Having problems with your Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum ?

Hoover agility--poor suction, still!

\015 Hello, my agility has poor suction, it probably vacuums up 1/3- 1/2 of the amount of water put out. I have replaced the lower hose (the short one) b/c it had a tear, and that helped a bit, but not much. I've taken apart and checked all the seals, filters...I've basically taken everything apart except the motor! For instance, with the hose attachment, if I place my hand partially over the intake, water actually reverses direction in the hose. The suction coming from the black plastic part attached to the lower hose reminds me of the first cordless model dirt devil--weak, weak-- wouldn't move a penny from half an inch above it. What else can I check? Help! I'd really like to **** up ALL the filthy water instead of leaving half of it to dry on my carpets and upholstery!! One light-colored footstool (that I'd successfully cleaned before) actually had a dingy spot on it after I cleaned it--from the left over water! I'm desperate for your help...\015

Answers :

When you remove the dirty water tank, on the machine, there is a screen that gets clogged and will prevent good suction, is this one clean? If it is, do you feel suction at that screen, if so then there is a problem with the tank. If no suction there, then you will have to check it over for a air leak or a bad seal.
\015\012
\015\01299c831d.jpg\015\012
\015\012f5a2155.jpg
Repair Help & Product Troubleshooting for Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover agility--poor suction, still!


When you remove the dirty water tank, on the machine, there is a screen that gets clogged and will prevent good suction, is this one clean? If it is, do you feel suction at that screen, if so then there is a problem with the tank. If no suction the ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Hi the suction on my dyson hoover has gone very poor. I have cleaned all filters but suction is still pretty poor.Is there anything else i can do?


Yes there is; \015\012Remove the base plate that surrounds your beater bar. There are three large flathead screws on the bottom. Turn these, and rotate the base plate up and towards the fromt (it hinges at the front). Remove the beater bar ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Hoover Portapower hose won't stay on, when it does poor suction.


In reply to the problem you have about the hose not staying attached very well, we had this problem years ago with one of our old cylinder vacs. Sometimes after several years of the hose connector being rotated to attach/remove it from the machine, t ... Hoover Portapower C2094 Bagged Canister Vacuum

No Suction I have a dc18 dyson and it had lost suction from the main hoover and the hose part. If you remove the dust collection part there is suction from the hole behind that part. I have cleaned all part to this hoover but the problem is still there. Any help would be apprieciated. Thanks


Filter removal step 1Turn power off and unplug the machine.\015\012\015\012To remove the washable filter: Rem ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Hoover U5468-900 WindTunnel Supreme suction is suddenly poor


The other possibility is there is a blockage in the foot. these models have dual channel air flow (windtunnel) and become blocked when not cleaned depending on use. under the roller there is a cavity that can be removed for cleaning. a hot motor can ... Hoover U5453-900 WindTunnel Supreme Bagged Upright Vacuum

Suction button Although my Hoover Spin scrub is working perfecting dispensing the solution, when I go to suck up the solution from the carpet--I am having problems with the RED suction button that keeps popping up. I have to stop the cleaner and lift up the dirty water container to break the suction. Ive tried cleaning the netting that is encased around it, but still no luck. Any help would be appreciated! Thanks


This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Poor suction I have a hoover hush s5627 vacuum purchased about 4 years ago from Costco. It's suction power isn't so good anymore. I've checked all the lines & hoses and they're clear and I've changed the bag. I even disconnected the pipe from the vacuum unit and held my hand over the intake. While the machine roars like a jet engine the suction power just ain't like it used to be. What could possibly be the problem?


This vaccuum has a Fan Blade inside connected to the motor that spins to create the suction you feel. After a few years of use (and misuse) the blades on this (plastic) fan will be broken off, thus damaging the unit. These Fans are replaceable if yo ... Vacuums

Low suction I have a Hoover central vacuum system. I've reset the fuse box, checked the fuses, all of the lines are clear and there are no holes for escaped air to travel out. The filter has been cleaned as well. The vac works well with high suction when hooked directly to the unit, however when using any of the indoor connections there is extremely low suction. The machine still turns on so I do not believe it is an electronic issue. I have troubleshooted the issue as best I could and would


... Hoover L2310 GUV Central System Vacuum

Hoover Agility, No Suction!!!


We know the suction hose is cracked and we need to replace it. (1) we cannot find the number to order the part, and (2) there are no instructions in the manual as to how to take the machine apart to replace the hose. Has anyone had any success doin ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Dyson DC14 suction still poor after all cleaning and new pre filter set.


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My henry hoover is stuck in the hi suction function, I have changed the hi-lo rocker switch with a new one, but it still will not alter the power of the suction. Any other suggestions what I can check?


HI I have the same problem, and actually did the same thing to fix it..any ideas yet? please [email protected] ... Henry Numatic "" Canister Vacuum

Poor suction The actual sweeper seems to work ok, but the hose attachment has some suction but not enough to pick up things I think it should and not enough to make the power brush spin. I've checked everywhere I can for clogs, but I can't see anything. And there doesn't seem to be any way to check to hose itself for clogs. I've cleaned out the container and the filters, but there's still a problem.


