Having problems with your Hoover F7431-900 SteamVac Vacuum ?

Having trouble i have a hoover steamvac f5815...i cannot figure out how to **** the water back up into the reserve tank... any advice?


Answers :

Still no HELP> does it help that i am cute and quite stacked? I am so kidding
Check that the attachment lid is closed properly and the rubber seal is still intact. This needs to be closed or you will lose suction. As above, check the recovery lid is sealed all the way round, it's easy to think it is when it isn't. Make sure all the clips are in place at the back and the front clips closed.
Repair Help & Product Troubleshooting for Hoover F7431-900 SteamVac Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Having trouble i have a hoover steamvac f5815...i cannot figure out how to **** the water back up into the reserve tank... any advice?


Still no HELP> does it help that i am cute and quite stacked? I am so kidding ... Hoover F7431-900 SteamVac Vacuum

Bissell ProHeat 2X - I removed the clean water tank bladder and now I can't figure out how to attach the insert from the bottom of the tank so I can put it back together. Any ideas? Make sense? :)


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Brushes won't turn on the bissell proheat 2X steam cleaner-I don't have the manual to see if there is a button I am not pushing to turn on the brushes. Also, do you put the clean water in the "bladder" in the tank? Sorry I am so dumb-this cleaner was given to me with no manual and I can't figure it out. There is a small tank on the bottom at the back of the machine, that says "formula here" and I don't know if that is where the cleaner goes or what that is for. The machine turns on just fine


... Bissell 8910 ProHeat Clear View Upright Vacuum

The panel came off of my SteamVac water tank, and I can't figure out how to get it back in! HELP!


I think that you mean the little white/grey/sometimes clear panel that fits on the dirty water tank. \015\012\015\012Remove the lid of the dirty water tank, and slide it down the front of the machine to the clear housing below. It will on ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Cant figure out how to get the water to suck up into the reserve tank


... Hoover F5832-910 SteamVac Supreme Vacuum

Dear Sir: I just purchased a Bissell Rug Shampooer at a garage sale. The only thing I find for a model is on the back and it says Model 1695 there. Nothing on front. It is Navy blue and has a grey tank on it with a smaller one inserted at bottom of the large tank. It has two switches on the back of it and the trigger switch at the handle. The cleaner works, BUT, it does not extract any water back into the tank that is to pick up the dirty water. Could you suggest what I may look at t


... Bissell Vacuums

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm


I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Bissel proheat 7901 carpet cleaner and it is not sucking the water up. Normally when I clean the water gets sucked back up and I have to empty the dirty tank. Now no water is in the tank when I am done cleaning. Please help I cannot afford to take it to the shop.


I'm not sure if this will help but I had the same problem and was about ready to pull my hair out. I ended up taking the fill tank off and if you look inside where the red overflow flap is you will find a small screened opening. I found that mine w ... Vacuums

My Kirby shampooer - G4 - hardly used any water from the tank and no suds at all. Pet hair did blow out of the small slotted holes in the tray as I moved the shampooer back and forth, but the carpet was basically dry. I did vacuum before shampooing, so the brush part seemed to work great during shampooing, but no water! The small screen was stuck in the crook of the hose that attached to the tank so I did get that out and put it on the small hole on the tank, but it didn't make any difference. I


Few things:Make sure the sponge and the valve under the sponge (water tank) is clean.Make sure you follow the instructions (f you do not have the manual you can find one ... Kirby Ultimate G Bagged Upright Vacuum

Bissell Proheat - I need the manual - how do I get the water container back into the machine? I took out the tank and filled it up with water but I cannot get it back in. I need a manual or a picture of how to do it. thank you, ruth


Http://www.bissell.com/images/UserGuides/7950_1204.indd.pdf ... Vacuums

Bissell will spray water when set to water rinse, but as soon as it is set to light, normal, or heavy cleaning, there is no spray. I have tried priming but to no avail. I put plain water in the solution tank to test without ay success. It is like it loses it's prime whenever you try to use a solution mix. Once you set it back to water rinse only and go through the priming steps, it is OK. Any help would be appreciated. Thanks.


