Having problems with your Hoover F5906-900 Upright Steam Vacuum ?

Cleaning solution tank dumping

\015 Everything was working fine, used product several times, after refilling clean solution tank unit started emptying itself at an excessive rate, (faster than if trigger were held down). Attempted removing and reseating tank to no avail, seems like trigger broke, but would/could it break in open position? One would think a broken dispensing trigger would result in no no dispensing. No visible signs of cracked reservoir, no obvious broken pieces. \015\012 Actual model is :F5860-900 Hoover Steamvac deluxe series;17:9\015

Answers :

Maverick_bea may be describing a different model than mine... but on my Steam Vac, remove the clean water tank... and locate the black rubber gromet seal. JUST BEHIND the gromet is an opening that allows you to see the trigger actuator. Inspect that actuator while operating the trigger. I suspect that you may have something stuck in that space that is preventing the actuator from restoring to the closed position. Careful inspection should clarify the problem (and the solution.....
In some cases the reservoir that the tank sits on would have to be replaced. best way to tell is, if you take the tank off and pour a little water in the valve where the rubber gramet is. if it holds the water its good, but if it goes down without you pressing the trigger then it will be the reservoir.
Repair Help & Product Troubleshooting for Hoover F5906-900 Upright Steam Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cleaning solution tank dumping


Maverick_bea may be describing a different model than mine... but on my Steam Vac, remove the clean water tank... and locate the black rubber gromet seal. JUST BEHIND the gromet is an opening that allows you to see the trigger actuator. Inspect that ... Hoover F5906-900 Upright Steam Vacuum

Bissell Pro-Heat 7901-1 no cleaning solution is pumped out. The flow indicator is spinning and the belt is spinning the beater bar. Have cleaned the flow indicator, checked vavles in the solution tank and water tank and they are working properly. Also checked the trigger to make sure it works okay. Any ideas?? Moody Fan


Bissell Pro Heat shampooer - Fill the soap dispenser with extremely hot water and shampoo with only water for a few minutes. There is often dried soap in the lines. Make sure that all filters are clean. Press the soap container and the water conta ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Picture you sent for me is not the same model as I have mine is a dual vac v carpet cleaner with the solution tank on the side of clean water tank so I need to know how much solution to put in solution resevoir.


The solution tank injects the cleaner depending on the selection you have make such as light or heavy. You fill the tank with cleaning solution. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Cleaning solution continually runs from clean solution tank


Where is the water running out? If at the bottom of the tank, is the seal on where the tank sits on, Maybe the rod inside the handle is staying pushed down, the reservior asm is bad, or a water line is off.\015\012\015\012 ... Hoover F5881-900 Vacuum

When I was putting my new rug shampooer together and the directions said to press the trigger and the clean surge button until I heard a snap, I did just that many times and never did hear a snap so I thought it had likely happened and I didn't hear it so I proceeded to fill the solution tank and get busy but no solution came out so I used the clean surge button instead and got the job done (I think). Can I continue to use it that way or is there a way I can get it to snap and use it the way it


My husband figured it out and it now works great! Thank you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have Hoover Floormate Model H3004. The machine will no longer dispense the cleaning fluid due to the trigger assembly not engaging properly with the inlet/outlet on the Clean Water Solution Tank. I have checked and made sure the tank was seated properly.


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My bissell proheat carpet cleaner wont dump water or solution. It will however **** up water and solution if dumped on the carpet. Help I cant clean up doggie pee and it smells in this heat!


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a bissell quickwash 1950-e. I bought it Jan. 2006, and have only used it 8-10 times, I live in a very hard water area, so I though if I put some vinegar in with the cleaning solution it would get rid of any hard water deposits, unfortunatly the solution went lumpy in the tank and stoped spraying out water, I have opened it, hose clean, sprayer not blocked, x at bottom of water container when depresed water trickles out, component that opens the x when water container placed, also ran wate


Hard to say what is causing your problem, replacing the cap and insert on the water tank may help, part #2041111, even tho it may trickle out water when depressed, they can still be bad. The other thing would be the rod not relesing the water like i ... Vacuums

I have an older model F6056-900 Hoover steamvac Spin Scrub Cleaner. My first problem was that I loaned it out to a friend. Anyway she ran over the hose (used for attachments) with her car. I tried using the cleaner for carpet cleaning this morning but when I tried to put the solution tank into place...its loose...won't snap back in like it used to. When I can get it somewhat in place the solution just complete drains out through the bottom fo the tank. The leak is where the small hole on the bot