Check the inlet down by the brush roll, make sure it is open, if it is then the hose itself must have a clog. If the hose comes off, drop something like a marble in one end and see it it comes out the other end, if it doesn't then you have a clog. ... Dirt Devil M1100009 Reaction Soft Touch Cyclonic Upright Vacuum Cleaner Vacuum

I have a Hoover Wind Tunnel Self propelled 12amp. There seems to be very little suction. I have cleaned the hoses and filters but still not much suction. any ideas? thanks.


I have the same problem , and Like the the person who asked the Question ,, there is no Blockage ,, Im thinking maybe these filters have a very short life span ,, and even cleaning theses filters with a brush, etc , may not be enough, and could have ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

I have bought new Hoover bags on two occasions. The first spares I bought were the Xxxl variety and I didn't think they fitted that well. The next spares I bought were the type g megafilt. I still feel like they do not fit that well and the suction power on the vacuum is not as good. I'm I buying the correct replacements? I followed the guidelines on the Hoover bags the vacuum came with. These were printed as the right bags to buy. I only have the vacuum around a year and thought it was brillian


... Bosch BSG71310UC Bagged Canister Vacuum

Hoover Tempo Widepath 12 AMP, poor pick-up and suction. Fantastic suction at the attachment hose though.


Could be blockage in hose,, try straightening out the hose,,and shove a broom handle down there,,,,if there is no bend!! and clear the blockage out. ... Vacuums

My Hoover Tempo lost suction on the floor feature, but there is still suction in the nozzle. This is a very new vacuum-- used maybe 5 times.


Sounds like blockage or belt off between that area and sole plate /Check for blockage... ... Hoover Tempo Widepath Upright Vacuum - Blue

No suction My Hoover Steam Cleaner does not have any suction. We have cleaned, checked belts and filter. Still does not work.


I laid my cleaner down and checked it all out and actually vacumed the insides out (we have a lot of animals at our house) and then put the Recovery tank bank on and it worked fine. ... Hoover F7431-900 SteamVac Vacuum

My Hoover Steam Vac for my rugs works fine, but I don't have any suction when I try to use the hose and attachment for my upholstery. I went over the instructions dozens of times but still no suction.


Which type of hose do you have? One has a duct attached to it that fits into a slot in front of the recovery tak, make sure it is seated all of the way down. The other hooks direct to the machine, is it cracked where it hooks up? You can tell by l ... Vacuums

My Bissell cleanview is NOT suctioning well, all filters, nozzles, attachements, canisters and belts are clean and in good repair. We've pretty much made sure everything that I can get to without completely dismantling the vacuum is super clean and/or new... still poor suction


Did u check the filter above the dirt cup?\015\012\015\012twist the yellow piece and wash the filter ... Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum

No suction i have a hoover supreme wind tunnel vac and its relatively new and the suction, well......sucks. It wont pick anything up! I am extremely frustrated! I picked up a ball of fuzz off the carpet and held it under the vacuum and it still wouldn't **** it up. I then shoved the fuzz up INTO the vacuum. It fell right back out. I may as well not even vacuum. Please help!


I have found more vacuums on the way to the dump because they were full. Check. Is it full?\015\012If not the air way is clogged. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

How do I clean out the suction side of a Hoover steam-vac Model#f6020-900. I took all the screws out and still cant get it apart.I vacuum before using it, but it still seems to find more hair.


These don't come apart. Hoover makes a thin long tool that will allow you to stick up into this suction side to clean it or use a long piece of galvanized metal strip to slide up into it and clear away the hair. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Agility Steam Vac has no suction for the dirty water


Broken suction hose. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Hi. I have a Hoover Wind Tunnel Deluxe vacuum, and the rotating brush does not spin any longer, but still has air suction. Cause ? Sincereley, Teresa T. [email protected]


Could use the model number. Most use a belt, if yours does, then you may need to relace the belt, also check the brush roll. ... Vacuums

BURNING SMELL My DC 07 has suffered from poor suction in the upright position for some time now but this morning it ground to a halt. It was if the motor had burned out. I turned it upside down and some small stones etc tumbled out. I tried switching on again and the motor kicked in but the smell was horrendous so i switched off immediately. If it's likely to be **** inside the motor area i don't no how to access it. I've removed for fixing screws but still unable to prise apart. Is it just the


Hi.\015\012\015\012Try this site http://dysonmanuals.llc.nu/ has service manuals covering removing the Dc07 motor. ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

Hello! The suction in my Dyson animal is very poor. I discovered small holes in the internal hose, but even after a quick duct tape fix, still having issues...sounds like the seal from the canister to the vacuum is leaking air. I know I need a major repair but my mother in law is coming tonight! Any suggestions? ~Lisa


Or you can do this for free:\015\012\015\012http://www.ehow.com/how_5870417_modify-dyson-prefilter-suction.html ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0547 seconds