Having problems with your Hoover F7220900 SteamVac V2 Upright Vacuum ?

No water/cleaning solution comes out on wash cycle

\015 When I pull the trigger on the wash cycle, no water/cleaning solution comes out. However, the water comes out fine when it is in the rinse position. We cannot find any clogs. When I go to refill the clean water tank, it bubbles up as though there is soap in it, even though there are two separate compartments for clean water and soap.\015

Answers :

With this model, the soap dispensed is controlled by electric solenoids. these can be tricky to troubleshoot. I would take it to your nearest dealer. these solenoids fail, and cause a variety of symptoms.
Repair Help & Product Troubleshooting for Hoover F7220900 SteamVac V2 Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No water/cleaning solution comes out on wash cycle


With this model, the soap dispensed is controlled by electric solenoids. these can be tricky to troubleshoot. I would take it to your nearest dealer. these solenoids fail, and cause a variety of symptoms. ... Hoover F7220900 SteamVac V2 Upright Vacuum

I have a new Hoover Dual V steam vac that I bought from a neighbor who only used it once. I have only used it once since then and it worked great. This time, because I am pregnant, I bought some non-toxic cleaner that was much thicker than the very watery Hoover soap. This vac has a wash option and a rinse option. The rinse option works (sprays and sucks properly), but the wash cycle doesn't at all-neither soap nor water comes out. Nothing comes out, but it still sucks. I took everything o


There's a powerful electric motor attached to a fan that sucks in air.Did you checked and cleaned that motor.If the dirt is got stuck up ion the motor then the motor will not spin as per its regular speed.For rinsing the motor spin on one cycl ... Vacuums

Bissell quick wash no solution coming out


I have exactly the same problem. We have flushed the pipes through put descaler in the area feeding the water solution from the tank and no luck. If anyone can help I'd be very interested. ... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

When we put our spot bot cleaner on automatic the cleaning solution does not come out. The machine goes through all the cycles but the area is completely dry with no solution passing through the brush.


Good afternoon,It sounds like the spray tip may be clogged. This is all referenced in the product/service manual located here: ... Bissell SpotBot Hands-Free Compact Deep Cleaner - Silver

On the wash cycle water doesnt come out - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Water does not dispense on wash cycle


This would be the soap/ water valve. it is stuck closed or isn't opened.( no cure for an non-opened valve, just replace.) ... Hoover F7220900 SteamVac V2 Upright Vacuum

We have a Hover F7411-900 which runs great but for some reason the wash does not dispense the cleaning solution. It works fine on rinse but not on wash. We tried cleaning the round piece at the base of the cleaning solution but that did not fix the problem. How can you repair so that the wash will work.


That would be the wash silonod, the thing that makes the soap and water mix together in order to make the soap come out at the bottom were the brushes are. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Bissell Powerease Lighweight Deep Cleaner. (Shampooer) After I fill the solution tank with the solution and water, I put it in it's slot, but all of the contents just come flowing out. I have only used this machine twice and it worked ok. You are supposed to press the trigger and the solution sprays out and then release the trigger when you want it to stop. But like I said, now I just put the tank on and all the contents come flowing out. I don't know what's wrong or how to stop it.


... Vacuums

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!


Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Bissell Quicksteamer I have a Bissell Quicksteamer that is about 5 years old. I went to use it today and hardly any solution was coming out. I could see it suctioning up what little came out, so I took it apart and cleaned it thoroughly. I tried to use again and no solution is coming out. Everything seems to being working just fine. Thanks


Here's a kinda kick yourself quick fix that might be helpful, I took my whole machine apart all the way to the motor to come to realize that the small rubber piece that cover the tip of the water container was jammed in the hole you sli ... Bissell 1770 Quicksteamer II Upright Vacuum

I have a hoover steamvac dual v and is leaking, bristels not working very food only two are speaning and is not sucking any water Very little solution comes out, or comes out in streaks when pressing the solution dispenser button on the handle. I think the lines may be stopped upped.


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=41020&thid=634728\015\012I have a Hoover SteamVac\015\012Posted by albazo on May 30, 2008\015\012I have a Hoover ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

I have a hoover steam vac LS 3600 and i attached the tool to clean my couch. the tool is sucking but no solution is coming out. i checked the hose and everything looks ok but no solution will come out of the sprayer.


