Having problems with your Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum ?

Hoover SteamVac Dual V Carpet Cleaner # F7410-900

\015 Brushes won't rotate during floor cleaning.\015

Answers :

"I did some research online and the recurrent theme was a bad turbine assembly. Fortunately I was able to fix this myself which took about 2 hours (some reading) and little effort. The problem was with the turbine which is fairly simple and had a bearing that had rusted and froze up. Removing the cover proved to be more difficult than fixing the stuck bearing. This was mostly due to figuring out the correct screws to remove and finally discovering that the back of the cover (over the wheels) is not secured by fasteners but by pegs that "pop" out.

Once I had the brush assembly and Cover removed the turbine came out with the removal of some obvious screws and gently pulling the hoses from the assembly. After carefully opening the assembly housing I discovered the bearing problem and with a little lubrication and some new grease had it working in short order. Putting everything back together was simple as well."
\015\012
\015\012
this worked for me. although once i got in i just had to mess around with the gears and loosen them up. getting in was the hard part soo here you go peoples.
\015\012
\015\012take off tanks
\015\012
\015\012unscrew 6 screws fom underneath machine. look carefully
\015\012
\015\012just underneath where the dirty tank goes right by the part that sucks everything up is a screw. unscrew it
\015\012
\015\012pop off the switch for your spin scrub mode. it pops right back on.
\015\012
\015\012make sure your locks for the tank are turned in
\015\012
\015\012then the back just pops off. you might have to give it a good tug. there are no screws although it maight look like there is.
\015\012
\015\012then pull off the grey part.
\015\012
\015\012once inside it is pretty easy.
\015\012
\015\012but if you have any questionbs email at [email protected]
\015\012
\015\012i took off so many more screws than i needed to to get this figured out so dont do that.
I have the Hoover F7210-900 and experienced the same problem of brushes not turning. It started less than a year after purchase with moderate spot use (keeping up after my new puppy). Since I procrastinated and missed the warrantee window I did some research online and the recurrent theme was a bad turbine assembly. Fortunately I was able to fix this myself which took about 2 hours (some reading) and little effort. The problem was with the turbine which is fairly simple and had a bearing that had rusted and froze up. Removing the cover proved to be more difficult than fixing the stuck bearing. This was mostly due to figuring out the correct screws to remove and finally discovering that the back of the cover (over the wheels) is not secured by fasteners but by pegs that "pop" out.
\015\012
\015\012Once I had the brush assembly and Cover removed the turbine came out with the removal of some obvious screws and gently pulling the hoses from the assembly. After carefully opening the assembly housing I discovered the bearing problem and with a little lubrication and some new grease had it working in short order. Putting everything back together was simple as well.
\015\012
\015\012Now if I can only figure out how to open up the front nozzle so that I can clean out all the dirty carpet fibers!
Repair Help & Product Troubleshooting for Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover SteamVac Dual V Carpet Cleaner # F7410-900


"I did some research online and the recurrent theme was a bad turbine assembly. Fortunately I was able to fix this myself which took about 2 hours (some reading) and little effort. The problem was with the turbine which is fairly simple and had a bea ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Hoover SteamVac Dual V Carpet Cleaner will not dispense when on "Wash"


... Vacuums

I have a Hoover steamvac Dual V carpet cleaner Model No. F7427-900. This is a spin scrub upright. My brushes will not work. We think the white square that the brushes fit up into in the center of the brushs is not turning. Can you help me.


You are on the right track! Place a screwdriver (flatbladed) into the white drive square and try to turn it. If it is locked up the drive assembly is your problem. It is very common for these parts to lock up because of the moisture involved with ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steamvac dual v carpet cleaner F7412-900 will spray water/shampoo when on WASH


... Hoover F7452-900 SteamVac Upright Vacuum

I have a hoover steamvac dual v carpet cleaner it's only maybe 2 weeks old and already the brushes won't spin


One cause is that the recovery tank lid isn't on correctly and not sealing. If there is a foam filter on the inside of the lid, make sure it has a 1/4 in. gap from the top of the lid. There is another filter, from the bottom, it has a red frame, pu ... Hoover Vacuums

Hoover steamvac dual v carpet cleaner problem


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My hand tool won't spray water on my hoover steamvac dual v all terrain carpet and hard floor cleaner


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover SteamVac Dual V Carpet Cleaner just hums when I turn it on


If the motor doesn't run sounds like you either have a bad motor or your motor armature might have gotten wet and created a dead spot.if you have any contact cleaner spray a little on the armature then turn the motor by hand make sure its uuplugged f ... Vacuums

Hoover carpet cleaner not picking up water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover steamvac dual v not dispensing water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a Hoover SteamVac SpinScrub with Clean Surge Carpet Cleaner. I loaned the cleaner to my son, who lives 3 hours away from me. My son returned the Steam Cleaner to me on Easter Sunday. My son failed to return the Owner's Manual. I need to clean my ottoman. I have never used the upholstery & stair cleaning tool. Would you be able to e-mail me the instructions for this chore? My e-mail address is: [email protected] My name is Kay. Thank you!


