Having problems with your Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum ?

How much water goes in the vaccuum

\015 I have never used a steam vac and i cannot find the instruction manual and can't figure out how to work it.\015

Answers :

I have a simular model. Here's what I do.
On the fill tank (that's the top tank), look on the front and you'll see where it says "Fill Line". Fill this with hot water first (so it doesn't foam up) and then add your cleaning solution. Make sure the lid on the bottom tank is on tight. It should snap in place. Top should also snap into place. Turn on and pull trigger and move forward a few feet, let go of trigger and solution will stop coming out. Do this a few times and then without pulling trigger, go over the same area you just did to pick up water. Repeat this until you are done. When the bottom tank is full, it will sound a little loader and higher pitch. Just empty tank and put back in and continue.
Hope this helps.
Repair Help & Product Troubleshooting for Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How much water goes in the vaccuum

Hello,I have a simular model. Here's what I do.On the fill tank (that's the top tank), look on the front and you'll see where it says "Fill Line". Fill this with hot water first (so it doesn't foam up) and then add your cleaning solution ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

How much water goes in the tank?

Water has to be level with the tip of the bump. 1/8 of the inch above or under - would not make a difference.Good luck,Rocky:-) ... Rainbow 75th Anniversary Canister Vacuum

Can't get the cork to open....and can't find the booklet...also...how much water goes in?

Request operating instruction for model no. sc 618 ... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

How much water goes in my proaction handheld steamer

... Vacuums

How much water goes in the ultra steam shark 2?

... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Uses too much solution and it goes into the clean water

... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Bottom container does not catch water when I vaccuum

I am about to go wrestle with the vacuum once again. I read somewhere that I should check the tube that extends from the handle and also check the other tubes to make sure there are no holes in them and to also check the seals. If I get it to work ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Can't find info for hoover steam vac spin scrub model # F5905900 on Hoover website, doesn't show that model number at all...looking for mesh (kind of cone/cylinder shape) that goes in dirty water tank (I think) and also the tool (wand) that slides into front to clean it out. It doesn't pull all the water up very well and the filter has been missing for some time. I don't know if that has anything to do with it or not. As far as the wand tool goes, I have taken the cover off at this point and

The cleanout tool is part # 43514001. The filter is # 90001398. Be sure to leave a 1/2 inch gap between the top of the filter and the bottom of the lid. If you need a manual, try model F5914-900 0r F5912-900 on Hoover.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Bissell steam shampoorer..I'm not sure where the water goes. I assume in the bladder (soap & water)..there is a little red plastic piece that I don't know where it goes..somewhere in the bladder?..Anyway, no solution is coming out and of course no vacumming up. Cannot find my manual or instructions. I've had it working before..thanks

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Dyson vacuum I have a DC07 vaccuum. The problem I am having is that the front does not want to stay down as I vaccuum and I continuously have to keep stepping on the front to make it go back down to the floor. It seems as though there is either not enough weight in the front or possibly the unit just has to be broken in so that there is not so much resistance between the handle and the front of the vaccuum. Could there be something I did not remove or is this typical on these vaccuums?

There is some thing broken it is two plastic cogs they help the front go down and stay up you will have to get a star screw driver and there should be two screws on top and two at the b ... Dyson DC07 Bagless Upright Cyclonic Vacuum

How much soap and how much water do I put in the Bissell pro heat?

You are supposed to buy the Bissell soap. On the bottle depending which cleaner you need. The directions are on the bottle. Please do not use house hold cleaners because you can cause serious damage to the vacuum.\015\012Go here, this pg. shows ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm

I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Tefal steam iron (Pressing Compact) blew a fuse. There was water in it and it had been used for about 15 mins. It had been leaking small amounts of water through he steam holes.I changed the fue and emptied as much scale as I could, refilled it and switched it on.Now it works but pours lots of water onto the clothes, making it impossible to use!

... Vacuums

The cleaner/water solution dispenses into the carpet, cleans it, pulls out the pet hair, but no dirty water goes into the dirty water reservoir! is all this dirty water going into my carpet?

The pet hair may be clogging the water return inlet I suugest you clean the bushes and inlet as well ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?

... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a george wet and dry (A26A), it wont pick up any water. the tube which goes from th lid into the water wont pick up water?

... Vacuums

I have a bissell quicksteamer powerbrush home steam cleaner and it will not **** up water anymore. All the filters are clean, it sprays water fine, but no water goes into the waste container?

... Vacuums

I put boing water in my water tank for my bissel quick steamer it does not want work right any more i need to know how much would it cost for a new water tank, and how i might be able to order one, as well as a free manual

Hi and welcome to FixYa. I am Kelly \015\012\015\012Here are all the parts for your machine. \015\012Click on "read more" for price details \015\012\015\012 ... Bissell 8930M Upright Steam Cleaner

Im trying to put the peice back together that goes under the tube that hold the water the part that goes into the hole in the vacum.. i took it apart because its not spraing right to see if it was cloged.. and now im not sure how it goes back together.. can you please help me.....

I tried to find a service manual for this, but came up with only a exploded view diagram:\015\012\015\012http://ineedbags.com/images/b8920.jpg\015\0 ... Bissell 8920 ProHeat 2XTM Upright Vacuum

Carpet Powersteam water tank no dirty water goes in

... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a steamvac v i was wondering if i fill the container of water to the top and does the water need to be cold or hot? I heard I could use tide liquid if so how much do i put in the detergent holder

Hi there SmartAlec from NelsonVacuums.com.au here. I have looked at literally hundreds of steamvacs over the years and you can use warm but not hot water in the tank. You c ... Hoover Vacuums


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My keurig coffee machine makes noise like it is brewing, but water just drips out. De scale reminder is on, but with no water coming out the vinegar is sitting in there and not doing much- a few drips coming out with each cycle. this will take for ever to get through the entire container of vinegar -should I keep trying and see if it fixes the problem??

... Vacuums

Hello. first id like to thank you very much for helping me. There is no problem really. Id just like to know if i can use other soap or product to clean the rug besides the kirby evaporated dry foam.. Also how could i **** up as much water as i can?

I would only use the brand intended to be used in this machine. Home Solutions Turbo Shampoo by Aerus Electrolux. This machine doesn't **** up water, and if used according to the directions, there really shouldn't be much water on the carpet. ... Electrolux Floor Pro Vacuum

My Pasquini Livia 90 S/E will not stop heating water. This builds up too much pressure. I have unplugged the machine and let it cool off and turned it back on and got the same result. I can relieve the pressure by opening the steam valve, but since the heating element does not turn off it builds up too much pressure very quickly

Your thermostat is failing. Given the initial price tag, look at your warranty options first. If you are out of warranty, then lets proceed.Since there is not a parts / assembly diagram to be found, you will need to disassemble your esp ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0612 seconds