Having problems with your Hoover F5899-910 SteamVac Vacuum ?

Hoover steam vac hose is broken

\015 Broken at the connection to the unit\015

Answers :

This applies to Hoover SteamVac model F5899-910.

My unit had a broken hose. I repaired the hose using duct tape and Teflon tape. The breakage seems to be due to a manufacturing error or design defect. The hose is clamped to the unit where it passes to the inside. The position of the clamp did not allow enough slack when the handle is released and the unit is wide open.

The hose coupling has a plastic latch that holds it onto the vacuum nipple. Pry it and remove the coupling. Then trim the ragged end of the hose and clean things up. Wrap the hose with some teflon tape and then tape the hose to the coupling with several turns of duct tape. Attach the hose coupling back onto the vacuum nipple.

Now you should move the clamp say an inch, so that it leaves more slack. Take the two screws out of the clamp and pry out the plastic bracket/cover that holds the clamp in place. Then move the clamp and screw the clamp back onto the bracket/cover. Then snap the bracket/cover back in place.

Take care not to put too much slack in the hose (by moving the clamp too far), as the hose can also bunch up due to being too crowded when the handle is upright.

Inspect the hose and the tape whenever you use it.
Repair Help & Product Troubleshooting for Hoover F5899-910 SteamVac Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover steam vac hose broken so I get no suction.

The entire hose has to be replaced. I beliive they run about 39.99 ... Hoover F5872-900 SteamVac Wet/Dry Vacuum

Broken hose The hose on my Hoover F5837-900 Steam vac Supreme broke away from the coupler on the bottom of the unit - under/behind the recovery tank (solution tube is till attached). It might have gotten pinched in there a couple times. Problem - it was glued in the coupler really well, and I cannot get the whole thing out - hose will be too short anyway - is there a way to fix this or a part I can order instead??

You will have to replace the complete hose asm, part # 90001337 ... Hoover F5837-900 SteamVac Supreme Wet/Dry Vacuum

Hoover steam vac hose is broken

This applies to Hoover SteamVac model F5899-910.My unit had a broken hose. I repaired the hose using duct tape and Teflon tape. The breakage seems to be due to a manufacturing error or design defect. The hose is clamped to the unit where i ... Hoover F5899-910 SteamVac Vacuum

Parts replacement We have a Hoover Steam Vac that has a broken part #10 in your picture or Part # 37271035. Does this part cover the whole top section of the Vac? Is it hard to replace? Where can you get the best prices on Hoover parts? I have been on Hoovers website and they don't even recognize this Steam Vac. which is hard to believe they don't even recognize their own unit? Thanks Ray

This the hood or top cover. There some screws on the bottom as well as on the top, then it comes off. ... Vacuums

Replace interior hose for cleaning attachment for Hoover Steam Vac Agility

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=618767&thid=632107\015\012Replace interior hose for cleaning attachment for...\015\012Posted by castcomm on May 29, 2008 ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover steam vac max - hose that sucks water up from carpet broke

... Hoover F6207 Steam Cleaner

Routing of cleaning solution hoses on hoover steam vac

... Hoover Vacuums

MY hoover steam vac hand held hose cleaner leaks profusely

Try taking a sharp knife and shaving a little off the edge of the plastic, or a small file if you can get to it, see if it is getting binded. If its getting stuck internally, you will have to replace the switch instead of risking takin it apart. ... Hoover F5810 SteamVac Upright Vacuum

How does the upholstery cleaning hose attach to the vac? Hoover Steam Vac Deluxe Model # F5860-900 Series 17.9

See if this manual helps:\015\012http://www.hoover.com/pdfs/manuals/F5857955.pdf ... Hoover Steamvac F5860-900 Vacuum

How do you remove the recovery hose from my hoover agility steam vac

... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Steam Vac F8571-900 hose if broken off at the point where it enters the machine. Can I replace it or where to get it fixed in Bemidji MN area

It will have to be replaced, need to see a service center for vacuums to get the part may cost around 50 dollars for the part. ... Hoover Vacuums

I have a Hoover Steam Vac F7458-900 & can't find out how to hook the hose up to the machine.  Can you tell me how?

On the end of the hose there are two tabs. These two tabs line up with the round cover on the nozzle of your unit. Its about 2 inch lid that lifts up. (Nozzle is the clear plastic piece on the foot of the unit where water goes up.) ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

How do you connect the stair and upholstery hose to the hoover steam vac

You can download your manual at Hoover.com under Service and Support - Download Manuals. It's acutally very easy to connect: With cleaner unplugged, open the hose connection port on the top of the suction nozzle (much easier to just follow the pict ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I think the trigger on my upholstery hose is broke how can i tell? trigger is loose- water just flows out and i have to shut the machine off. i have a hoover steam vac dual deep cleaner

The most common issue with this is the white nozzle tip broken. sometimes it comes out. it still could be the trigger. take it to a shop and they can tell right away. the trigger is spring loaded, you should feel tension. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I can not get my attachment hose hooked up to my Hoover Steam Vac with Clean surge model F5914-900

Http://www.hoover.com/pdfs/manuals/F5914900.pdf ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac model f5912-900 stoppped sucking.please dont tell me to check the hose, there isnt one,and the extraction tank IS empty.this machine is brand new with 10 minutes on it ?????

There is a hose under or behind the extractor tank which can come loose or tear. Lower the handle and remove the tank to look for it. See if it sucks when you use the upholstery attachment. If it does this would indicate that the part that lowers to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a hoover steam vac LS 3600 and i attached the tool to clean my couch. the tool is sucking but no solution is coming out. i checked the hose and everything looks ok but no solution will come out of the sprayer.

There is a small pump inline of the spray unit. This is normally a coil type reciprocating type and most often this can be dirty or faulty.\012So remove pump and check it on table to see if this works, if not clean or test coils for continuity. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My hoover steam vacs brushes will not turn . could there be a belt broken? I have misplaced the manual

For the manual:\015\012http://www.hoover.com/pdfs/manuals/F5914900.pdf\015\012\015\012For the brushes:\015\012(1) Ass ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover Steam Vac for my rugs works fine, but I don't have any suction when I try to use the hose and attachment for my upholstery. I went over the instructions dozens of times but still no suction.

Which type of hose do you have? One has a duct attached to it that fits into a slot in front of the recovery tak, make sure it is seated all of the way down. The other hooks direct to the machine, is it cracked where it hooks up? You can tell by l ... Vacuums

I can't find my manual for my Hoover F6060-900 steam vac; therefore I can't figure out how to turn off the tool feature and water is pouring out of the hose. Can you help me please? Sincerely, Bob damron

Manuals can be downloaded from the Hoover website ... Hoover F6020-900 SteamVac Upright Vacuum

Upholstery conversion I can't find where to attach the end of the upholstery hose so that I get suction.  I have a Hoover F5888 Steam Vac Spin Scrub.

Take out the duct in front of the tank (#3), the hose end will have a duct on it that you insert in its place. This provides the suction for the hose. Don't forget to put that duct you took out back in place, or you won't have suction when you use ... Hoover F5888-900 SteamVac Upright Wet/Dry Vacuum

Help!!! I bought a replacement nozzle valve for a hoover steam vac hose and I can't get it back in right. Does anyone know where I can find an illustration of this assembly??

Hessco.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How do I attach the upholstery hose to Hoover Steam Vac model F5835-900?

... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a Hoover Steam Vac F5853 and the trigger seems to be broken. I have taken off the cover only to find the trigger just flapping in the wind. What do I need to fix this?

... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My Hoover steam vac is stuck on the tools setting and wont stop leaking water from the tools hose

... Hoover Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0898 seconds