Having problems with your Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum ?

Hand held hose won't spray

\015 From the day i bought it it has never worked. i've had it a couple of years now. I didn't use the hand hose right away, it was more than a month later. so i couldn't take it back to the store because time had run out for a return. Nearest service center is 50 plus miles away so i never got it in for warranty, (Ramble, ramble). Any way i tore into it and got it apart by dumb luck. I found a switch inside that turns on the water pump, it presurized the line, but i can find no way to get that to happen with all the parts in place and not jamming something in there to have the switch on all the time. What might i be missing? i can't find anything that would cause that switch to come on. even a schematic would be nice but i cant find one aanywhere. thanks for your time\015

Answers :

Hard to determine without seeing it, maybe these drawings will help:
\015\012
\015\012e92ae0b.jpg\015\012
\015\0121176c5a.jpg
Repair Help & Product Troubleshooting for Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hand held hose won't spray


Hard to determine without seeing it, maybe these drawings will help:\015\012\015\012\015\012\015\012 ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

I have a Bissell 1623-1 Steam Cleaner. It will work good for about 2 minutes and then after that it will not dispense cleaning solution on floor or through the hand held wand.I have replaced both drive belts with no improvement. I have cleaned it and found no obstructions in hoses and spray nozzles, put back together and it still will not dispense. Is it possible the pump or solenoid is no working? Aaron


... Bissell 1623 Steam Cleaner

My rug doctor will not spray out water when in the upright cleaning mode but will if im using the hand held hose whith tool


... Vacuums

MY hoover steam vac hand held hose cleaner leaks profusely


Try taking a sharp knife and shaving a little off the edge of the plastic, or a small file if you can get to it, see if it is getting binded. If its getting stuck internally, you will have to replace the switch instead of risking takin it apart. ... Hoover F5810 SteamVac Upright Vacuum

No suction in the hose for the hand held tools at all


Hi I had the same problem and my Hepa filter was clogged. You may wanna check that.\015\012I hope that helps. This is my 4th Windtunnel and I hate this one also. I loved all the rest. ... Hoover U8361-900 WindTunnel 2 Bagless Upright Cyclonic Vacuum

I have a Bissel 9300-C 0714 BC Carpet Shampooer. It was working great and all of a sudden it stopped working. It still sucks up dirty water but it does not spray water onto the carpet. I can get it to spray water through the smallest hand attatchment but not through the large hand held piece on the base of the machine. I really hope you can help me, I am a dog groomer and I really need my machine to work properly. I can get it to spray water out of the smallest hand attatchment but that's all t


The spray jet has become clogged from the soap.... just clean it out. same thing happened to my attachment. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Bissell Proheat cleaner hand cleaner spray but floor cleaner wont


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The unit (9400-3) is not spraying water from the lower deck but will spray from the hand held wand. Checked water levels and water/soap dispenser valves which seem to be working fine. Spray nozzles are not blocked. Where do you look now.


Same problem i have got, spent one day on the bloody thing but of no use, the only solution is to spray water from bucket and use the cleaner to **** it up. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

DC 17 Animal No suction on hand held hose


There is likely a blockage in the pipe. Try pushing something through taking care not to perforate the pipe. ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Floor attachment does not suction, no clog in the hose, hand held works when dettached from floor attachment


Have you checked the floor head? Use a pipe cleaner or twisted metal to carefully and gently see what's in there. It sounds like dirt or something has definately sealed up the main suction channel. ... Vacuums

My hose tools wont pick up. when hose tools unattached suction is fine and will **** my hand fiercely, but once tool attached no suction..... how am i gonna pick up cat hair from seats now?! its a dyson DC04 but it wouldnt let me choose that!


I have a DC04 and the hose tools are a open hole.The only reason they want pick up is they are blocked.If you say they are sucking your hand when not attached.Make sure the hose is not blocked by taking off the cover at the front.Allso check the cyli ... Dyson DC07 Allergy Blue/Turquoise Bagless Upright Cyclonic Vacuum

Hoover steamvac ultra hand tool doesn't spray water from hose - it has steady stream instead of spray


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

The hand-held wand wont slide back into the tube. It wont go down far enough to click in and become the handle again. It was working fine but all of the sudden won't fit back in.


