Having problems with your Hoover Company Wind Tunnel U53019 Upright Vacuum ?

I have a windtunnel vacum cleaner. When I

\015 I have a windtunnel vacum cleaner. When I start it there is a smell like it is burning and it is hard to push? any ideas?\015

Answers :

It might be a slipping rubber belt, is the brush roller moving when you look underneath? If it's a self propelled machine there might be another slipping belt. Friction from fast rubbing rubber can smell like it is burning.
Repair Help & Product Troubleshooting for Hoover Company Wind Tunnel U53019 Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hello, my names Travis. I was contacting you in concern of my Kenmore Quick Clean 12AMP Vacum Cleaner. My girlfriend took the bottom off the vacum and removed the belt because the vacum wasnt picking up. I know have a new belt i just dont know where to put it on the vacum to reinstall it


Look for grooves on the motor shaft and on the brush shaft. ... Kenmore Quick Clean 30012 Vacuum

The cleaning head of the vacume does not lock into position when I pick up the vacume, therefore when I raise the vacume th cleaning head just lays down.


The mechanism that locks the head into place is broke. Prob a plastic tab that broke off from so much use. ... Vacuums

Vacume did not come with screws to hold handle to Vacume need the screws handle falls off vacume hits the floor [email protected] Model # 3041 Type - B2 The answer is simple, send the screws please this will fix the problem. Thanks Dr.Tracy Massie Dr.Tracy Massie Harvard;Dr/PHD; Chief Officer of Internal Medicine;Lead Surgeon Dr. Child Disorders; Princeton Dr. / PhD.; Chief Medical Officer; Lead Councilor


... Eureka 3041BZ Upright Vacuum

Vacume Overheating My vacum is overheating and then shuts down for awhile but doesn't start again untill the vacum has cooled down.. Are there any heat-relays or something like that that could cause the problem ?


There will be a filter between the cylinder/bag and the engine. If your vacuum has a HEPA filter there will be one on the other side of the engine. Remove both of these and clean them out with water, allow to dry and replace. ... AEG Vacuums

Ware can i get bags for my vacum - Fantom Vacums FC251 Canister Vacuum


This model vacuum does not use bags. So, you can't. ... Fantom Vacums FC251 Canister Vacuum

When i start the vacum the brushes trun for about 3-5 seconds then stops. the vacum still runs,its just the brushes stop turning, what should i do?


If your machine has no power or interrupted power, please check the following:\012 \012- Make sure the power cord is plugged into a functioning outlet to check for power.- The handle may not be installed properly, causing a ... Bissell Healthy Home HEPA Bagless Upright Vacuum - Metallic Blue

My vacum keeps sutting itsself off after a few mins of use. I need to vacum the whole house and dont have tinme for it to cool down every 10 mins


Something is plugged. What you describe sounds like the motors' thermal limiter is opening the circuit to prevent the motor from overheating. You need to open and verify that evey air passageway is clear and the unit has good air flow. I bet you find ... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

I have a 5.5 hp craftsman 20 litre wet Dry vacum . I have lost the manual. & have 2 questions 1) how do I change to wet vacum from dry? Also could i use the wet mode with some water in it and let it run while I am sanding dry wall to catch the dust in the water in the container? Thanks


# 1 myou just take the bag out make sure ytou sponge filter is in place athe top and turn it on the power switch just turns on ,machine ther is no wet dry switch just an empty bagless cannister is all you need make sure the ball outlet in vacumn is w ... Vacuums

How do you fix the beater bar in a dyson vacum. Otherwise the vacum works fine.


Its either the belt or the roller switch. Most likely the belt. Go to lowe's and get the replacement belt.Remove the screws that hold the cover on the bottom of the vacuum and remove it. You will see the broken belt. pull it out of the va ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

I was vacuming with the hose only with my kirby generation 3 vacum and it suddenly made a different sound and smelled strong of burning. I immediately shut it off and unplugged it. It IS about 30 yrs old. Do you think it is worth taking in to pay someone to look at it or it just bit the dust?


It might be the belt and if it is it will be a sipmle fix. If it isn't I think It's time to bite the dust and buy new. You won't believe what you old vacuum was not sucking up and for what it would cost to repair vs buying new it would be about the s ... Vacuums

Panasonic vacume#MCV573500 was vacuming motor stopped and won't restart. is there a reset button?


It is probably a thermal issue. contact any local vacuum dealer. ... Panasonic MC-V7355 Upright Vacuum

Vacum bags I just found this vacum in the basement ...does it use bags???