Please check the following with liquid in both tanks.\012 \012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\012- Check for ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water leak I just bought this steamer a few days ago, and already I am having problems, when I fill the water tank that your suppost to fill the water runs out before I even turn the machine on. I have tried using plugs to keep it from doing this just so I can shampoo my carpet, this seems to work to a point, considering the fact that there are two holes underneath close to the brushes and one just a little ways back from that location. Do you know if this is something that should have plugs or


If you just pruchased this, then it is under warranty, take it along with proof of purchase to a warranty repair shop and have them fix it. If water just runs out, then there may be a seal missing or a water line off. ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?


... Bissell 8910 ProHeat Clear View Upright Vacuum

My bissell sprays solution and water but does not **** it back up. After the water and solution are gone the return tank is completely empty


1) check the tank is full of water2)check gasket position,can be worn, or damaged fix it3)check the belt worn for inoperable brushes.4)check motor duct gasket, and test it. yif you notice suction in the duct, remove the tank, for assure i ... Vacuums

Vapor Clean TR 5 Under "maintenance" they told me to unscrew to empty refill tank. After doing that, no water came out and the piece that the scew went into is now in the tank. It is too large to get out and even if you put the screw back inti that piece ir still goes into the machine. Can I still use the machine? brand new only uded it once


I is really needed to check this with the manufacturer! See contact details below: ... Vacuums

Bissel spot bot water not coming out of tank is not a year old and tried manual wand and the water doesn't come out there either. any advice. Is not a year old yet.


You could take the end of the handle off 2 screws i think check the line for a clog or just take it to a bissell service center it will be covered under warranty ... Bissell SpotBot Robotic Wet/Dry Vacuum

No dirty water in the collection tank. It sucks up the water, but it seems to be leaking back out


... Bissell 2X Proheat 9200 rug cleaner

Lost manual last time i used the upholstery tool and i think i forgot to put a part back on...from the floor head to the recovery tank the water comes up but i have a gap there...the water won't suck up off the floor...


Send your email address to [email protected] I found the pdf manual file for this unitl ... Hoover F5906-900 Upright Steam Vacuum

Steam vac won't vacuum water back up from carpet well - 1/2 of upper tank emptied on carpet and only 2 Tbsp. in lower tank retrieved. What can I do?


Is that float stuck up stopping the suction? ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac not sucking water back up i have super wet floors and no water in recovery tank


I think it is the gasket on top and bottom of the plastic chanel that takes the water up to the dirty water holding tank , Part of the rubber gasket is missing on both the top and bottom. This will alow \015\012air to come in and thus you loo ... Hoover F6020-900 SteamVac Upright Vacuum

I have a tear in the hose of my old model # F6030-900 unit which doesn.t allow water from the attachment to **** back into dirty water bucket. The model #F6039-900 is the same model # but different year I understand. The tear is at the bottom where set the recovery tank in the lay down position and can look in the unit at the bend of the hose.


You will have to replace the hose asm. You can order online at: \015\012http://vacuumsuperstore.com/F6019.html\015\012\015\012H-90001334 (43 ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hover F7452-900 My brushes are not turning. I have taken the tanks off to check the switch that changes from carpet to hard terrain to Ceramic tile.I noticed that there is a spring that has came off. I tried to disassemble the top half (nose) of the cleaner but I have came to a stand still. I cannot figure out how to remove the cover so I can figure out where the spring should be attached. I have removed all the screws that are visible and it still won't budge. It is loose but on the back side o


Regarding the brushes not turning:\015\012\015\012Your filter may need to be cleaned. It is located behind your brushes. With your tanks removed and the cleaner unplugged; tilt your cleaner back. The filter screen located behind your b ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

The tank lid isn't sealing to the machine, leaving a gap between the lid and machine and therefore not drawing the water back into the tank


Your missing the gasket. ... Bissell Powersteamer 1694 Upright Vacuum

I lost the detergent container on my Hoover Model F7220-900. Its a small plastic bottle that sits on the back of the clean water tank. I called the help desk and they told me that they no longer make that part so I have to pay $55 to replace the whole tank which will come with a detertent container built in. The whole carpet cleaner was only worth about $225 new. I don't feel I should have to pay $55 for a part I don't need but the machine is worthless without it. Any good ideas to solve th


... Hoover F7220900 SteamVac V2 Upright Vacuum

I left dirty water in my Scooba for two days. Now the tank smells bad and there is a green film in it. Any ideas how to clean it or does it have to be serviced? Thanks for any advice (except not forge


... iRobot 5800 Scooba Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0540 seconds