Having problems with your Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum ?

IT IS NOT SUCKING WATER OUT? - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Answers :

If the motor is running there are two possibilities for lack of water recovery. The most common problem is that the lid is not squarely seated on the tank. The other is that the rubber seal has fallen off the motor cover suction duct. The seal sits atop a round tube. As viewed from behind, the seal is below the front left corner of the lower tank.
Repair Help & Product Troubleshooting for Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

IT IS NOT SUCKING WATER OUT? - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


If the motor is running there are two possibilities for lack of water recovery. The most common problem is that the lid is not squarely seated on the tank. The other is that the rubber seal has fallen off the motor cover suction duct. The seal sits a ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

It wont **** water up - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Try putting the recovery tank on again. check the filter screen at the bottom by the brushes and in side of the recovery tank screen. worst case, it will be the rubber grament under the recovery tank, to get to it you will have to.... remove the reco ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

On the wash cycle water doesnt come out - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

F6020-900 hoover steamvac widepath manual - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

My upright will not suck the water back up - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. 1. TAKE LID OFF OF DWT2. SLIDE THE LITTLE SQUARE PIECE (5\\'X5\\'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS POSSIBLE AND IF IT ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Replacing belt on Hoover F5915-900 - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Hoover steam vac v2, brushes won't turn. - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Hello,The Hoover SteamVac's are notorious for \015\012this exact problem. There are several things that can be causing this \015\012probelm.First, what you'll need to do is take the brush block \015\012out of the machine. To d ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Attach upholstery cleaner to hoover f5857 - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Need manual to operate - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Brush will not turn - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

The cleaning solution does not come out. - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Our cleaning solution had gotten 'stringy' or 'thready' and clogged the exit. Hubby emptied it, cleaned it thoroughly (with long-handled aquarium brush), and with new bottle of solution it worked fine again. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Steam vac sprays but won't suck up water... - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brushes do not turn - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


The brushes are turning by an air driven turbine. The turbine has a \015\012pivot bushing made of steel inside of it that gets rusty because of the \015\012water that is running through it. The turbine will have to be replaced.\015\012 You can fin ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Brushes don't turn - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


I had the same problem and found a manual online. I never realized that there was a filter in the bottom of the machine. There are 2 red tabs, squeeze them together and pull ( I had to use a pair of pliers to pull). Note which is top and which is bot ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Is not sucking the water back up - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Srub brushes not turning - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


You will find broken belt or something is jamming it ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

How to hook up tool to clean upholstery - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Keep your upholstered furniture looking fresh by vacuuming it regularly\012with the upholstery tool attached to your vacuum's hose. Prevent the\012fabric from fading (or at least delay this) by keeping your furniture\012out of direct sunlight -- clos ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Brushes donot turn when asked to shampoo - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


The brushes are turning by an air driven turbine. The turbine has a \015\012pivot bushing made of steel inside of it that gets rusty because of the \015\012water that is running through it. The turbine will have to be replaced. You can find a genu ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Brushes do not spin and not sucking up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My spin scrub brushes don't spin at all. - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Check that the belt that spins the brushes is not broken, also that the\015\012gear that drives the belt is turning.\015\012\015\012Tom ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Hoover SteamVac Plus 1200 upright hot water extractor Water/carpet cleaner applying o.k. Suction on the "floor" does not work. Suction on the hand tool works somewhat, but water is not collecting in the bucket. There is suction coming from the floor but water is not going into the bucket. It does not appear to be clogged because I can feel with my hand that air is flowing from the floor. The water is not being sucked into the bucket.


... Hoover Vacuums

My hoover steam vac is not sucking up water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My steam VAC upright wont **** up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common and simple problem with these involves the recovery tank. Take it off, remove the cover and check to be sure it fits snugly. All tabs must be locked front AND back. If this machine has tools you have to hook up in order to use you ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover spin scrub not giving water out - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Using a Hoover Steamvac to clean my carpets. It works fine in some areas, but others it makes a clicking noise and stops sucking water. Once I turn the vacuum off and wait a few seconds, it clicks once more and is okay to use again. Certain parts of my carpet this happens so frequently I can't vacuum.


1)clog in the hose or air/tank full you must , need replace or emptied,test the belt for broken or worn.2) noises can be area motor , test for fan blade defective or broken3) You must go http://hoover.com/support/video-instruction-guides/ for ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1292 seconds