Hi,I would be glad to send that. But, you never Mention the Model Number and there are Various Models introduced by Hoover.Let me know the Manual and within Few Minutes, i would be able to send you one more email which would h ... Vacuums

HOOVER STEAMVAC Model# F5842-9RM 120v 12 amp Carpet Cleanerworks well. Hooked up upholstrey attachment, used it. Reassembled to standard operation, the aggitator brushes do not work. I dis assembled brush insert verything good. ran cleaner and the square hole that the bushes insert into did not rotate with cleaner on. turned off lightly tried to turn mechinism in machine no luck. Reassembled aganin, reinserted cleaning tool, then disconnected it. agitator still doesn't work. toggled switch


... Hoover Vacuums

Hoover f7411900 brush not spinning - Hoover MaxExtract Dual V Carpet Cleaner F7412900


... Hoover MaxExtract Dual V Carpet Cleaner F7412900

I have an older model F6056-900 Hoover steamvac Spin Scrub Cleaner. My first problem was that I loaned it out to a friend. Anyway she ran over the hose (used for attachments) with her car. I tried using the cleaner for carpet cleaning this morning but when I tried to put the solution tank into place...its loose...won't snap back in like it used to. When I can get it somewhat in place the solution just complete drains out through the bottom fo the tank. The leak is where the small hole on the bot


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brushes on Hoover f7411900 will not rotate - Hoover F7411900 Maxextract Dual V Carpet Cleaner


... Hoover F7411900 Maxextract Dual V Carpet Cleaner

My carpet cleaner will not pick up water. - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Check to make sure that the recovery tank lid is fastened down all of the way around. Also if the foam filter on the bottom of the tank lid, make sure there is at least a 1/4 inch gap from the top of the lid. The wire screen filter is plugged, from ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a hoover spinscrub steamvac carpet cleaner. I was cleaning the carpet when I heard a crack noise then the motor rev's up and the machine immediately loses all suction. Like it lost a belt.


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Have a Hoover Steamvac F7410-900, the brushes don't spin anymore. Can hear the motor running. There is no visible debris and the lint screen is clean. Please HELP! I miss my steam cleaner. Thanx!


Check to see if you can turn the brushes by hand, if not your bearings need service in your turbine assembly.Check aslo for proper suction at the instake standpipe under the lower tank. If it is the turbine, take it to a repair shop. ... Vacuums

Have a hoover steamvac widepath 6000 carpet cleaner. How do I use it?


... Vacuums

HOOVER DUAL STEAM CARPET CLEANER BRUSHES WILL NOT SPIN....MOTOR SOUNDS STRONG...


There are three things to check:\015\012\015\012Is the switch on the hood for brush speed set to full, or may it be set to OFF?\015\012\015\012Remove the brush block from under the unit by pulling it down and unlatch each side ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My brushes on my hoover steamvac all terrain carpet and hard floor cleaner will not spin what do i do


I am not sure if you have the F7222 or F7452 all terran. There is a plastic piece on the back of the block brush (spin scrubbers) these wear out or break. You may need to replace the block brush. You can find the parts below follow the link. P ... Hoover STEAMVAC VACUUM Vacuum

I have a Hoover Steamvac Deluxe model F5853-900 carpet cleaner. I don't have the owners manual. I need to know how to attached the upholstry cleaning attachment.


... Vacuums

How do i hook up my stair cleaner part to my hoover steamvac to clean my carpeted stairs? f5909=900 model


Hi There,I'll be happy to walk you through step by step how you can attach the hose to your Hoover SteamVac.Here are step by step instructions for you:Step 1. To prevent possible leaking, removeclean ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Leaking My new hoover steamvac with clean surge is leaking. As soon as I fill liquid into vaccum cleaner, it leaks withing 2-3 minutes. It makes my whole carpet wet... Sangeet


My machine leaked badly BUT it was my own fault. There is a one-time\015\012only setup procedure where you squeeze the trigger and push the\015\012Clean-Surge button to lock a rod into place. Push the Clean-Surge\015\012button VERY HARD. There will b ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How do I get the handtool to work on my Hoover Steamvac carpet cleaner?


Please reference page 11-12 on this manual:\015\012http://www.hoover.com/pdfs/manuals/F6039900.pdf\015\012\015\012The tools are plugged on ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0834 seconds