Having problems with your Hoover Commercial C1403 Bagged Upright Vacuum ?

Where do I find the bags for this old c1403 one?

\015 Where do I find the bags for this old c1403 commercial upright one? I tried type A bags as advised but get clouds of dust going everywhere except the bag. They don't seem to fit properly.\015

Answers :

Were these generic bags or Hoove brand? Also, I believe that some bags have a rubber seal on the inside of the hole to attach. I hope this helps. Type A is the correct one.
Repair Help & Product Troubleshooting for Hoover Commercial C1403 Bagged Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where do I find the bags for this old c1403 one?

Were these generic bags or Hoove brand? Also, I believe that some bags have a rubber seal on the inside of the hole to attach. I hope this helps. Type A is the correct one. ... Hoover Commercial C1403 Bagged Upright Vacuum

Morphy Richards Pets vacuum cleaner, less than one year old. Not sucking, overheating, claims bag is full when it is new. I have looked for blockages but the hose is clear. Can't find anywhere in Aberdeen to repair it

Discovered I had a 3 year warranty on it so got a replacement. Thanks for your helpful advice! ;) ... Morphy Richards Vacuums

Need Charger for Shark: Charger # KA12D090015023U and Im sick and tired of looking for it. It shouldn't be this hard This shark was purchase by my mother who is 85 years old from HSN, she bought 2 one for a gift and one for her self. Somehow the charger got damaged and I cannot find one any where please assist me in finding this item. This Vacuum has been used one time. I hate to contact Home Shopping Network

Call 1-800-798-7398 the person I talked to was knowledgable. The cost of the charger KA12D090015023U is $14 including shipping and takes 2 days to deliver. ... Vacuums

Last year my wife and I bought a new Dirt Devil Reaction All Surface vaccuum cleaner to replace the older Platinum Force. After using it a couple of times the new one gets clogged with dog hair easily and shuts down. I cleaned it out completely including the hepa filter but it will not handle the dog hair. The old one never had a problem and still works. We went back to using the old vaccuum cleaner because we can not find the receipt and had not registered the new one and are stuck with a new 1

Greetings jettin_us,\015\012\015\012Normally you can contact the store you purchased the unit at, and if you paid with anything other than cash, they may be able to retrieve your receipt for you. \015\012\015\012Once you get t ... Vacuums

Can't find the replacement filter bag for the SV300Q the numbers on the bag are 3999 and 3605...looked everywhere and no one carries the bags.

... Genie Company GV150 Wet/Dry Vacuum

I own a old Bissell Big Green Cleaning Machine and am looking to replace the inline fluid/vaccum pump. The pump has an Eaton logo and is model CP7. I have not been able to find a replacement at your site. Could you tell me if one is still available or where I might find a replacement?

I just saw one on USAVacuum.com It's about $29 ... Vacuums

I heard that a class action lawsuit against Oreck Vacuum is being started because of all the problems customers are having with their vacuums. Does anyone know about this? My Oreck is only a couple of years old and keeps burning up belts. I took it in after only one week of usage when I started to notice white smoke coming out of it and the smell of burning rubber. I feel like I got the old run-around, when the service tech told me he couldn't find anything wrong (but replaced the burned up belt

You are correct about the fact that legal action has been taken. Go to this link to read more\015\012\015\012 ... Oreck XL2200 Bagged Upright Vacuum

I need to replace the brushbaron my DC17 Animal model Dyson. It's almost four years old. I can't find the correct part number on the Dyson Website and I can't seem to find a Dyson repair center in Albuquerque, NM. What are my alternatives? If I can't service this machine without returning it to Dyson, I won't ever buy another one.

Hi,\015\012\015\012The original Dyson part number for the brush bar (often called brush roll) is: 911961-01\015\012\015\012If you type the above part number into Google Products (click link below) you will get a list of suppli ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

How to change bag of Hoover Elite 200 Vacuum Cleaner? Do I need a new bag to replace to old one?

... Vacuums

My Necchi supernova ultra mark 2 (50 year old) sewing machine's belt broke (13 inch length). I'm having trouble finding one on-line. Any idea where to get one?

I have the same machine and I see the belt has been replaced. It's a Singer belt. You might wanna try that. ... Vacuums

On off switch stopped working 3rd one to do so this one cannot be returned to old ? model QPV10.5b nothing on shop vac site and nothing comes up on Digi-key site really do not want to buy 150.00 vac again but cannot find on off switch! thanks for your help

Use a higher amp rated switch. If this is not available, then solder and insulate the wires where switch should be, then install an aftermarket in-line switch. ... Vacuums

We have a Kenmore Progressive Model 116 Upright bagged vacuum with Hepa filter. It's at least a couple years old. For quite some time now when ever we use the vacuum the vacuum motor will shut off nafter about 5 min. of use. We then need to let it sit for awhile and then we can run it again for another 5 min. The bag has been change. Any one have any ideas how to fix this?

