear vent hole


Try putting the vacuum hose end into vent hole while running. That may dislodge the clog. Otherwise, you will need to disassemble the machine far enough to get to the clog area. ... Vacuums

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK. Mine is so loud I can't use it very long-high pitch screech. Can this be fixed or does the whole vacuum need to be replaced? It still cleans gr


Sounds like a bad motor. Could be either foot motor or main motor either way cost will be more than half of the unit. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

My Dyson DC 14 is making the horrible "ratcheting"sound only when the brush is engaged on the carpet setting. I have cleaned the brush, so there are no obstructions, the canister is empty and properly on the unit. I checked to make sure all of the "traps" and hoses are clear of obstructions, the belt is on the brush securely and moves freely, the brush itself spins freely, but there is still the "ratcheting" noise. Any other suggestions?


Our DC33 was making the same ratcheting sound immediately upon placing the cleaner/brush head on the carpet. We carefully pulled the beater/brush bar out of the vacuum. Once removed, we pulled the black plastic end off of the center rod. We discovere ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I have a Model 116.35922500 Kenmore upright vacuum cleaner. It makes a loud air noise when using the vacuum. I have disconnected and removed the hose to see if anything is lodged in the hose and it appears clear. It makes the noise when the hose is connected. When I remove it, the noise stops. When I place my hand over the hose, the nose re appears. I sounds as though the noise is coming from the fan or internal parts of the machine. So, when there is a load or pull on the machine, it mak


... Kenmore Progressive 35922 Bagged Upright Vacuum

I have a DC07 and the brush wasn't rotating and I had no suction at the brush but perfect suction through the hose. I noticed a large build up of dog hair around the brush so I took off the cover plate and removed all the hair, cleaned inside the floor/brush housing and cleaned out the hose. I also cleaned the filter and removed the other air access cover and made sure that they were clear. I put everything back and the brush still doesn't turn and there is still no suction through the bottom


Hi and welcome to FixYa. I am Kelly. \015\012\015\012Here is a link that can assist you in your quest for the missing suction: \015\012\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

We have the GE sensor microwave WES1358DN1WW. It was made in 5/2009 & bought in July of 2010 brand new. it worked perfect til last week. i put something in it & it started to make a loud humming/vibrating noise. i assumed it was just something ontop of the microwaved & ignored it. 1 min later my food was still ice cold. we tried unplugging & plugging back in & made sure that it was clear of anything but it still makes noise & doesn't heat. GE charges $79 to look at it, & since the microwa


... Vacuums

Making high pitched squealing noise and motor is hot...cleaned out brush area and made sure hoses were free and clear too..noise is coming from the brushes because when I use just the wand, the noise disappears


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

MY HOOVER VACCUM MODEL #U5185-900 IS MAKING A LOUD VIBRATING NOISE AND I CANT FIX IT, IT STILL PICKS UP STUFF BUT THE NOISE IS UNBEARABLE. cAN YOU HELP ME


T could be 1 of 3 things:1. The belt that drives the beater bar. ... Vacuums

My Kenmore Progressive Direct Drive Beltless System Vaccum cleaner is making a loud noise by the filter and hose in the back of the vaccum and is not picking up. I have cleaned the hoses and the bottom of the vaccum where the agitator is located. Still it is not picking up dirt. What can i do?


... Vacuums

Where do you hook the clear hose that is in the compartment with the motor ? Second where the vacuum hose connects to the bag it keeps cutting in and out of power. I replaced the female cord to motor and still cuts out."no suction "


Would you care to tell us the make and model of the vacuum you're asking about? ... Vacuums

Screeching noise The vacum works fine on the bare floor setting but doesnt on the caprte setting i;ve cleared the enitre roller brush and its still making that awful noise?


