Having problems with your Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum ?

Hoover max extract 60 brushes wont spin - Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum


Answers :

Repair Help & Product Troubleshooting for Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover max extract 60 brushes wont spin - Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Hoover max extract brushes not turning - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover max extract wont suck - Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Hoover max extract hose wont turn off - Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Brand new Hoover Max Extract Deep Cleaner brushes won't turn. Read manual. Checked filters - all clear. Set Spin Scrub Mode Selector to a scrub setting. Brushes still won,t turn. However the brushes on the Spin Scrub hand tool rotate.


... Vacuums

Hoover SteamVac F7222-900 steamvac Brushes do not spin. Looked at filter as per manual instructions but it was free of lint. Need to fix it, help please? Vacuum was used less than 10/12 times


Solution for Hoover SteamVac (F7452-900) brushes not spinning\015\012Uses the turbine model and same solution would be similar. Root cause is simply the main gear attached to turbine becomes stuck. This problem shoul ... Hoover Vacuums

The spin scrub brushes do not spin. - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Try this: Make sure the setting is set to floor, then remove the little window (you might need a flat screwdriver to "pry" it up) and clean off the filter. If there is a blockage, the brushes will not spin! I hope this helps, if so, please give fe ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover max extract 77 water tank leaking - Hoover F5505 SteamVac Spot Vacuum


Remove the little black plastic plug on the bottom of tank (has a metal spring around it), that is where it is leaking. Wrap Teflon (pipe tape) around it and the spring. Replace black plug. Not a permanent fix, but can help if you are on a bind. It w ... Hoover F5505 SteamVac Spot Vacuum

Hoover f7450100 spin brush will not work - Hoover F7431-900 SteamVac Vacuum


... Hoover F7431-900 SteamVac Vacuum

My spin scrub brushes don't spin at all. - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Check that the belt that spins the brushes is not broken, also that the\015\012gear that drives the belt is turning.\015\012\015\012Tom ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

My Hoover Max Extract 77 brushes won't spin. I can't figure out why. I have only used it a half a dozen times!!


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My brushes wont spin and i dont know why - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Your belt has broken and therefore the brush isn't spinning. You can find any vacuum belt at www.vacbelts.com. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brushes are not spinning - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Remove the brushes from the base of the unit by pulling down and unlatching at ends. Is there a drive pin present? The pin will be a 1/4 inch square pin, about two inches long. It engages to the drive mechanism.\015\012\015\012Second: ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brushes don't spin - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


(1) Assure the Brush Control on the hood is NOT set to the OFF position.\015\012(2) Remove the brush assembly by pulling/unlatching it from base on each side.\015\012(3) Does one of the brushes ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The brushes on the unit do not spin. - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Try to clean the filter under the machine or the filter behind the clear plastic, were you see the hypnotic disc sprin that lets you know that the brushes are spinning. To remove : the plastic piece that looks like a triangle, ( were the indicator is ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Scrubber brush does not spin - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


There is a plastic piece on the back of the block brush (spin scrubbers) these wear out or break. You may need to replace the block brush. You can find the parts and a schematic below follow the link. Please don't forget to give positive feedback ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The brushes are not spinning - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Greetings from GoVacuum.com,It sounds as if your brushes are either clogged with debris, or your turbine that drives the brushes have gone bad. The first thing you should check is whether the brush selector knob is turned to the on positi ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

BRUSHES WILL NOT SPIN - Hoover F7220900 SteamVac V2 Upright Vacuum


(1) Assure the Brush Control on the hood is NOT set to the OFF position.\015\012(2) Remove the brush assembly by pulling/unlatching it from base on each side.\015\012(3) Does one of the brushes ... Hoover F7220900 SteamVac V2 Upright Vacuum

My brushes are not spinning - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


You probably have a break in the wiring somewhere or you got water in the motor. if there is a break replace all the wires and solder all the connections, if it still doesn't work start replacing switches and other components. if you got water in th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The brushes on the Hoover F7452-900 SteamVac Upright Vacuum will not spin but everything else seems to work fine. How can I solve this problem?


There is no belt. This unit uses a turbine that uses air off the vacuum motor. There is an actuator arm that moves rearward when you depress the handle release and then lower the handle to use the vacuum. That engages the turbine and spins the brushe ... Hoover F7452-900 SteamVac Upright Vacuum

The brushes will not spin - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The belt maybe broke take a look to see if it is you maybe able to get replacement belt at walmart!!! :) amtnng ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brushes do not spin - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


(1) Assure the Brush Control on the hood is NOT set to the OFF position.\015\012(2) Remove the brush assembly by pulling/unlatching it from base on each side.\015\012(3) Does one of the brushes ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My brushes stopped spinning. What do I do? - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Sounds like the brush belts has snapped and needs replacing, you should be able to get a replacement at most electrical stores, just take the make and model number with you. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brush won't spin - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


It's more than likely that you have to clean the brush and its mounts mainly from hair, but also other dirt. Then it should be fine. You might want to disassemble the piece to get a better access, but only if you are confident, because it's important ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My brushes stopped spinning. what do i do? - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


You simply just need to change your belt. This models uses Hoover belt # 40201160 and can be found at www.vacbelts.com. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1175 seconds