Having problems with your GE 1983 Chevrolet G10 Instrument Cluster Bulb ?

The speedometer says that you are going 40 when you are only going 30

Answers :

Get the proper sized wheels and tires for your rig... or take it in and have the speedometer adjusted.
Repair Help & Product Troubleshooting for GE 1983 Chevrolet G10 Instrument Cluster Bulb

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The speedometer says that you are going 40 when you are only going 30

Get the proper sized wheels and tires for your rig... or take it in and have the speedometer adjusted. ... GE 1983 Chevrolet G10 Instrument Cluster Bulb

Shampoo-er This seems to be a common problem, the shampooer is putting out alot of water and hardly any suds. I read through the posts about the little filter that sometimes gets out of place and I think I found it in the box - is it about 1" diameter hard plastic ring around very fine mesh? If so where exactly does it go? Some posts say in the hose, and others say in the opening of the tank. Or does it go in the place where the hose attaches to the tray? I also found a round sponge in the box o

It goes on the small hole on the tank where the hose attaches to it. The sponge goes in the hole directly under the on/off valve. Here is a link to my online shampooer instructions.\015\012 \015\012 ... Kirby Ultimate G Bagged Upright Vacuum

Roomba turns in circles going one direction and then another but can not go forward in a straight line. Aftter a few moments of going in circles, it cuts off and says inspect and clean roomba's wheels. We have done that 5 times and to no avail.

... iRobot Roomba 530 Robotic Vacuum

Error 5 will not charge says error5 charged it for 24hourswith 3 seperate baterrys green light to say its charged but wont go ive cleaned it to death but no joy help alan

Try this linkhttp://uksupport.irobot.com/app/answers/detail/a_id/883/related/1/?cc=uk ... iRobot Roomba 560 Robotic Vacuum

********** about the shop vac L250. Really chaps my --- when it's stupid filter design fills my house with dust because it wont say in place! BIG problem. I'm sure you're going to say it's operator error instead of an engineer flaw!

There is supposed to be a foam sleeve, a paper dry filter and a rubber band mounting ring. It truly is a crappy design. try replacing that foam sleeve ... Vacuums

The light on Sunbeam Accura Digital Iron is flashing red instead of going from orange to green when switched on and reaching temperature. There is nothing in the manual to say what the problem is.

... Sunbeam Vacuums

The ac unit says E2 and keeps going on and off

... Vacuums

Troubleshooting My says to clean brushes but they are clean. Whats going on?

... iRobot Roomba 550 Vacuum

I have what I thought to be a Kirby Classic Omega that is in excellent running condition and looks great. I love it and have been using it for years, but it is recently going through an identity crises! I looked on the identification plate under the motor while cleaning it and discovered that the ID sticker says it's a Kirby Classic III. How can this be when every part of my dear kirby is Omega brown? There is not a hint of Red or Rosewood! Is there another way to determine the actual model b

The Kirby Omega was made from 1973 to 1976.The classic III 1976 to 1979When in for repair the case (motor cover) from a Classic could be put on the Omega. This happens in repair shops if the teck. has two apart at the same time and was no ... Vacuums

My Bernina 807 set on min. speed takes off fast, doesn't go slow at all, although there is a difference in the slow speed setting and high speed setting if I switch from one to the other while stitching. The machine is well oiled and goes well apart from this. I would like min. speed to start smoothly and slowly. I have read it could be capacitor in foot, but DH says it does not look burnt out. Would it help my problem to remove it? thank you, Barbara

... Vacuums

The power head of my DC 21 keeps cutting off as soon as I start moving the hose around. The only way to get it going again is to step on the main switch on the canister, then the whole cycle of off and on starts again. I have replaced the entire power head and tested the continuity of all the wires in the hose and they are good. The repair shop says the PCB is bad but can not get one. What can I do ?

