Having problems with your Hoover F7458-900 Upright Vacuum ?

Hoover Steam Vac Clean Water Streams from Unit

\015 My Hoover F6025900 just streams clean water to the carpet whether it is turned on or off. I have inspected the unit for poor o-rings and seals and this is not the case. The clean water tank does not have any problems unit after it sits in the unit, then without using the control lever, the water streams out like I am in ''rinse'' cycle whether it is on or not.\015\012\015\012I may be wrong but it appears that the solution and water are gravity fed until it reaches an area where electrically it turns it off and on. I just cannot locate that area.\015\012\015\012Thanks.\015

Answers :

Hello there,

Are you certain on the model number of your Hoover vacuum, I can't seem to find any reference to that anywhere online.

Either way, I am familiar with these steam cleaning type vacuums. The electrical control for the spray portion is located in the actual base of the unit, below where the water / solution sits. It is actually very complicated to take this portion apart and attempt a manual repair without extensive knowledge of the vacuum system. It is very easy to damage the unit further without thorough knowledge of the electrical systems in the vacuum. You would be much better off taking it to a local service center. On Monday I would give Hoover a call at 1-800-944-9200 and they can direct you to the nearest location that is certified to work on Hoover vacuums.

Repair Help & Product Troubleshooting for Hoover F7458-900 Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover Steam Vac Clean Water Streams from Unit

Hello there, Are you certain on the model number of your Hoover vacuum, I can't seem to find any reference to that anywhere online.Either way, I am familiar with these steam cleaning type vacuums. The electrical control for t ... Hoover F7458-900 Upright Vacuum

Hoover Steam Vac clean water tank valve leaks

A) make sure that there is not a place for a stair attachment. If\015\012there is make sure air is not leaking through where the attachment goes\015\012on because of damaged or misplaced fitting.\015\012\015\012b) some steam ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Soap and water will not come down for cleaning carpet Unit has only been used once before where it worked fine. Hoover Steam Vac F5915 900.

Either the pump is not pumping water, or a hose is kinked, or the jets are clogged and need to be cleaned with a paper-clip ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover steam vac dual v clean water and detergent tank leaks water before attached to the vac and during cleaning

This is a common problem with the earlier models which had a separate soap tank glued to the clean water tank. The plastic was too thin beneath the valve on the clean water side and would develop cracks. You most likely will need a new one piece tank ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Can't find info for hoover steam vac spin scrub model # F5905900 on Hoover website, doesn't show that model number at all...looking for mesh (kind of cone/cylinder shape) that goes in dirty water tank (I think) and also the tool (wand) that slides into front to clean it out. It doesn't pull all the water up very well and the filter has been missing for some time. I don't know if that has anything to do with it or not. As far as the wand tool goes, I have taken the cover off at this point and

The cleanout tool is part # 43514001. The filter is # 90001398. Be sure to leave a 1/2 inch gap between the top of the filter and the bottom of the lid. If you need a manual, try model F5914-900 0r F5912-900 on Hoover.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Took my Hoover Steam Vac apart to clean it and now it won't **** up the water but was working fine before I got the bright idea to clean it. Took four screws out but did not touch the motor. It puts out water and the brushes rotate but no suction? Thank you for your help, Cathy

The suction is created by the motor and is pulled to the motor through the flexible hose. The hose could have pulled off at one end or it could have torn in a spot where there is more pull on the hose like when you lay the handle down to empty dirty ... Hoover F7431-900 SteamVac Vacuum

Hoover Steam Vac V2 Deep Cleaner leaking clean water

Fill the tank and determine if the plastic is leaking, or if the valves are leaking. if the tank is cracked, it would need replaced. There is an improved design now available.\015\012\015\012You may cycle the valves on the bottom with t ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover steam vac clean water reservoir leaking.

Take the clean water tank out and look on the bottom for a fitting that screws on make sure its tight.also inside of that fitting trhere should be a washer or an oring to keep it from leaking.if thats not the problem then your pump mightbe leaking.fo ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Clean Water Leaking from Hoover Steam Vac

... Hoover F5826-900 SteamVac Upright Wet Washer

I'm using a steam vac for the first time, i wanted to know if the bottom piece that you empty out the dirty water has to have water in to use it. or is it suppose to be empty?it's an upright hoover steamvac for heavy traffic areas and spot cleaning

Hello,\012The bottom piece should be empty when you use your machine. Make sure you rinse it our real good when you are finished.I hope this helps. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

The unit is a hoover steam vac LS 3600. the unit will put the cleaning solution down but will not vacum it up off the carpet.

