Having problems with your Hoover F7220900 SteamVac V2 Upright Vacuum ?
Solution will not exit fresh water tank
\015 I have a Hoover Carpet Cleaner model number F7220-900. The solution with not come out of the fresh water tank. The rinse side work OK.\015
The early models of this machine had a pretty ugly defect in the clean water tank. They had all kinds of problems with them and now have a completely different tank to replace the old style. It sounds like you have a defective tank. When the tank sits on the machine, there is a center pin in the tank support that pushes on the tank valve(s) and released the solution into the machine. One of the problems was that the hot water would cause the plastic of the tank to become too plyable and the preassure of the center pin would bend the plastic up and then the valves would not open. You may have to replace your tank. Contact the Hoover company and tell them that you are aware of the many problems they had with this machine and they may make compromises on a replacement tank. Good Luck.
Repair Help & Product Troubleshooting for Hoover F7220900 SteamVac V2 Upright Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Solution will not exit fresh water tank
The early models of this machine had a pretty ugly defect in the clean water tank. They had all kinds of problems with them and now have a completely different tank to replace the old style. It sounds like you have a defective tank. When the tank sit ... Hoover F7220900 SteamVac V2 Upright Vacuum
I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!
Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
Replaced the pump for a 9300 M Bissell Proheat 2x as the water solution was not releasing to the carpet. Once rehooked the lines the solution appears to be coming from the water tank and returning to the used tank and bypassing spraying on the carpet. How can I be sure the hoses are hooked up correctly?
Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
I have a bissell quickwash 1950-e. I bought it Jan. 2006, and have only used it 8-10 times, I live in a very hard water area, so I though if I put some vinegar in with the cleaning solution it would get rid of any hard water deposits, unfortunatly the solution went lumpy in the tank and stoped spraying out water, I have opened it, hose clean, sprayer not blocked, x at bottom of water container when depresed water trickles out, component that opens the x when water container placed, also ran wate
Hard to say what is causing your problem, replacing the cap and insert on the water tank may help, part #2041111, even tho it may trickle out water when depressed, they can still be bad. The other thing would be the rod not relesing the water like i ... Vacuums
Bissell will spray water when set to water rinse, but as soon as it is set to light, normal, or heavy cleaning, there is no spray. I have tried priming but to no avail. I put plain water in the solution tank to test without ay success. It is like it loses it's prime whenever you try to use a solution mix. Once you set it back to water rinse only and go through the priming steps, it is OK. Any help would be appreciated. Thanks.
Please check the following with liquid in both tanks.\012 \012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\012- Check for ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
Picture you sent for me is not the same model as I have mine is a dual vac v carpet cleaner with the solution tank on the side of clean water tank so I need to know how much solution to put in solution resevoir.
The solution tank injects the cleaner depending on the selection you have make such as light or heavy. You fill the tank with cleaning solution. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?
... Bissell 8910 ProHeat Clear View Upright Vacuum
Bissell Powerease Lighweight Deep Cleaner. (Shampooer) After I fill the solution tank with the solution and water, I put it in it's slot, but all of the contents just come flowing out. I have only used this machine twice and it worked ok. You are supposed to press the trigger and the solution sprays out and then release the trigger when you want it to stop. But like I said, now I just put the tank on and all the contents come flowing out. I don't know what's wrong or how to stop it.
I am using my Hoover Steamvac FH5001 for the first time. It worked great until I had to empty the dirty water tank and refill the solution tank. Now it will not spray solution. I have double checked to make sure both tanks are inserted correctly, but to no avail.
Check all o rings to see if they are seated correctl= on the hoses that were disconnected. If not you will not receive suction to spray ... Vacuums
My bissell sprays solution and water but does not **** it back up. After the water and solution are gone the return tank is completely empty
1) check the tank is full of water2)check gasket position,can be worn, or damaged fix it3)check the belt worn for inoperable brushes.4)check motor duct gasket, and test it. yif you notice suction in the duct, remove the tank, for assure i ... Vacuums
Cant locate owners manuel for bissell proheat complete pet 2x does solution go in small tank and hot water in bottom tank ?????where does dirty water collect ??
