Having problems with your Hayward Pool Products Hayward Super Pump 1.5 HP SINGLE Speed W/ DE4820 48 Sq. Ft. DE Filter ?

Too Much DE added to Pool Filter

\015 I think the Pool Technician Added too much DE material to the pool filter. I had DE in the pool after he left. My Filter pressure is high. What's wrong and how do I fix it?\015

Answers :

Repair Help & Product Troubleshooting for Hayward Pool Products Hayward Super Pump 1.5 HP SINGLE Speed W/ DE4820 48 Sq. Ft. DE Filter

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Z345 Electrolux cylinder vacuum cleaner, from the 1970s probably, but not used much. I have lost the guide. I forgot to change the bag before it was full. Smoke started to come out - smelling of burnt paper, not rubber. So switched off. It did not blow the fuse, and may be OK. I wish to inspect it. How do I open it up? Alos I have an air filter and a motor filter for it. I have often changed the air filter on the top. How do I get at the motor filter, if there is one? Than


Good day! OK you have to is replaced the bag and that's it.And don't forget to change the bag again to avoid that problem.Thank you ... Electrolux Guardian Bagged Canister Vacuum

I have a sta rite (pentair) cristal high rate sand filter model T-200-BP-1....its leaking water thru the top of the valve, where the valve cover screws on the valve body assembly. it leaks water out where they go together around the screws. Also when i vacuum it, everything that i vacuum gets washed back in the pool when its on the filter position. Also the backwash leaks when its turned 2 the filter position, does it supposed to do that?...the only way i have gotten it to stop is to put a seper


... Vacuums

Hoover Windtunnel T-Series UH20700 9 mos old. Keeps clogging in hose just above the beater brush assembly. I think it clogs because the suction is too weak to pull much through. Primary filter is clean and HEPA filter is replaced. Even when everything is unclogged, suction is weak compared to another unit (same model) that a friend has. Any ideas?


... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner

I have a shark transformer Vac EP602RF. I want to know how much the filters cost. My daughter threw the non-woen pre-filter away thinking I had replacement ones.


... Vacuums

Can't get much suction out of hose. checked one filter at the bottom of sweeper, are there any more filters tocheck?


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

The pre filter of my dc-17 get dirty and clogs up during every vacuuming. Why is so much dirt getting through to to filter


Hi, it's Jack at Dyson.If an unusually high amount of debris seems to getting through to the prefilter, this could indicate an issue with the cyclone pack. So we can help confirm if this is the case, please email us at [email protected] wi ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Vacuum does not have as much power and is getting hot and shutting down after only ten minuets of use. does the filter need to be changed along with the bags to provide the best results, if so how often does the filter need to be changed?


... Miele s558 Silver Moon Vacuum

I have an Alba Vacuum Cleaner model AVC1502(Bagless cyclonic cylinder 1500w) I am in desperate need of a filter cover. As I have severe arthritis this vac cleaner only weighs 5.1kg(not able to lift much weight) please I need help tracking down the filter cover, perhaps a later model may have the same cover, need all experts assistance thanking you sincerely for any help that can be offered. In anticipation Dee


Www.searspartsdirect.com ... Vacuums

I have an Alba Vacuum Cleaner model AVC1502(Bagless cyclonic cylinder 1500w) I am in desperate need of a filter cover. As I have severe arthritis this vac cleaner only weighs 5.1kg(not able to lift much weight) please I need help tracking down the filter cover, perhaps a later model may have the same cover, need all experts assistance thanking you sincerely for any help that can be offered. In anticipation Dee


... Alba Vacuums

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!


... Miele Vacuums

I have the Electrolux Velocity Pet Lover 1800w which has lost all suction from the pipe. I have checked for blockages and cleaned the filter but still no joy. Would changing the HEPA filter resolve the problem? Your help is much appreciated


... Vacuums

I have had my Bissell 6591-X for 2 years. I hate it! No matter what I do all the fuzz, hair, whatever fills up around the upper filter before it even starts to deposit in the cup. It has done this ever since I bought it. No matter how much I take it apart, clean it, clean filters, empty the cup, nothing does any good. I spill more dirt onto the vacuum and floor than ever gets in the cup. I will never buy another Bissell.


