Having problems with your Genie Company Vacuums ?

I need a hose for a sv2000 - Genie Company Vacuums


Answers :

Repair Help & Product Troubleshooting for Genie Company Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need a hose for a sv2000 - Genie Company Vacuums


... Genie Company Vacuums

Need on/off switch for genie wet/dry vac - Genie Company GV150 Wet/Dry Vacuum


... Genie Company GV150 Wet/Dry Vacuum

Need filter for genie 300pc wet dry vac - Genie Company Vacuums


... Genie Company Vacuums

Genie company vacuum 125PH - Genie Company Vacuums


... Genie Company Vacuums

Hi. Bought a M3888-3 Royalcylinder vacuum from Lidl. Lost manual that came with it. Only had it 4 mths. Need new hose. Plastic hose has snapped near whereit attaches to metal hose. Can I get a replacement hose from somewhere in U.K.? I know the vacuum is from Germany.


... Royal Vacuums

I have an older EVO canister vacuum model 116. 22822200. This has a hose between the canister and the floor sweeper. Switches are on the hose. The hose needs replacing. Can you give me a price and part number for this hose? Can I order it at a store or on-line? Thanks, Alan.


... Kenmore EVO All Surface Floor Cleaner Vacuum

The hose is disconnected, new bag in unit, new filter, unit runs when hose is detached but immediately turns off when hose is attached but hose has no obstruction, etc.. i was told i need some sort of valve. HELP! I have birds, a cat and 2 large dogs and no vacuum :)


There is a vacuum hose that attaches inside the unit to a round clear plactic piece. In most cases you can simply cut the small vacuum hose and it will fix the problem. ... Electrolux Epic 3500 Vacuum

OUR DYSON 07 SWEEPER HAS VERY LITTLE Vacuum, have cleaned all filters and hoses, on line troubleshooting has said to check soleplate being on correctly, we have done this, still does not have good vacuum, belts are covered by a housing, the video that shows the changing of the belt is not the same, I need to know how to remove the cover to check both belts and any help in gaining the vacuum


This video shows you everything you need to know ... Vacuums

DT 1300 As I am vacuuming the motor seems to fade in and out and sometimes stops running for a few seconds and then resumes. If I move the hose a bit near the vacuum end, it runs smoothly again. Does this sounds as if there might be a short in the motor? Would this be something I can fix myself or does the vacuum need to go in for repairs.


... Oreck DutchTech DTX1300C with Motorized Carpet Brush Bagged Canister Vacuum

I have an electrolux central vacuum in my house. My central vac hose has something stuck in it, I think, maybe a sock. I tried to put a long dryer wand down it but the hose is just too long. Does this need a repair man or new hose?? Any idea of a way to blow it out? Thanks.


The best way to clear an obstruction is to blow it out by attaching the wall end to the exhaust of a shop vacuum, or using an air compressor.\015\012You can try holding the wand end of the hose directly to the CV in port and turning the machine ... Electrolux Central Vacuum

I need to replace the hose on my Euro Pro Shark canister vacuum EP722. After numerous searches, unable to find online. Looking for simular hose that will attachment to canister. What hose from another model or even maker will work? Thanks


Go to shark in GOGGLE. Go sharks wedsite, find your vaccum, click your hose. We have 3 mops and vacuum. No trouble getting parts and filters. Not high priced. ... Euro-Pro EP722 Canister Vacuum

I need to replace vacuum hose


If you have a vise, put the end in to and you want to just squeeze it so you can get to the 2 tabs inside and using 2 flat blade screwdrivers, pry outward and the hose should come out of the cuff. Sometimes you can just cut and rewire, but watch and ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Need everstar replacement hose for garage vacuum


... Vacuums

Have the Innovage auto series wet & dry auto vacuum & need hose


... Vacuums

I have lost the manual and forget how to use the hose part of vacuum, also the handle turns and is not secure ( that is the handle in the upright position). It is a bagless Stick Shark Vac. I need to know how to attach the hose to the vac so I can clean furniture and corners.


... Euro-Pro V1828 Shark Stick Vac Bagless Vacuum

I have a Genie home wet/dry shop vacuum model 300PCA, 7.5 amp,rn1.1 HP. Electirc motor bearings are worn and in need of replacement motor. Unable to locate any Genie web sites Any assistance will be deeply appreciated, Thanks. [email protected]


... Vacuums

Need a replacement hose for a wet/dry Coleman Vacuum Where can I purchase the hose?


... Coleman Vacuums

No suction The vacuum doesn't pick up anything with the vacuum or the hose. The filter says it doesn't need to be replaced. What is the problem?


Fiflters should be replaced at least once a year, they go bad. You could also have a clog in the hose, or the dirt inlet by the brush roll may be clogged. Take the hose off if you can, drop something down it and see if it comes out the other end, i ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

Need a hose for shark ep 238 canister vacuum - Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum


... Euro-Pro HEPA Shark EP238 Bagged Canister Vacuum

Do i need a special hose to vacuum up water? - Rainbow E series Canister Wet/Dry Vacuum


Yes. You need a non-corded hose so there is no power running through it when vacuuming up liquids. ... Rainbow E series Canister Wet/Dry Vacuum

Bissell lift off vacuum about 4yrs old. Extremely noisy. OK until before Christmas but getting worse every time it's used. Washable filters washed, HEPA filter replaced. brush bar cleaned of every scrap, hose empty,everything that can be cleared has been. Noise high pitched, screeching and can only bear to use it for a few seconds at a time. Suction OK. Mine is so loud I can't use it very long-high pitch screech. Can this be fixed or does the whole vacuum need to be replaced? It still cleans gr


Sounds like a bad motor. Could be either foot motor or main motor either way cost will be more than half of the unit. ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

My Miele s558 Silver moon vacuum just stops suddenly while vacuuming. I can start it again using the button on the handle of the hose. It is erratic, doesn't SEEM to be due to overheating. I read online that this may mean it need a new starter switch. What do you think?


This is caused by a circuit board problem in the hose. Unfortunately, the only way to fix this problem is to purchase a new SES 125-3 hose. The good news is that the new production hoses have rectified this problem and you will not experience it agai ... Miele Vacuums

No I did not my hose on the dirt devil does not have much suction on it I took everything apart and found nothing wrong no clogs anywhere but when I add an attachment to the hose it loses all suction...I looked for a switch to change from regular vacuuming to attachment found nothing why is this??????? Need a manual where can I find some information and a download on line manual??????


Try this. There should be a little filter unerneath the tank. just clean that filter or replace it. (9 times 10) thats the problem.\015\012\015\012good luck. ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

My mother purchased a replacement hose assembly for a Bissell ProHeat 2X and the part was shipped without any instructions... While I am pretty handy, my issue is with the supply tube, and I cant figure out how to accomplish the replacement, and as its not MY vacuum, Im hesitant to start taking things apart.I just need instructions to replace the entire hose assembly.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Need A manual for U5025-900 Hoover Sprint vacuum want to check if the filters are correct. Was given the vacuum, seems like there is very little suction for the hose. Any help would be appreciated


Wasn't able to locate a manual, but you may be able to get the info you need from this page:\015\012\015\012U5025900 Parts ... Hoover U5025-900 Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1420 seconds