Recovery tank does not fill with water. The lid is tight - there is no where for cleaning or looking for a clog. Worked for two solution tanks then stopped sucking upt he water.
My time is worth more than this... take it back ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum
Bissell Pro-Heat 7901-1 no cleaning solution is pumped out. The flow indicator is spinning and the belt is spinning the beater bar. Have cleaned the flow indicator, checked vavles in the solution tank and water tank and they are working properly. Also checked the trigger to make sure it works okay. Any ideas?? Moody Fan
Bissell Pro Heat shampooer - Fill the soap dispenser with extremely hot water and shampoo with only water for a few minutes. There is often dried soap in the lines. Make sure that all filters are clean. Press the soap container and the water conta ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
DIRTY WATER THE FRESH WATER AND SOLUTION COMES OUTON TO THE CARPET, BUT NO DIRTY WATER IS COMING INTO THE CANISTER.
Remove the dirty water tank and see if the front nozzle is fitted correctly, also see if the filter is clean on the dirty water tank ... Bissell 1770 Quicksteamer II Upright Vacuum
Cleaner will not dispense the water from the tank. It solution is dispensed but not the water from the blatter. It also picks up water from the carpet.
Check hose for a clog ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum
Water pours from solution tank of Hoover F6020-900
... Hoover F6020-900 SteamVac Upright Vacuum
I have a powersteamer and it does not spray water when I squeeze the trigger. The clean water tank is full, the cleaning solution is full and this is the same problem I had with my last Bissell steam cleaner, which I assumed was just that I had it for a few years, but this cleaner is only over a year old.
Every line has an O Ring at each end. inspect each one by removing the O Ring for nicks and cracks. Lubricate the with Vaseline and reinstall if ok so they will hold the prime to pump and vacuum up Your leaking O rings will draw air causing your p ... Bissell Vacuums
My Bissell ProHeat Upright Carpet Cleaner will not spray water or solution. I have filled the bladder; I have filled the formula tank; I have reseated the tank; and I have turned the unit off and then on again to reprime the trigger. Nothing has worked. Any suggestions?
Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
Followed directions on filling water and solution tanks. When I use the cleaner the cleaning solution is not being dispensed.
The tubing is clogged, you need to take the tubing off and clean it out or some how force some hot water thru the tubing and clean it out. this happens when you don't run clean water thru thesystem after using the cleaning solution. The solution drie ... Bissell 8910 ProHeat Clear View Upright Vacuum
Need tank clean water solution tank broke - Vacuums
The hoover web site has service locator go to \015\012\015\012http://www.hoover.com/locator.aspx ... Vacuums
Cleaner solution in smart mix tank not mixing with the water from the bladder. All tanks are seated properly
... Bissell 1697-7 Powersteamer Pro Deluxe Vacuum
The soap dispenser on my 2X is not dispensing. I wrote with this initial problem and received a reply. We did everything recommended to find a clog. To begin with, we poked holes thru the little holes on the underside with a toothpick. Next we took the machine all apart as directed and cleaned out anything that had accumulated (such as pet hair). Eventually we emptied out the soap dispenser, filled it with a hot salt water solution and let it sit for 10 min. I ran three tanks of hot water
Hello,The solution to your problem is already solved, since your soap dispenser is still under warrant,What i will suggest is that you contact the company that supply you this product and explain everything to them, it is most ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
Water leaking fresh water upper tank leaks all over the place.
Best I can say is to not buy a Hoover product again. This is the second time in just a few months that I have had this problem with this product. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum
Solution tank does not dispense--recovery tank still sucks up dirty water from tile floor on screen porch. I applied cleaner manually with a scrub brush and sucked it up with the hoover steam vac deluxe.
Check to see if the when you squeeze the trigger, the rod is hitting the reservior asm(tank sits on). If not then there is a problem inside the handle and the rod. If it is hitting, then the reservior asm. is bad. Also make sure fluid is coming ou ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
Carpet Cleaner i was cleaning my carpet and it stopped putting out water. I changed the water tank and checked the solution everyhting was fine. what chould I do
Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be o ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum