Having problems with your Hoover F7220900 SteamVac V2 Upright Vacuum ?

Our hoover F7220-900's solution tank's spring came out? Does this mean I have to replace the top clean tank or can I replace the sping?

Answers :

You will need the valve assembly. as long as the hole that it mounts in is not cracked or broken.
Repair Help & Product Troubleshooting for Hoover F7220900 SteamVac V2 Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Our hoover F7220-900's solution tank's spring came out? Does this mean I have to replace the top clean tank or can I replace the sping?

You will need the valve assembly. as long as the hole that it mounts in is not cracked or broken. ... Hoover F7220900 SteamVac V2 Upright Vacuum

Hoover spin scrub clean water dispensing tank. How do I replace the spring, seal and valve stem at bottom of clean water tank?

... Hoover SteamVac SpinScrub 50 Carpet Washer with Hard Floor Tool and Accessories

I lost the detergent container on my Hoover Model F7220-900. Its a small plastic bottle that sits on the back of the clean water tank. I called the help desk and they told me that they no longer make that part so I have to pay $55 to replace the whole tank which will come with a detertent container built in. The whole carpet cleaner was only worth about $225 new. I don't feel I should have to pay $55 for a part I don't need but the machine is worthless without it. Any good ideas to solve th

... Hoover F7220900 SteamVac V2 Upright Vacuum

One side of my floormate H3000 dispenses more liquid than the other. How do I fix that? How do I clean the tank from the upper tank to the dispenser on the bottom? I do not have a manual and do not know how the liquid is routed from top to bottom. Thanks

... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Replaced internal pump. Color coded hoses for replacement. Marker has worn off hoses. Need proper routing of hoses from clean water tank, to heater to spray nozzles. An internal schematic of hose routing is preferred.

Hi\015\012\015\012Thanks for using FixYa. Please remove the top cover of your Bissell cleaner. Now place the Auto-Mix selector knob to the water only position. Turn the cover over. You will notice an angle on the ... Vacuums

Empty dirty water tank, replaced it and then started to clean again. It did not **** up the water.

The only reason for no pick up is an air leak. The most likely problem is that the lid is not properly seated on the dirty water tank. A less common problem is that the round rubber seal the tank sits on is out of place. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Kirby Heritage II. Beater bar does not turn. One end rotates freely, but the other sticks, preventing the bar from rotating. No obvious means to disassemble the end of the bar. Is there a way to repair this, or does this require replacement of the beater bar? Did clean the front end assembly, and removed all hair, threads and similar obstructions.

The bearing is bad on the end that turns hard. You will need to purchase a new brush roll assembly. If the roller is older that 4 or 5 years, it should be changed anyway. The brush strips that scrub the carpet loose their strength after many years of ... Vacuums

I have a Vacu-Queen V3000. It stopped in the middle of a job. The plastic housing that sits on the rubber ring at the top of the cannister was sucked part way into the cannister and broke the seal. I cn replace everything but after cleaning the filter it continues to happen. Any ideas how to correct this problem?

... Filter Queen Majestic Canister Vacuum

My Bissell 3920 motor is making a high pitched noise. I have cleared out pet hair from top to bottom. Cleaned the lower filter and replaced the upper filter. I Checked for blockage in the hoses and found none. The filter indicator goes green when I turn it on, but the straining motor noise persists.

Click on the link below to view the replacement motor and fan for your Bissell 3920 vacuum\015\012\015\012http://www.vacuums24x7.com/motorfan.html ... Bissell 3920 Bagless Upright Vacuum

I have Bissell ProHeat 2X 9300-M that I tried to use again today. Is does not dispense solution when turned to Floor Cleaning, when switched to Hose it seems to be working fine. Brushes and suction are working as well. Soap and water containers are full. I took off and replaced tanks, waited to prime the pump multiple times without success. Not sure what is going on.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Need to replace the main belt on my Bissel 1698-P. Can't figure out how to get the belt around the brush roller. Have the top off. Cleaned the water tubes, didn't let the water come down.