Not much. my only suggestion is to dig through the internet and try and find that pcb it may take awhile but it would be worth a shot. if you dont think you can make the repair take it to repair shop with new pcb and let them do it. ... Dyson Genuine DC-21 "Stowaway" Spare HEPA Filter, Dyson

Power nozzle of my S3670 does not work (vacuum itself does work), the headlight bulb in the nozzle is broken. This happened in the past several times - we would bring the vacuum to service center - I don't know what they did other than replacing the bulb. I decided to go to ACE and buy replacement bulb myself, replaced the one in the nozzle - this did not fix the problem. I don't see any fuzes or anything in the nozzle. However, the manuals says to "Use only HOOVER part no. 27317307, which is a

... Hoover S3670 Bagged Canister Vacuum

I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test

If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $3 ... Ryobi P113 18 Volt One Charger 140501001

Dirt keeps coming out the back of the vac. I have a D:ayton 1D457D wet/dry vac. I have aring that says to use on dry applications only. Where does that ring go?

The ring goes over the filter insid the vac where the filter is.take the filter out and cleanit real good then put it back on.now the ring goes over the filter and get pushed all the way to the top and pressed on to hold the filter in place ... Vacuums

My Irobot Roomba keeps saying that I need to clean Roombas brushes. I have cleaned the brushes...they are spotless. Still the Roomba will go for 2 minutes and shut itself off stating once again to clean the brushes. What up?

Perform the troubleshooting found at the iRobot website: http://tinyurl.com/nh5c8a (I promise that really does go to the right site.) That troubleshooting will enable you to determine exac ... iRobot Roomba 510 Bagless Vacuum

Our Whirlpool microwave is 5 mo. old - it is W10182518A --- we tried to change the time because of daylight savings time going off and the clock will not hold the new time - PRESS comes up - and then different time show up - I have the manual and am doing just what it says.

... Vacuums

My 400 series Discovery Roomba will no longer charge. It shows a green "charged" light, but when I hit clean, all lights/vacuum, etc just go out and it stops. Irobot says that the entire unit needs to be replaced, but it has to have something to do with the charging mechanism. Any Ideas? I've tried the system reset, and removing/replacing the battery. No effect. The robot doesn't give me the "uh-oh" beeps to be charged. It just stops and goes dead.

... Roomba Robotic Floor Bagless Vacuum

I have a Bissell Proheat steamer carpet cleaner. There is a red L shaped part that says hips on it that I do not know where it goes. It also does not have any suction. Is the part the cause of the loss of suction and where does it go?

Http://thefuntimesguide.com/images/blogs/bissell_water_container.jpg ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I am trying to find a replacement water tank cap for a Vicks V4450 humidifier. I dropped the cap and broke it on the edge. Everything I see on line does not say it will fit the V4450. My e-mail address is [email protected] My name is Andy. I would like the part number to order and price and web site to go to for the ordering process. thank you Andy

Http://pg.custhelp.com/app/ask This is a link for Vicks online help section. I'd shoot them an email and simply ask if they can send or sell you a new one. Have the model n ... Vacuums

My Dyson DC44 is charging on the wall mount, and when I go to use it it wont run:( it has worked because its basically new. when i pull red trigger a green light comes on where it says max and on top.

... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Help my new roomba 4100 was fully charged and I'll start it up and 5 min. into vacuuming it shuts off and the red battery light comes on saying it's not charged whats going on?

Same thing happened to me, I called the company, and they told me to remove the battery, press the on button for 5 seconds, which clears the system, replace the battery and do a long charge 12 hours. I'm in the process of doing that now. ... iRobot Roomba Red 4100 Bagless Robotic Vacuum

I just got a coralife SPL-165R-JS replacement ballast for my saltwater aquarium but not sure how to hook up the output pins to the wires that go to the bulb. It says pin 1&2 - fila1 and pin 3&4 - fila2, what the heck does that mean? I can't find any wiring diagrams anywhere.

... Vacuums

Keeps stopping. My Roomba Discovery says it has a full charge, but it runs for a few minutes, then stops and beeps and the status light comes on. If you press the clean button, it will start again and go for a few minutes before the same thing happens again.

Your battery isn't holding a charge ,buy a new battery ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Roomba keeps saying clean brushes yet are clean!

Make sure you take off the little cap at the end (the one that spins -- just grab it and pull it straight off) and clean under it too. The rest of the brush may look perfectly clean but what happens is that hair gets stuck under spinning cap and, li ... iRobot Roomba 530 Robotic Vacuum

Little yello steamer not heating up yellow light not going on

... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.5218 seconds