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover SteamVac is spitting out dirty soultion from the recovery tank, it seems. I have removed the clean solution tank and turned it on to **** up what was soaked into my carpet and it just kept spitting out slowly. When I first turn it on, it spits out a tremendous amount. What could be causing it to spit out solution?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Scooba 5800 "check tank" light always goes on. - I have checked tank. I have cleanout brushes, tank; rinsed, sloshed, dumped. The check tank light comes back on when I want to clean. What should I do now? Pat


... iRobot 5800 Scooba Vacuum

Hoover Steamvac Model C3820 Clean Solution tank leaking


You need some inexpensive parts.\015\012\015\012\015\012\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 ... Hoover C3820 SteamVac Upright Wet/Dry Vacuum

Bissel proheat cleaning solution dumping out


Replace the soap dispenser, the new one will come with a new vavle. Part # 2101785, or just the cap and valve #2101795. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I have a Bissell Proheat 2x Model 9200. The solution goes directly through to the carpet. The tank empties extremely fast even when I am not pushing the button. I have also noticed that I have soap spots on the carpet when pushing the cleaner forward. These spots are not even associated with the cleaning mechanism. I have inspected the cap on the tank, but it seems to be OK. Any suggestions?


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9200 Upright Vacuum

Bissell 1698-1 Solution applicator indicator (red spinner) does not rotate and no solution is being applied even though both the water and cleaning sol'n tanks are full and properly nested.


The heater is blocked wih lime scale ... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum

My machine will not spray the cleaning solution, how does the solution get from the tank?


... Dirt Devil CE6000 Featherlite Wet/Dry Vacuum

My bissell proheat 2x 8920 series will not dispense the cleaning fluid from the little tank. The water sprays out fine and everything else works, it just wont spray out the cleaning solution. Please help!


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Followed directions on filling water and solution tanks. When I use the cleaner the cleaning solution is not being dispensed.


The tubing is clogged, you need to take the tubing off and clean it out or some how force some hot water thru the tubing and clean it out. this happens when you don't run clean water thru thesystem after using the cleaning solution. The solution drie ... Bissell 8910 ProHeat Clear View Upright Vacuum

No suction - dirty solution tank is bone dry; carpet is wet from clean solution. Help! Thanks, Elizabeth P.S this is my second machine, I love them


I will explain:---\015\012ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. 1. TAKE LID OFF OF DWT2. SLIDE THE LITTLE SQUARE PIECE (5'X5'X1) (T ... Vacuums

Cleaning I cannot get the cleaner to release solution on carpet. have lost manual. is there a trick to this? I have tried squeezing trigger handle to dispense solution with no luck. have followed instructions (2 capfuls cleaner, fill with hot water to fill line) on filling tank.


Either you have a pinched or clogged water line, or the rod in the handle is pushing down like it should. The drw back is Bissell has deemed this unit and its parts obsolete. So any parts are hard to find.\015\012\015\012 ... Bissell 1950-3 Quicksteamer Plus Vacuum

Need tank clean water solution tank broke - Vacuums


The hoover web site has service locator go to \015\012\015\012http://www.hoover.com/locator.aspx ... Vacuums

I have a Bissell Proheat Turbo 2x model 9300. It has stopped spraying at the floor. The hand tools will work so I assume this means the problem is at the base somewhere. I cleaned the nozzles but don't know what to try next. It has always had a problem with dumping too much cleaning solution as well, don't know if this is a contributing factor


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Our hoover F7220-900's solution tank's spring came out? Does this mean I have to replace the top clean tank or can I replace the sping?


You will need the valve assembly. as long as the hole that it mounts in is not cracked or broken. ... Hoover F7220900 SteamVac V2 Upright Vacuum

Recovery tank does not fill with water. The lid is tight - there is no where for cleaning or looking for a clog. Worked for two solution tanks then stopped sucking upt he water.


My time is worth more than this... take it back ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Bissell Powersteamer 1695 The cleaning solution tank does not leak until I attach it to the machine. Then the solution pours out , looks like from the fittings where the liquid would go to be pumped out. I bought the used, I wonder if if could be needing a washer/gasket sort of thing?


Hi gownzilla,The solution cap has a spring loaded fitting so that when you put it in upside down, the projection in there in the machine pushes up on the fitting to release the solution when you pull the trigger. It could be that the proj ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0402 seconds