Having problems with your Hoover F5858-910 SteamVac Vacuum ?

Hoover steam vac won't spray water while cleaning


Answers :

Repair Help & Product Troubleshooting for Hoover F5858-910 SteamVac Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover steam vac won't spray water while cleaning


... Hoover F5858-910 SteamVac Vacuum

Hoover steam vac upholstery tool wont spray water


... Hoover Vacuums

My Hoover steam vac dual v clean water and detergent tank leaks water before attached to the vac and during cleaning


This is a common problem with the earlier models which had a separate soap tank glued to the clean water tank. The plastic was too thin beneath the valve on the clean water side and would develop cracks. You most likely will need a new one piece tank ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover Steam Vac Deluxe Wont **** up water?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Steam Vac clean water tank valve leaks


A) make sure that there is not a place for a stair attachment. If\015\012there is make sure air is not leaking through where the attachment goes\015\012on because of damaged or misplaced fitting.\015\012\015\012b) some steam ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Took my Hoover Steam Vac apart to clean it and now it won't **** up the water but was working fine before I got the bright idea to clean it. Took four screws out but did not touch the motor. It puts out water and the brushes rotate but no suction? Thank you for your help, Cathy


The suction is created by the motor and is pulled to the motor through the flexible hose. The hose could have pulled off at one end or it could have torn in a spot where there is more pull on the hose like when you lay the handle down to empty dirty ... Hoover F7431-900 SteamVac Vacuum

Can't find info for hoover steam vac spin scrub model # F5905900 on Hoover website, doesn't show that model number at all...looking for mesh (kind of cone/cylinder shape) that goes in dirty water tank (I think) and also the tool (wand) that slides into front to clean it out. It doesn't pull all the water up very well and the filter has been missing for some time. I don't know if that has anything to do with it or not. As far as the wand tool goes, I have taken the cover off at this point and


The cleanout tool is part # 43514001. The filter is # 90001398. Be sure to leave a 1/2 inch gap between the top of the filter and the bottom of the lid. If you need a manual, try model F5914-900 0r F5912-900 on Hoover.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Wont spray i have a bissell pro steam 2x and it wont spray the water out, i have cleaned everything and nothing seems to be working ...please help


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Brushes on Hoover Steam Vac F7441-980 do not turn.Brush control on;drive pin present;filter intake clean; Drive mechanism doesn't appear to be turning. Also when spraying on cleaning solution, spray comes out in streeks rather than the width of nozzle. JBB


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a new Hoover Dual V steam vac that I bought from a neighbor who only used it once. I have only used it once since then and it worked great. This time, because I am pregnant, I bought some non-toxic cleaner that was much thicker than the very watery Hoover soap. This vac has a wash option and a rinse option. The rinse option works (sprays and sucks properly), but the wash cycle doesn't at all-neither soap nor water comes out. Nothing comes out, but it still sucks. I took everything o


There's a powerful electric motor attached to a fan that sucks in air.Did you checked and cleaned that motor.If the dirt is got stuck up ion the motor then the motor will not spin as per its regular speed.For rinsing the motor spin on one cycl ... Vacuums

Hoover steam vac won't spray water


... Hoover Vacuums

Hoover Steam Vac V2 Deep Cleaner leaking clean water


Fill the tank and determine if the plastic is leaking, or if the valves are leaking. if the tank is cracked, it would need replaced. There is an improved design now available.\015\012\015\012You may cycle the valves on the bottom with t ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover Steam Vac Clean Water Streams from Unit


Hello there, Are you certain on the model number of your Hoover vacuum, I can't seem to find any reference to that anywhere online.Either way, I am familiar with these steam cleaning type vacuums. The electrical control for t ... Hoover F7458-900 Upright Vacuum

Hoover steam vac clean water reservoir leaking.


Take the clean water tank out and look on the bottom for a fitting that screws on make sure its tight.also inside of that fitting trhere should be a washer or an oring to keep it from leaking.if thats not the problem then your pump mightbe leaking.fo ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steamvac maxextract 60 wont spray clean water


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Clean Water Leaking from Hoover Steam Vac


... Hoover F5826-900 SteamVac Upright Wet Washer

I HAVE A HOOVER STEAM VAC DELUXE 5 BRUSH AGITATOR THAT SPRAYS WATER BUT IT DOES NOT SUCK UP THE WATER TO THE RECOVERY TANK


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I just bought a hoover steam vac model F5914900 and the clean water tank is leaking. I tried pressing the clean surge button and the trigger button that was suggested by someone else but it won't


Go to Hoover.com and find a local Service Station. They will replace it at no charge. MUST be a warranty location to get it free. Take your sales slip with you. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover steam cleaner is spraying water from the right side as soon as it's plugged in and ready for steam cleaning. What's the solutio?


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I'm using a steam vac for the first time, i wanted to know if the bottom piece that you empty out the dirty water has to have water in to use it. or is it suppose to be empty?it's an upright hoover steamvac for heavy traffic areas and spot cleaning


Hello,\012The bottom piece should be empty when you use your machine. Make sure you rinse it our real good when you are finished.I hope this helps. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Water pours out from the clean water tank,there is a plastic type pin that the tank sits on and i'm not sure if there was some sort of washer on it that is not there now. Its a Hoover Steam vac, model # F5875-900 Thanks for your help.


The hose is off tilt the handle back you will see it running down into the base ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My hoover steam vac spinscrub f5915100 wont despence water


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I have a hoover steam vac and water will not spray from hand attachment


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover Agility Steam Vac has no suction for the dirty water


Broken suction hose. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

I own a Hoover Steam Vac V2 deep cleaner with Auto Rinse feature. The Model Number is not available ex: was on the bottom of the machine and the sticker is completely worn off the machine. I am having a problem with the bottle you fill with detergent ex: this bottle is seperate from the main clean water tank. THE PROBLEM: The little plastic part that goes in the bottom of the bottle has an "O" ring ex: cone shaped with a spring.....it keeps falling out. Can you supply a part number for this


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=641300\015\012Generic problem for all Vacuums\015\012I own a Hoover Steam\015\012Posted by w_brennan on ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1217 seconds