... Hoover Vacuums

I just bought a hoover steam vac model F5914900 and the clean water tank is leaking. I tried pressing the clean surge button and the trigger button that was suggested by someone else but it won't

Go to Hoover.com and find a local Service Station. They will replace it at no charge. MUST be a warranty location to get it free. Take your sales slip with you. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Water pours out from the clean water tank,there is a plastic type pin that the tank sits on and i'm not sure if there was some sort of washer on it that is not there now. Its a Hoover Steam vac, model # F5875-900 Thanks for your help.

The hose is off tilt the handle back you will see it running down into the base ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Using my hoover steam vac tonight and too much water coming out. once it's turned on, water and shampoo continuously come out underneath until tanks are empty. looks to be leaking from left side bottom as looking at it standing behind the unit

Make sure that you have filled everthing properly and the hoover steam is in a good condition. or check else is there any loose coonections in the bottom of the hoover, which makes the tank empty.if the problem persists take it to service. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

My Hoover steam vac is not spraying the water. Instead it is ejecting 5 streams. This is a new probolem and in the several years I have used it I haven't had this problem before. I can find nothing in the manual that explains it or "fixes" it;

There is a filter screen under the plastic cover below the brush indicator. If it is dirty clean it. The solution pump works off of vacuum. If this screen is dirty then the pump does not work correctly. Funny, the manual says nothing about this, only ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac won't spray water while cleaning

... Hoover F5858-910 SteamVac Vacuum


... Vacuums

I own a Hoover Steam Vac V2 deep cleaner with Auto Rinse feature. The Model Number is not available ex: was on the bottom of the machine and the sticker is completely worn off the machine. I am having a problem with the bottle you fill with detergent ex: this bottle is seperate from the main clean water tank. THE PROBLEM: The little plastic part that goes in the bottom of the bottle has an "O" ring ex: cone shaped with a spring.....it keeps falling out. Can you supply a part number for this

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=641300\015\012Generic problem for all Vacuums\015\012I own a Hoover Steam\015\012Posted by w_brennan on ... Vacuums

Parts replacement We have a Hoover Steam Vac that has a broken part #10 in your picture or Part # 37271035. Does this part cover the whole top section of the Vac? Is it hard to replace? Where can you get the best prices on Hoover parts? I have been on Hoovers website and they don't even recognize this Steam Vac. which is hard to believe they don't even recognize their own unit? Thanks Ray

This the hood or top cover. There some screws on the bottom as well as on the top, then it comes off. ... Vacuums

My Hoover Steam Vac Spin Scrub aw/ Clean Surge

Greetings,\015\012\015\012A few more things that you can try on your SteamVac. First remove the dirty water solution tank from the machine completely. You should see where the solution tank was just sitting, a plastic casing with a wh ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover Steam Vac Spin Scrub aw/ Clean Surge

... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a hoover 3000 i have not used in awhile, and since I removed a large rug, I would like to use it again on my slate floor. HOWEVER, I cannot get it to pick up ANY water in the water recovery unit......it is dry, dry, dry. I have put in a new filter, cleaned the nozzle unit, the scrubber , and reconnected both the recovery unit and the water unit several times, but to no avail. I would like to get a graut attachment a well as replacement part, but since I can't get the basic unit to work, I

Have you made sure the plastic filter cover with the round hole in it that covers the filter is in place ( part # 59177096 ). This piece seems to get lost, and without it there is no pick-up. The other common problem is that the wheel assembly has be ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover steam vac spin scrub leaking cleaning solution

The hose leading from the tank to the sprayer head on the bottom of the unit, or the tank is not seated properly or the tank has a hole or crack ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Agility Steam Vac has no suction for the dirty water

Broken suction hose. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Hoover steam vac, brushes won't rotate, have cleaned filter by brushes, removed brushes and they rotate okay when off steam vac, tried to ajust level for carpet cleaning and brushes still don't move

There are three things to check when experiencing 'no spin' on the cleaning brushes. 1) Check the small pull out filter screen under the machine. It must stay clean for air to pass to the turbine which powers the brushes. 2) Check that the long shaft ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1378 seconds