Having problems with your Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum ?

Hoover steam vac dual brushes will not turn.

\015 I have cleaned the filter and the brushes but they still will not turn. I have followed all directions in the manual. Everything else works fine.\015

Answers :

The belt is broken.
Have you tried checking the drive belt?
drive belt is located on the bottom side of the power head ,remove all the Phillips screws from the bottom and pull the plate off . Remove the brush bar by pulling it straight out this will expose the belt. Belt is gray in color, replace belt around the drive pulley and also around the brush bar, align the bar and push back into place, rotate until the belt is centered and reinstall plate and screws.
Repair Help & Product Troubleshooting for Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover Steam Vac Dual V Model F7223-900 brushes will not turn


... Vacuums

Hoover Steam Vac Dual V brushes won't turn


The brushes are driven with air pressure from vacuum motor. The switch merely opens a small door to allow air flow. usually there is a screen that is plugged that stops air flow which stops the brushes from turning. I too only used the appliance once ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

The brushes won't turn on my hoover steam vac dual v


Hi There,\015\012\015\012Unfortunately the answer above is far from helpful. The filter has absolutely nothing to do with your brushes not spinning, and you can really replace the turbine yourself without having to take it into a shop t ... Hoover F7220900 SteamVac V2 Upright Vacuum

Hoover steam vac dual brushes will not turn.


The belt is broken. ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

My brushes wont turn on my f7412900 hoover steam vac dual v


... Hoover Vacuums

Brushes will not turn - Hoover Steam Vac Dual V w/ SpinScrub Vacuum


The turbine which drives the brushes is defective. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover steam vac dual v spin scrub brushes won't turn


... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Brushes aren't turning on Hoover steam vac dual v w Spin Scrub


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Brushes on Hoover steam vac dual v do not turn


(1) Assure the Brush Control on the hood is NOT set to the OFF position.\015\012(2) Remove the brush assembly by pulling/unlatching it from base on each side.\015\012(3) Does one of the brushes ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover Steam Vac Dual VModel #F7430-900 the turbine does not turn


... Hoover F7220900 SteamVac V2 Upright Vacuum

Beater brushes not turning on the wife's Hoover Steam Vac model F5905-900. Found one prior ''solution'' stating that it sounded like the belt was bad. That was my original thought, but on checking schematics and trying to find part numbers at Sears Parts Direct and at Hoover, it does not appear the F5905-900 steam vac HAS any belts to begin with. What's next??


This one I can tell you about from personal experience with that generation Hoover Steam Vac. After using it about 7 or 8 times my brushes stopped turning also.I disassembled it (kind of like disassembling a Chinese puzzle box) and found ... Hoover F5905-900 Vacuum

Hoover dual v brushes won't spin - Hoover Steam Vac Dual V w/ SpinScrub Vacuum


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Brushes wont turn hoover f7412900 steam vac - Hoover SteamVac V2 6-Brush Widepath F7426-900 Vacuum


... Hoover SteamVac V2 6-Brush Widepath F7426-900 Vacuum

Brushes not rotating on my Hoover Steam Vac Dual


The brushes are all connected to a single shaft. This square shaft is connected to 2 sets of gears and then another shaft which is turned by an impeller (suction from the vaccum pump is used to turn the impell and thus the brushes). There are 2 bea ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover F7458900 steam vac brushes won't turn


No, there is a turbine that turns the brushes. You can take the top cover off to get to it, open it up and clean it out and then try it again. If that doesn't work, then replace it, or just replace it to begin with. ... Vacuums

Hoover Steam Vac - Brushes not turned, no suction power


The Brushes not spinning is most likely is caused by seized bearings in the turbine, requiring shop service (easy fix). The suction issue can be caused by the standpipe seal missing or lower recovery tank not on properly, on some models missing front ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My brushes won't turn on my Hoover Steam Vac Cleaner. I have removed them and cleaned them and put them back in and they still won't turn. Any suggestions?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac dual Model # F74310-900 - Brushes won't spin. i've cleaned the little screen per owners manual and still no fix. What else could it be? I can spin the brushes by hand if i remove the assembly.


... Vacuums

HOOVER STEAM VAC DUAL V STEAM CLEANER BRUSHES WONT SPIN


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac v2, brushes won't turn. - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Hello,The Hoover SteamVac's are notorious for \015\012this exact problem. There are several things that can be causing this \015\012probelm.First, what you'll need to do is take the brush block \015\012out of the machine. To d ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Brushes turning slow on Hoover F5881-900 steam vac


There is a part inside called the turbine which needs to be replaced or cleaned. Also clean the brushes. ... Hoover F5881-900 Vacuum

Roatary brushes do not turn on my hoover steam vac dualy


The machine uses an air powered turbine which typically rusts and then locks itself up Ive been able to fix it in the past but its best to replace the whole assembly ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The Brushes don't turn on my Hoover Steam Vac DuetV


CHECK INTERNALLY SOMETHING MIGHT BE BLOCKING THE BRUSHES TO MOVE.CLEAN THAT MANUALLY AND TRY. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Brushes are not rotating is there a belt - Hoover Steam Vac Dual V w/ SpinScrub Vacuum


I had the same problem, on mine there is no belt, the brushes are driven by an air motor. My problem turned out to be one of the motor brushes was completely worn out and the motor was not turning at the proper speed. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Brushes wont turn on hoover steam vac f7431-900


Need replaced TURBINE AND GEAR ASY \015\012part no: 91001097 ... Hoover F7431-900 SteamVac Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0892 seconds