Having problems with your Filter Queen Majestic Canister Vacuum ?

How to reset a FILTERQUEEN majestic 360

\015 How to reset the unit after the red light lights up\015

Answers :

Repair Help & Product Troubleshooting for Filter Queen Majestic Canister Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to reset a FILTERQUEEN majestic 360

... Filter Queen Majestic Canister Vacuum

The beater assembly on our Majestic 360 is not working. We've pressed the reset button, checked the belt, made sure the connections were complete. Suction is reaching the unit. What's our next step? Thank you.

Check the power cord going to the unit with a volt/ohm meter. The wires break, UNPLUG and take plyers and slightly squeeze the female connections, and plug in again. ... Filter Queen Majestic Canister Vacuum

There is a break in the cord where the clamp is entering the unit of our Majestic IAQS system Filterqueen Lux have tried to get into it but cant seem to get it open! Any ideas?? This unit is approximately 5 years oldish!

Undo the side clamps so that you can get to the dirt below. Grab the handle and remove the top portion of the canister. Take the top portion and to go the table. Remove all the attachments (if they are even attached). twist an ... Filter Queen Majestic Canister Vacuum

My filterqueen majestic is 10yrs old and just started to spark and smell of burning ive took it apart

If you have a burning smell from the motor, your motor is shot. You should be able to buy anew AMTEK Lamb motor for about $85-110 US. Request a double ball bearing motor as it will have a longer life span. Also buy a fresh internal filter kit ... Filter Queen Majestic Canister Vacuum

My powerhead on my filterqueen majestic 360 is not working properly. the motor seems fine but when it touches carpet the m otor bogs down and sometimes stops. if you hold it up off of the carpet it runs just fine???

I don't know pandora charms ... Filter Queen Majestic Canister Vacuum

How do u replace dome filter on filterqueen - Filter Queen Majestic Canister Vacuum

Go here> http://www.filterqueen.com/pdf/majestic.pdf for the manual ... Filter Queen Majestic Canister Vacuum

I need to reset the lock on the samsonite 375 flite comfort and cant seem to do it. It has a red button at the back of the dials with 'on' 'off'. I've pulled it forward and followed instructions to reset it but still it won't reset. I'm not sure if that button has anything to do with resetting it actually???

... Vacuums

I have a Eureka Boss Model 411... I need to know where the reset button is for the suction motor. The canister was clogged on the backside, I didn't see it and the suction motor shut off. I have cleared the obstruction, but don't know where the reset is for that motor. I know how to reset the brush head motor.

If your vacuum motor overheats, it will stop working. it will start working again once it cools. ... Eureka 411A Upright Vacuum

After over heating the reset button did not reset after a cooling period.where is the reset switch /or fuse located? vacuum is a shark model UV208C

... Euro-Pro Shark Professional Upright Vacuum with Bonus StickVac Red Bagless Vacuum

Webpage error detailsrn User Agent: Mozilla/4.0 (compatible; MSIE 8.0; Windows NT 5.1; Trident/4.0; FDM; AskTbPLTV52/ Timestamp: Wed, 1 Jun 2011 21:06:26 UTC Message: HTML Parsing Error: Unable to modify the parent container element before the child element is closed (KB927917) Line: 0 Char: 0 Code: 0 URI: http://www.facebook.com/hoshmend.ali1

... Euro-Pro PT205 Leaf Blower Powerful 12 AMP Leaf Blower, provides 205MPH air speed, Detachable Vaccum... Vacuum

I have a hoover windtunnel platinum. I have changed the bag ( hepa Q bag) but the bag light wont reset. so the vaccum wont turn on. I have unpluged it and let it set for a while with the new bag in and repluged it in. I have checked the brushes and it is all clean but it will not reset. This only the second bag so it is a new machine I should not be having problems. Is there some sore of reset button I can hit.

... Hoover Company Wind Tunnel U53019 Upright Vacuum

I have a taco japanese slot machine how can i reset it with out the reset keys i hit jackpot and i cant reset it

... Vacuums

Changed the motor carbon brushes on my Beam central vacuum cleaner equiped with an IntelliWatch system. This system includes the Alutron DB100 module. This Alutron module needs to be reset so that the vacuum cleaner can operate properly. I believe that this module keeps log of running time and disables operation after a predetermined time. Can you help me with providing a reset procedure that will reset this module. Thanks

... Sunbeam Vacuums

Have a hoover windtunnel platinum. I have changed the bag ( hepa Q bag) but the bag light wont reset. so the vaccum wont turn on. I have unpluged it and let it set for a while with the new bag in and repluged it in. I have checked the brushes and it is all clean but it will not reset. This only the second bag so it is a new machine I should not be having problems. Is there some sore of reset button I can hit.

... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

Reset button The drive belt on my machine broke. They sent me a new one and I installed it, I think, correctly. It still won't engage and rotate the brushes. I can't find a reset button, but I suspect it needs to be reset. Where is the button? Theresa

Do the brush rolls turn ok? The brush roll motor may be bad.\015\012\015\012 ... Bissell 9400 ProHeat Upright Wet/Dry Vacuum

My Miele S748 will not run the overheat light and reset light on but can not find a reset button

... Miele Vacuums

Reset buton? HI was using the shampooer , the container got full, the vacum stopt before i could empty it and now it doesent turn back on, is the a reset button to hit

Hi painter1 and skkkfam, \015\012even not knowing what Rainbow models are you using, I know that in the newer versions there's a red buton in upper side that is "Restore". Other case is a security shaft that makes the machine available when we ... Rainbow E series Canister Wet/Dry Vacuum

My Dyson Ball rug attachment won't work - something had caught that I cleared, but the reset button does not reset the vacuum. This happened once before and I had to take it in. Is there another way to fix this simple problem?

... Dyson Vacuums

I have a DC14. About a wk ago it was making loud sound and bar stopped turning. i unclogged everything....now the suction works great. However, the bar still wont turn. The belt inside is still intact and isnt loose. Several solutions suggested resetting the "Red" button...i have searched the vacuum over and over. there is NO red or any other color reset button. The bar is set down perfectly in there, the cover plate is installed properly. What other problems could there be? Or do i just need to

... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My Oregon Scientific BAR888 has 5 windows, 1. temperature, 2. humidity, 3. mb/hPa or inHg (switch at the back), 4. bars showing pressure changes over 24 hours, and 5. time/date. Window 3 gives an option to set something between 0 and 2500. Oregon say they only have one set of instructions for the BAR888 but they do not match my instrument as there is nothing included for my window 3. Trouble is I don't know what the 0 to 2500 relates to and therefore don't know what to set it at.(My model does n

... Vacuums

How do I reset the brush it won't turn on My DC 14 got jammed with carpet stings and now the brush will not turn on, how do I reset it.

You cant reset the roller on the dc14... you most likey have snapped the belt that runs the roller.\015\012DO you have the clutch version? ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Have a Bissell proheat steamer. Will not heat up. Is there a reset for for heat switch. I beleive just needs reset. The switch, the way that it feels gives me this indication. Switch will not engage and stay switched to on position. J.J.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Deep Cleaner Upright Vacuum

Problems with Kenmore Whispertone model 118 Bagged Canister Vacuum Overload Protection Reset won't reset

... Kenmore Whispertone 23312 Bagged Canister Vacuum

I have a Miele S5980 vacuum cleaner, and recently had to change the Hepa filter. After doing the change, I tried resetting the reset button to switch off the Hepa filter indication light and it would not switch off. After a few tries, I accidentally depressed the switch, and it has dislodged from its cradle. Help, what can I do to fix this?

... Miele Vacuums

It shut off ,the water got real foamy and it shut off . will it reset. Do I need to reset it.

It should reset, try not using a sol that has a foaming agent in it. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0261 seconds