Having problems with your Hoover Elite Rewind Bagless Upright VacuumVacuum ?

Hoover Elite motor runs when moving backwards but not forward

\015 Hoover Elite motor runs when moving backwards but not forward\015\012Seems to be related to the angle of the handle since once in awhile it will start to run going forward but always runs going backwards\015

Answers :

Are you sure its not just your belt on the beater of head slipping and needs to be replaced?
Repair Help & Product Troubleshooting for Hoover Elite Rewind Bagless Upright VacuumVacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover Elite motor runs when moving backwards but not forward


Are you sure its not just your belt on the beater of head slipping and needs to be replaced? ... Hoover Elite Rewind Bagless Upright VacuumVacuum

Hoover U8185-900 motor shuts off when you move the cleaner forwards but it runs when the cleaner is moved backwards


... Hoover U8185-900 Upright Vacuum

NO SUCTION ,EITHER AT WHERE THE HOSE GOES IN OR AT THE MAIN NOZZLE. WHAT COULD BE THE PROBLEM, HOOVER ELITE? ALSO MOTOR IS RUNNING AT A HIGH SPEED THAN NORMAL.


It might be clogged. ... Hoover Elite U5349-900 Upright Vacuum

Overheating motor won't run - Hoover Elite Rewind Pet Bagless Upright, UH71003


... Hoover Elite Rewind Pet Bagless Upright, UH71003

My Discovery 4210 Roomba will run normally for about 20 minutes on a smooth, wooden floor. It then begins the following sequence: run forward a few inches, turn in a tight counter-clockwise circle a few revolutions, stop, power off a few seconds, power up, repeat cycle from forward run. The sequence can be repeated seemingly endlessly if I don't turn off the power manually. I've replaced the motor, and led revolution sensor system on the left drive wheel. I've blown the dust out of everywhere. A


This robot vacuum has a electronic micro processor that controls the unit and tells it how to operate and where to go based on programmed parameters. It's quite a technical marvel. I have dropped a link here for contacting the company tech support li ... iRobot Roomba 560 Robotic Vacuum

Makita 440 Dust Extractor - Trying to rectify a problem, when i switch on an appliance plugged into the socket, it will not run. IS used to run with this plugged in, but the hoover motor runs no problem. Any ideas what might be amiss, or where i can get a wiring diagram? Thanks in Advance!


... Makita 440 Wet/Dry Vacuum

Loud noise coming from motor on hoover elite rewind vacuum


... Hoover U5507900 Elite Rewind Bagless Upright Vacuum

My Hoover duros s3590 just stopped running. The motor started up and then just powered down and won't start back up. Is this a faulty on/off switch or a motor problem. I'm weighing the +/- to fix or buy a new vac. TIA


... Maytag Hoover Duros S3590 Vacuum (Canister)

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Mine does the same thing. There is no suction. I found that there is a door that opens when you tilt the handle in the down possition. I think there should be a spring in place so it can open. Until I find a replacement spring I have to open the door ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

No suction My Hoover Wind Tunnel vacuum runs but there is no suction. The last two or three times I used it, it shut itself off after having a burning smell. When I unplug it for the suggested 30 minutes, the motor will run again but no suction. What is wrong?? Should I just buy a nve one? This one is 8 years old.


Sounds like your motor bearings are going bad. This is generally indicated by the motor overheating, and the heat transferring out through the motor pulley, which is where the belt attaches. So, your machine is overheating, melting the belt, and then ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Ihave a Hoover Windtunnel self-propel model U6445-920. The belt from the drive motor to the big wheel will not run in the center of the wheel. The belt runs about 1/3 off the wheel. I have tried several new belts and still the same problem. What do I need to do to repair this problem.


The large wheel may be worn off center. If the belt stays on and is not thrown, you can run the vac. if there is wobble in the wheel causing a genuine belt to slide off replace the wheel mechanism. ... Vacuums

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is ... Vacuums

Hoover SteamVac Al Terrain Spin Scrub motor running in reverse


If it dosent **** up the water send it back but some hoover steamvacs blow air to dry the carpet or floor faster ... Hoover F7431-900 SteamVac Vacuum

Hoover linx motor makes a lot of noise when running


... Hoover Platinum LiNX Cordless Stick Vacuum

Hoover Vacuum Elite (Allergen Filtration) 12 Amp Motor


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=646648\015\012Generic problem for all Vacuums\015\012Hoover Vacuum Elite (Allergen Filtration) 12 Amps...\015\012 ... Vacuums

Hoover bagless vacuum motor not running


... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

Broken motor on new Hoover Elite Rewind


I only have the number for the hoover service center in Seattle, but they can certainly point you in the right direction of a service center in your area or a customer service rep.\015\012\015\012Hoover: 206-367-4425\015\012\0 ... Hoover Elite Rewind Bagless Upright VacuumVacuum

Is there a trick to getting the belt on the motor pulley and brush on the Hoover Elite Supreme


Hi ,try warming the belt up in hot water first it will stretch better\011 ... Vacuums

Hoover Elite II Model # u4689-910 Impeller replacement


I have had to use a dremmel tool to cut the plastic around the shaft, you can also something sharp and a hammer to break away the remainer of the fan. There are no threads on the fan so to keep truning it may or may not get it off. Just have to wat ... Vacuums

Hoover shampooer motor is running ,but no suction


When you place the recovery tank on the machine, there is a mating of the tank to the motor intake and this directs the suction into the tank. Make sure the lid is on the tank correctly. You also should check that the seal on the motor intake is in p ... Hoover F7220900 SteamVac V2 Upright Vacuum

Hoover Model U6425-920, Series Q 12.0. runs 3-5 minutes, shuts down on thermal reset. motor shaft and brush both turn freely. cannot detect any roughniss at all in shaft turning.


... Hoover Vacuums

My Hoover U6430-900: the motor seems to be running fine, the brushes turn fairly well, no blockages but no air is moving through it at all? Is it likely the fan and is this something I can replace myself?


Keep looking it must plugged somewhere ... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

Our Hoover floor mate won't **** up the water. Motor runs but pick up is limited.


You will need to replace the squeege that is located on the nozzle. 3 screws will take it off. you can get this at a vac shop or order it from the company, filter may also need to be changed ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My Hoover carpet cleaner is approx. 7 yrs. old....husband believes motor is shot? Smells burnt when running....fix or buy new???


You are correct, the motor is shot. if you like the machine replace the motor. i would get an est. on the machine from your local vac shop and the go price them. in some cases its better just to get another machine. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I HAVE NEW HOOVER STEAM VAC MODEL#F7452-990 serial #AA120 THE SOAP AND RINSE WATER KEEPS RUNNING WHEN THE MOTOR IS ON.


Check the FREE download of Manuals for this model on http://www.hoover.com/product.aspx?model=F7452900&ds=false ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0515 seconds