Remove belt access door at left front of unit.\015\012\015\012Unplug the unit. Remove the two solution tanks.Remove spray tips from guides.Remove the brush and cog belt by removing the screw from the orange retaining collar.\015\012Remove belt ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

My Bissel proheat carpet cleaner wont spray out of the bottom or the spray handle. I took of the scrub brushes and off and cleaned out the bottom of the machine including popping out the two spray heads to make sure they were not clogged. Put it back together. Still no spray! I also did the turn off, remove fluid containers, replace, turn on for one minute to prime the pump, and still so spray...does this mean my pump is not working?

... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Over heating I have a simplicity canister we can see the dirt by thr inner filter how do we remove the top to clean or replace the inner filter?

TAKE IT TO A DEALER HE WILL HAVE THE PARTS FOR IT ... Simplicity 7850 Premier Bagged Canister Vacuum

No Suction Hoover H3000 floormate does not have enough suction. Brushes and squeegee recently replaced. No Clogs: filter and tank are clean.

The water channel hose could be torn. you can check by removing the lower tank and tilting it backwards, it is located in the lower section. could also be the filter cover. it is needed for full suction control. ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

DYson DC07 not sucking properly when in upright mode. I have tried cleaning out pipes etc and even tried an old motor section I had in garage (replaced once under warranty as kept cutting out and they left old motor section here). Even the old motor section had same prob so this suggests its something in the rest of the vacuum cleaner (whats left after you have lifted off the green motor section and dust collection area if you see what I mean? Any advice weclome please.

Blocked filters ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Looking to replace missisng 8 0z. tank for cleaning solution for Model WS750 Spot Cop

... Singer Vacuums

There is a little red plastic thing that goes into the top of the water reservoir and I took it off to clean the water bag and don't know how to replace it.

It might sound silly but without seeing it the best suggestion i can make is try it in every possible position marking with a sharpie so you know which ways you've tried. sorry i couldnt be of more help ... Vacuums

The detergent container fell off as I removed the full tank from my sink. The top portion of the container broke off and is no longer usable. How and where do I replace it.

Hi!\015\012\015\012You can order that part from the link---\015\012\015\012Hoover parts\015\012\015\012Also you can remove i ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The cap for my upper cleaning solution tank is missing. Can I order a replacement?

The number to order parts is 18003211134 ... Dirt Devil SE2800 Spot Scrubber Handheld Wet/Dry Vacuum

Our problem with our Rainbow E Series is that it has sucked water up and blown it out through the lower part of the hepa filter, making the filter wet and dirty. This had happened before and the repair shop did not see any problems with the machine, so we replaced the filter and were very carful not to overfill the tank and to change the water often. Now it has happened again and ruined another filter. Do you know what could be causing this issue? Can the filter be cleaned or will a new one be

Thank you for allowing\012us to help, please respond with further questions and concerns\012\012Spanish speaking\012available for all problems\012\012 ... Rainbow E series Canister Wet/Dry Vacuum

I have cleaned the filters on my dust buster. The vacuum works for a minute then the battery seems to wear out and the power weakens until it stops. How do I replace the battery on this vacuum? Do I need just one 9.6V battery? What screws do I loosen to insert the battery? I can't find my instruction booklet. Tank you for your help.

... Black & Decker 15.6 Volt DustBuster Vacuum

I need 203-5537 - Bissell 203-5537 QuickSteamer Replacement Clean Solution Tank - Green

You can get all spares from the link belowhttp://www.vacsite.com/en/bissell-parts-1/bissell-parts.html ... Bissell 203-5537 QuickSteamer Replacement Clean Solution Tank - Green

I have a Thane h2o mop ultra, I added some bleach to the water tank to clean better, the unit worked for a while, enough to clean 1 room, then even if the tank is still full of water the steam is not

... Vacuums

Recovery Tank red float disk rising to top when no water is in recovery tank

When you put the filter back on, you must have put it all of the way to the top. There needs to be about a 1/4 in. gap from the top of the filter to the top of the lid. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have the Hoover max Extract 77 and when I'm cleaning the carpet, the clean water tank leaks on the floor, even if I'm not squeezing the trigger. The clean tank doesn't leak when I fill it, but once I place it where it fits and start using the vacuum, the clean water drains out on the floor. The dirty tank fills up, so the suction works, but, I don't know what is going on?

... Hoover Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1033 seconds