Hello,When a Dyson DC07 makes this horrible grinding noise, it can only mean one of two things. The Dyson DC07 uprights use a clutch mechanism to control the brush spinning when you change the floor / carpet switch. When y ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Lg kompressor luv200r makes really loud whining noise and i cleared everything out and it still makes the noise. brush moves and there is some suction. Any ideas??


... Vacuums

My dyson has two gears as it were! One for normal suction and the other for deeper cleaning. There used to be a real difference in the performance between the two options, also the noise changed when you swithched from one to the other. This no longer occurs. I have taken it apart according to your instruction, cleaned all the various bits but still no luck. The cat fur is still clearly visible despite my best efforts. Can you please help!!!!


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Bissell 3920 motor is making a high pitched noise. I have cleared out pet hair from top to bottom. Cleaned the lower filter and replaced the upper filter. I Checked for blockage in the hoses and found none. The filter indicator goes green when I turn it on, but the straining motor noise persists.


Click on the link below to view the replacement motor and fan for your Bissell 3920 vacuum\015\012\015\012http://www.vacuums24x7.com/motorfan.html ... Bissell 3920 Bagless Upright Vacuum

My Dyson Animal is not picking up very well in the drive position. With the hose the pick up is still very good. I have had it for 2 yrs now with very little problems. I have cleaned out all areas etc pipes, the brush underneath and cant find any blockages. The noise of the dyson is the same as usual. Could you tell me if there is a part that it sounds like it needs?


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

What color is the air flow indicator supposed to be? Mine is yellow but I have no suction. I have read that some people have red, others yellow. I have cleared out all hoses and cleaned the filters with a shop vac, still cannot get it to pick up. Just keeps blowing the dirt out the back at me :(


Hi there, the unit may be experiencing something other than a blockage. Perhaps the dirt canister is not put back into place properly and the unit is sucking through there instead of through the hose.Check to see if the lid and the canist ... Hoover Elite Rewind Bagless Upright VacuumVacuum

Empty, new bag and still no suction, hose is clear


If the motor is running it probably means a blockage somewhere in the system.Turn off the machine and up plug it for safety.You could use a wire coat hanger (unbent) to gently probe the tubes for blockages.Check where the bag ... Vacuums

I have no suction for vacumming the floor. the wand is totally still working and sucking it heart out. clear hosing doesnt looked cracked. dont know where else to look.


Hi, if the wand is doing its job very well, you have to have a blockage some where, either in the hose where it attaches to the bottom of the unit near the roller section. It may be hard to see, but this is what is causing the bottom from not picking ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My dyson slim dc18 has suction in hose attachment but no suction in floor attachment. Tried to clear any obstruction by running clothes hanger in rectangular opening that empties into cannister and also tried to blow air through there also but still can not get suction


Hi its Darran at Dyson.It would be worth checking that the brush bar is turning when the machine is in the vacuuming position. If it is not turning, please press the re-set switch located on the cleanerhead. If this starts th ... Sharper Image Dyson Slim DC18 All Floors Vacuum

My Dyson keeps overheating and cutting out. I have cleared a twig from the hose and checked everywhere else but it is still cutting out after aboout 5 minutes or less of vacuuming. What's the problem?


... Dyson DC14 Full Gear Bagless Upright Cyclonic Vacuum

Dyson DC14 animal vacuum does not turn on however the roller brush does come on.The hose was clogged and that was cleared but vacuum still will not turn on.


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Vaccumn repair ...lostlosing suction, belt still turning roller bar, hose clear


To generate strong suction, the motor has to turn at a good speed.If its a bag vacuum change bag with new one when a great deal of debris builds up in the vacuum bag, the air faces greater resistance on its way out. ... Vacuums

My husband go the brush tangled in something. We cleared all of the obstructing string from the carpet fringe and the brush is moving freely but it still is making this awful noise when I try to use it like it did when it was tangled up. Is there anything I can do to fix it or do I need to find a repair person?


Probably your belt have a spot where i wored out when it got tangled up inspect the belt first ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0725 seconds