There is a small pump inline of the spray unit. This is normally a coil type reciprocating type and most often this can be dirty or faulty.\012So remove pump and check it on table to see if this works, if not clean or test coils for continuity. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Electrolux ew910t after each washing small amount of water (about 1-2 glasses)appear under washing machine. I have checked both water filling and dump tubes - both are dry during whole washing cycle. Water commes from bottom corner of washer in drops. Do you have any idea what can be the problem? Many thanks, Pavel.


Are your loads spinning even if off balance it will cause the drum to spin off balance and water will come out of the bottom ... Vacuums

Cleaning solution does not come out of the rotating cleaning head or the hand-held nozzle the solution pump seems ok but does not run (electrical continuity check between the two leads on the pump show very low resistance so they seem to be intact) - no dirt or blockage is apparent (it is a very simple device with 1 moving part wires to the pump also pass a continuity check THERE IS NO VOLTAGE on the pump leads from the control circuit board when I turn on the "manual" cleaning mode - a


You can contact Bissell directly at the following\015\012\015\012For UK inquiries:\015\012Monday - Thursday 9 am — 5 pm\015\012Friday 9 am — 4 pm\015\012\015\012BISSELL Homecare (Overseas) Inc ... Bissell SpotBot Robotic Wet/Dry Vacuum

Hoover washing machine error E14 machine does wash cycle then finishes and says e 14 and wont open


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The cleaning solution stopped coming out of the rotating brush but still comes out of the hand held vacuum hose.


If you can check where the vacuum hose where it is connected their might have dirt in the opening to the rotating brush,or it is glogged,clean with a wire and it will be ok ... Bissell SpotBot Robotic Wet/Dry Vacuum

My Hoover Deluxe Hand/mop steam cleaner (H1005) is not working. The light comes on and you can hear the steam generating but nothing comes out of the nozzle. Do you have a solution for me?


... Oreck Sanapathic DMS2000 Handheld Steam Vacuum

Lately we've been having plumbing problems to where our washing machine floods up our bath tub and toilet. And it happens while we have the washing machine on of course. Another problem is that whenever we are taking a shower our tub starts to clog up and water starts pouring out from the bottom of our toilet. We had a plumber come by to root out our pipes just last week and it was fine for about 3 days. And now the problem is back and driving me crazy. WHAT IS WRONG AND HOW CAN I FIX IT??


Possible tree roots best thing is to hire a plumber with a camera snake ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

Wash cycle on model F7226900 does not release water. rinse cycle does.


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Cleaning solution When I press the release button the solution does not come out. What could my problem be?


With mine, the problem was that the drain plug was not being pushed into the solution tank far enough to release the solution. Pushing down on the solution tank while squeezing the trigger in the handle released solution. Since ours is a first gene ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

When i shampoo my carpet, the solution is coming out , but I can't **** up the solution into the tank so therefore the water/solution stays on the carpet. What do I do.. I did one carpet last week and it was fine but not now.


Check to make sure your front panel is installed in the front of the recovery tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

DIRTY WATER THE FRESH WATER AND SOLUTION COMES OUTON TO THE CARPET, BUT NO DIRTY WATER IS COMING INTO THE CANISTER.


Remove the dirty water tank and see if the front nozzle is fitted correctly, also see if the filter is clean on the dirty water tank ... Bissell 1770 Quicksteamer II Upright Vacuum

Replaced the pump for a 9300 M Bissell Proheat 2x as the water solution was not releasing to the carpet. Once rehooked the lines the solution appears to be coming from the water tank and returning to the used tank and bypassing spraying on the carpet. How can I be sure the hoses are hooked up correctly?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

No water comes out when you press the trigger only solution comes out when you turn it on its side


Check the belts. Most models have two belts. The first one from the motor runs both the brushes and the water pump. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

My bissell 2x proheat cleaner is letting out little spray solution when on the floor cleaner setting. If I press the sprayer on the attachment solution comes out of it even when it is not set on the attachment setting what should I do to fix it


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0465 seconds