Sure your not over filling it ? ... Bissell Vacuums

Vacuum cleaner hi.this is 10 yrs old and not overly worked.bags are changed regularly and the micro filter has been changed at least three times over ten years.it goes well for about 2o minutes then loses power with not much "suck"after that.sometimes shutting down completely,because of overheating i presume,or just carries on at a much lower'"suck".have tied shaking bag inside but no luck.any suggestions out there or can you tell me the agents support office for new zealand[auckland].many thank


What brand vacuum is it? ... Vacuums

KARCHEN 5500 My vaccum has 6 years old and the problem is that it does not work properly (wet vaccuming process). From the model overview I need Carpet turbo nozzle and the water filter. My email is [email protected] Thank you very much Patricia Perdomo 786-2620411


... Karcher K DS 5500 Vacuum

I do not have my users manual and have never vacuumed wet with this vacuum. How do I change it from a dry to wet vacuum. Can't find my manual and I need to use the shop vac for water in basement, do I have to change the filter or what lost my user manual never used it to pick up water. need to know how to puit it in wet mode i want to clean the dirty water out of my pool.


\015\012Vacuuming Liquids\015\0121. When picking up small amounts of liquid\015\012the filter may be left in place.\015\0122. When picking up large amounts of liquid\015\012we recommend that the filter be\015\012r ... Craftsman 17765 Canister Wet/Dry Vacuum

Kenmore upright vac model 33922 - good suction but developed loud whining noise after accidentally vacuuming room without bag. Added bag and changed both filters. Still makes noise. How can I stop noise?


The bag is the first stage in your filtration. Most times what you did will draw fine dust right through the filters and into the motor itself, affecting the bearings and clogging the motor fans, throwing them off balance. The fact that there i ... Kenmore 33922 Direct Drive Bagged Upright Vacuum

My Dyson DC14 ANimal vacum cleaner has lost a lot of its suction, i have cleaned the regular filter but this does not seem to have improved it much. JAmie


Hi its Darran at Dyson.A loss of suction is most likely caused by a blockage or a dirty filter. If you have cleaned the filter, it would be worth checking the machine through for a blockage by following the user guide or the diagnostics i ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

While vacuuming, the unit will stop/shut down. A short time later the unit will operate again but not for much longer. All filters are clean/new.


Check your hose for a clog. It's likely there is a plug somehwere. Run it (not while vacuming the carpet) with all three filters removed. See if you get good suction. If not then look around for a plug of dirt and hair somewhere. ... Bissell 3750 Lift Off Bagless Upright Vacuum

Bad smell no matter how much i clean the filter my vac smells like a dirty gym locker


You may have hovered up some thing wet in the past if so it will always smell like this as the dampness has gpt through to the motor and filters ... Dirt Devil M084000 RoomMate Upright Vacuum

My Bissell PowerForce 3522-1 wont **** in air anymore. But the side filter is blowing out air with much force


... Bissell Vacuums

I vacummed some sheetrock duct up with my hoover elite cyclonic.. i dumped the canister to empty the dirt and dust, but now theres not as much suction... is there any other area I should be cleaning... or can i submerse the plastic filter part in water?


Do not put the filter in water, it will ruin it. if banging out the filter did not work than you should probably replace it, sheet rock dust is very fine and will easily clog most filters. ... Vacuums

When I vacum the pool which position of the pomp need to be:filter? waiste,or backwash?


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=561980\015\012Generic problem for all Vacuums\015\012When I vacuum the pool\015\012Posted by lovepuppies3 ... Vacuums

Brush spins, I have washed the filter, but do not have much suction.


How about doing this for the filter housing:\015\012\015\012http://www.fixya.com/support/t2936439-dyson_suffers_from_lack_suction ... Sharper Image Dyson Slim DC18 All Floors Vacuum

White & grey model Roomba is moving much slower on carpet since I replaced battery and filter, but moves normal speed on linolium. How do I fix this?


You need to adjust the "Brush Height String" The new battery is a bit heavier than the old ( by 10 ounces if you got the new battery) dis assemble the roomba and you will see a string attached to a screw which allows the brushes to rise and fall with ... Roomba Robotic Floor Bagless Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0385 seconds