The vacuum that you have is over 10 years old. You can no longer get the bags directly from Bissell but if you call a authorized service center near you, they may still have bags that will fit your vac. So the answer to your question is yes.... ... Bissell 3065 Power Partner Vacuum

I have a Dyson DC14..I was vacuming and when I stopped the vacum would not stand up..it wouldn't click in the stationary poistion. When I turned it on all the suction is coming from the hose even though it is tilted. Can I do something to fix this?


Yes! Stand behind the machine. Hold the handle at about 45 degree angle. Remove the airway inspection valve (press the yellow release button that's between the right wheel and the clear bin and then just pull away that curved piece of plastic pipe). ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Vacum overheats and starts smoking after 4 minutes of vacuming


Clean vacuum internally, if the problem persists replace the motor. ... Panasonic MC-V7395 Vacuum

Vacume cleaner The vacume has no suction. the belt is fine i checked it. It turns fine no air is comming from the hose.


Check the hose and see if it has a clog, also the hose at the bottom. The filters may be clogged, make sure they are clean and that air flows thru them, if not then replace them. ... Eureka 5892AVZ Bagless Upright Cyclonic Vacuum

I have a Electrolux , EL6988 Canister Vacum, howeveer the brushes and motor will not run when turned on. I have take the plates and cleaned around the brushes, but it will not come one. The vacum comes on but the motorized bushes do not activate. Thanks I have lost my owners manual, and have looked for the reset button and can't find or know where it is located. Any suggestions.


I need the molded wire harness inside the plastic wand ( one of the prongs is broke off) What is the part # or where can I buy it? Model EL6988 ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I bought a Eurika upright vacum (the boss whirlwind lite) it is pretty new, keeps shutting off before i am done vacuming, and the hose doesnt **** very well!!!


Your model mite have a divice that turns the motor off if it heats up if so take it to a repair shop and have them look at it ... Vacuums

How do i go from dry vacuming to wet vacuming with the rigid shop vac


Can I run my sears shop vac without the paper bag, for dry pickup? ... Ridgid 9 Gallon Wet/Dry Shop Vac 96882 Canister Vacuum

My wife and I own 6 IRobots: 1 Scuba 1 Dirt Dog 4 House cleaning vacume models All of them are not working, so I decided to try and solve the problems with two of them: One is a dirt dog and the other a house cleaning vacume Rumba. Given: Battery is fully charged Reaction: I start both of them. They run for about 2 to 3 seconds They come to an abrupt stop as if there is a rock in the gears. Help


Both of them have identical issues? Can you please provide the actual part number of them? It should be on the bottom or inside the battery area somewhere.ThanksTim ... iRobot 1100 Dirt Dog Bagless Robotic Vacuum

My bissel vacume was not picking up the dirt on the carpet. So I found that the hose was clogged. I unclogged it but the vacume still is not picking up the dirt. I also changed the filters.


I found out that if you remove the front filter holder, tip vacuum back and look down inside. Sometimes there is hair caught back in there and you won't get suction. I had to use something long, knife, very long type tweezers, to pull all the hair ... Bissell 6594 PowerForce Bagless Upright Vacuum

I work for a company and we have bought about 25 hoover upright vacums since november of 2008 from HD supply and we are to refer to hoover for manufacturers warranty. We have a vacum that needs a bag replaced under warranty.


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=560323\015\012Generic problem for all Vacuums\015\012I work for a company\015\012Posted by dmoses96 ... Vacuums

Roller brushes on vacum won,t turn and vacum makes a screeching sound


You need to replace the belt. Here is the belt you need and the manual:Bissell Healthy Home Belt and Manual ... Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum

I want to register my new Platnium upright vacume..I went to the website ( htp://www.prodregister.com/hoover and nothing came up that said for me to register...Please let me know where I can go to register my vacume...Thanks!!!


Those url link are not correct either I have a Hoover myself and had a problem finding it.SO.... like a normal person I just went to hoover.com itself, and guess what I found but a product registration page. It also has a url for it as well,.which is ... Vacuums

I have the Bissell power force bagless upright vacume and I took the filters off and cleaned them and don't know where the round filter goes to be able to continue vacuming.


I had shortly after posting the question requesting help and then found the product manual.\015\012\015\012Thank you very much though. ... Bissell Vacuums

I bought the vac, used, but was told there was nothing wrong with it. I called the company, and was given the impression that it will be a huge headache to return it. Here's the best part: when I received it, I opened the box: it was broken. Clearly the highest internal piece of the vacume, whent he handle is removed, was cracked off, and in two pieces. The handle will not lock into place, so if I were to vacume forward, see ya, and the vac is back in pieces. Any idea how to rig this to get it t


... Dyson DC25 Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0223 seconds