I suspect that you have a restriction. The motor sounds like the thermal break is stopping the motor before damage, due to heat.\012You must witness that the entire suction and discharge side are clear. This is not always very easy, but necessa ... Kenmore 34612 Bagged Upright Vacuum

I work in the Pittsburgh Public Theatre costume shop. We have an old Rimoldi industrial serger withiut an instruction manual and can't seem to find one online. It says rimoldi on top and the numbers on the front plate are B.29.17 There are numbers on the back, one plate says 194076 and the other 0901-0962 Thank you- any help would be appreciated, Mindy Gregory

... Vacuums

Hoover Bagless Hello,      My Hoover bag less (Model U5280-900) is not picking up dirt like it should.  The brush roll is spinning fine, but the bristles on it are only about one quarter inch long.  I am wondering how long they should be.  The vacuum is quite a few years old.  Do you think it is time to replace the brush roll.  Could you email me at [email protected] about this topic.  The product bar below did not contain my model no.  The correct model no. is above in my message.  Thanks

If the belt is more than six months old then change it even if it is not broken. then replace your filters if that doesnt work than check the hoses for a clog drop a marble down them and make sure it comes out. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Belt I have a bissell pro heat model number7901-1 and i dont know how to put the belt back on. The old one broke and i cant find my book.

First take off the cover on the left side of the top cover, then turn it over, remove the screw holding the red lock and pull the cap and brush roll out, remove the cap, remove the cogged belt, then you can put the new pump belt thru that slot, put o ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have a dirt devil that is only 2 years old, I used it and sparks began to shoot out from the front grill area. I called dirt devil's corporate office at 12noon today July 25th, and was told that with out my receipt there was nothing that could be done and since I only paid $39 for the cleaner I should just get another one. This product is a fire hazard!!!!!!!! I was vacuming near my bed when the sparks began, I find it unbelievable that this was taken so lightly. If my home had burned d

... Dirt Devil Vacuums

Can't figure out how to change the broken handle on my Fein Turbo I - I have the part but can't figure out how to get the old one off. Have been trying to find some instructions but to no avail.

Hello. Here is a link to a diagram of all of the parts of your vac broken down and labeled. http://www.fein.de/corp/us/en/service/tooldiagramm.html ... Fein 9-55-13 Turbo II Bagged Canister Vacuum

I need to replace the cord on an older Hoover upright, model S660, about 1986 vintage. The cord broke where it enters handle. Handle comes apart easily. Just not sure how to pop the switch out without breaking it. Was looking for a manual online to see parts diagram and/or instruction on disassembly and cant seem to find one for that old of vacuum.

Check ebay. those vacuums are worth fixing. I loved them. they would **** the carpet off of the floor! those cords aren't hard to replace.just remember the way you got the old one out. ... Vacuums

I have two old identical 5842's that I use in the garage and around the house. The belt broke on one so I bought a bag of 2 genuine Eurika "U" belts, which is the correct belt for this vacuum. They were obviously smaller than the original belt because they were not stretched out. When I put the new belt on it lasted about 20 minutes and then came off. I put it back on and ran the vacuum with the cover off to see what was wrong. Everything looked fine except the belt rides to the outside edge of

Not 100% sure this is the remedy for that particular problem, but I would take the time to clean both of the brushes that the belts operate, one on each machine.\015\012Remove the brushes and clean as best you can. At the end of each brush there sho ... Eureka Whirlwind Litespeed 5840 Bagless Upright Cyclonic Vacuum

The bag latch on my Kirby Generation 3 broke. How do I get the old one off to replace it

At the bottom of the bag, there is a zip tie around the plastic part that turns & snaps on to the exhaust hole of the vac. also take a flat screwdriver & pull up the rubber under the zip tie...all the way around, like u would take a bike tir ... Kirby Generation 3 Bagged Upright Vacuum

I think there used to be a metal hanger-like piece of **** holding down the bag at the spot where it is affixed to the vacuum cleaner. I want to find it, and if possible, download the **** manual. Too much to hope for? Hoover Legacy 830.....Model # U5079-910......Serial # 069100005664. Please don't tell me it's SO old they deny ever having made the thing!

Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=559223\015\012\015\012Generic problem for all Vacuums\015\012\015\012I think there used to\015\012\015\012Posted by imaninvi ... Vacuums

The vacuum bag for my Kenmore Canister Vac is #50559. I can't find them anywhere. The man in a Vacuum Parts store here in Canada said #50558 is the one I need as it is the same thing. Is this correct???

... Vacuums

Replacing the old chamber filter (cloth on both sides)with filter that has cloth on one side black foam on the other. Which side faces the bag?

... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

I just bought this vacuum at a second hand store. My girlfriend told me to grab it as it such a quailty product. How ever I can't find a model number or anything else. I need a manual please. Does it take bags? Do I need to replace the filter or just wash the one I have? It is black and silver, cannister. It also says big gary's vacuum system warehouse in surry British Columbia, Canada. It also says to use filter pow-r-nozzle 96. I have no idea of the year.

I suggest you google what you know. I dont think anyone here can suggest where you can get a manual for a machine you dont even know the name of.\015\012\015\012You ask about a bag ... I dont know ... is there one in it now? You ask abo ... Vacuums

Possible broken belt - where do I find access to the belt. The beater bar does not rotate when i release the handle. I like this machine, but It is only 2 years old, the warranty has expired. And i must say, I am disappointed I am concerned that this article will end up in the landfill, adding one more problem for the environment.

As you do not say which type of vac ? but assume definately upright hoover/dyson or similar ? the actual belt is not difficult to renew on either model/s at this stage can only suggest you turn vac over to reveal the cover that houses the ro ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0531 seconds