Sounds like the tube has something inside of it that is obstructing the path. veriffy the the "female" end of the tube isnt obstructed, and also, make sure that nothing is bent ( which can happen easily). use a flashlight to shine down into the tubes ... Dyson Ball DC24 Bagless Upright Vacuum

When I try to disconnect the hose in order to use the hand held hose with an attachment, the dust from the bottom flies into the air. How does this opening get blocked off to ensure the dust enters through the attachment and not the bottom?


It is a matter of Physics. It seems like you have it running when you change the hose. ?? That's a no-no.Basically you will have o take it apart until you know how it works or wont work ... Bissell Vacuums

I have a Flex hand held vacuum. It turns on, the motor works, air is blowing out of the side vent very forcefully, but it is not picking up anything with the hose - no suction at all. My hose does not seem to be clogged.


No the hose,, check the filter and compartment behind the filter.. Note if there is air passing through the filter,, or being sucked through it.. If not chances are the extractor fan inside the machine may have broken ou will need to open it up and r ... Black & Decker CHV9600 Handheld Vacuum

My Bissell carpet cleaner will not spray water out the bottom but will spray water out of the hand held thing. What could be the problem and how do I fix it


Hey here is a guide on how to fix your problem.\015\012http://newzealand.bissell.com/images/In ... Vacuums

Dyson all floor vaccum no suction when hand held wand is turned on... doubled checked for cracks in hose -- none took house off unit to check for blockage --- none.. suction works fine when using as normal on floors.


You need to replace the belt that drives the brush on the underneath side of the vacuum. To do this, you need to flip the vacuum over and remove cover plate. There you will find the broken, or stretched out belt. Remove the brush and place the new be ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Hand held piece - the solution doesn't spray out anymore. I have taken it apart to clear any obsticles but still just a few drops come out. It has been several years since we received it as a gift. Any recommendations? -Kevin


Most likely the pump. its red and has a couple of wires attached ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

Water wont spray out of bottom carpet cleaner but will out of the scrubbing hose


First try putting in a little hot water in the water resevoir , let sit for about about 5 mins. then try it. if this doesn't work, flip the machine over and locate the spray jets on the bottom. You'll need a pin or something small enough to clean ou ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The hose does not pick up with the hand held brush, why?


See if hose is clogged ... Dyson DCO3 Absolute Bagless Upright Cyclonic Vacuum

The cleaning solution stopped coming out of the rotating brush but still comes out of the hand held vacuum hose.


If you can check where the vacuum hose where it is connected their might have dirt in the opening to the rotating brush,or it is glogged,clean with a wire and it will be ok ... Bissell SpotBot Robotic Wet/Dry Vacuum

Poor suction I have a hoover hush s5627 vacuum purchased about 4 years ago from Costco. It's suction power isn't so good anymore. I've checked all the lines & hoses and they're clear and I've changed the bag. I even disconnected the pipe from the vacuum unit and held my hand over the intake. While the machine roars like a jet engine the suction power just ain't like it used to be. What could possibly be the problem?


This vaccuum has a Fan Blade inside connected to the motor that spins to create the suction you feel. After a few years of use (and misuse) the blades on this (plastic) fan will be broken off, thus damaging the unit. These Fans are replaceable if yo ... Vacuums

No suction when i switch to the hand tools they spray out but there is no suction hru the hose what can I do?


When you turned the diverter knob, did the gray diverter valve open up? If not, this would be why no suction, it has to be open for the hose and closed to suction from the floor. Alot of times, the valve breaks and won't work. Is the black ovule s ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

The motor is shot on my shark XSH035. can I get the motor replaced - as I prefer the attachable, flexible hose feature for cleaning cornors & creavices and the newer hand-held models do not provide this option.


The motor is available from manufacturer.The manufacturer website is currently not working, here is the website: ... Euro-Pro S3325 Handheld Steam Vacuum

II have the kirby sentria, i have it in canister mode with blower attachment on the hose is on with the hand sprayer attachment the problem is the foam is not coming out the sprayer used it just fine all day went to refill w/ water and cleaner now the foam wont come out whats wrong with it?


Make sure the "straw" is in.See if dust coming out of the hose did not clog the air passages. ... Kirby Heritage II Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0398 seconds