Having problems with your Hoover FloorMate Hard Floor Cleaner - FH40010B ?

How to fix clog on hoover floormate fh40010?

\015 Cleaning fluid does not dispense\015

Answers :

I was having the same issue with my NEW just out of box Hoover FH40010. First run on the floor was great then the water/cleaner stopped dispensing!!! I found that when is assembled it out of the box I did not have the handle "plugged-in" properly!! I reattached it to where there is NO gap in the handle when pushed firmly into place and locked in the base. WATER SOLUTION NOW WORKS PERFECTLY!!!
Repair Help & Product Troubleshooting for Hoover FloorMate Hard Floor Cleaner - FH40010B

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to fix clog on hoover floormate fh40010?


I was having the same issue with my NEW just out of box Hoover FH40010. First run on the floor was great then the water/cleaner stopped dispensing!!! I found that when is assembled it out of the box I did not have the handle "plugged-in" properly!! ... Hoover FloorMate Hard Floor Cleaner - FH40010B

Hoover floormate FH40010 trigger problems - Hoover FloorMate SpinScrub Hard Floor Cleaner, FH40010


... Hoover FloorMate SpinScrub Hard Floor Cleaner, FH40010

Hoover F5809 Hello, I seen a few of your post and was hoping you could help me. I just became a member today. My sister gave me her old Hoover Steam Vac-Model F5809. This thing is so dirty and clogged because my sister has pets. So far I've gotten it all taken apart to clean it. I'm not a newbie and taking apart and fixing things. I have fixed things like microwaves, washers, dryers, dishwashers (still learning about TV's-very hard, hehe). Anyway, I got what I believe to be the motor cover off.


That cover is the called the fan cover and is usually pressed on. Tapping on the edge with a flat blade, you may be able to get it off and hope you don't bend it up, you will to put it back on tight enough so it will stay in place. Another thing to ... Vacuums

Hoover Floormate clogged water line - Hoover Floormate H3000 Upright Wet/Dry Vacuum


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

Model number f 5912-900 hoover steam vav with clean surge.This is not the f5914 model........my new machine has 10 min. on it...in mid use it has stopped sucking and now is blowing more than anything, I took the front clear piece off as well as the black cowling/shroud and can find no obvious hoses to un-clog nor anything else to un-clog for that matter...I am looking for advise to fix this thing now, myself


Here is a list to go by for no suction problems that you can follow along with they are common proble\015\012Problem #1 Steamvac is not Sucking!If your Hoover Steamvac was working properly and suddenly it is not sucking any ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How do you remove the handle on a Hoover floormate fh40010


... Hoover Vacuums

My Hoover SteamVac has been doing a wonderful job but in two instances, after emptying the dirty water and reattaching the reservoir, the machine has lost suction. The first time I was able to make it work again after taking it apart and putting it back together about 10 times. I don't know what I did that fixed it but as long as it worked again, I was happy. But it's happened again and I can't get it to vacuum. I can see that it isn't clogged. Can you please help me????


Look for the lower tank filter to be clean. also make sure the lower tank lid is on properly. latch when installed on machine. Make sure the front panel duct is on the lower tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover Mach 5 model number u5194-900 series ZF12.O will vacuum for about 15-10 min then it shuts its self off and will not turn back on., I have cleaned out all the hoses, filters and cleaned off brush. What can I do to fix this so that it will **** into the chamber. The hoses get clogged and it doesn't appear to be sucking into the "bag area"


... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

Hoover floormate h3000 w/spinbrush will not dispense the cleaning solution how can i fix


The hot glue trick will work; but what you probably need to do is gently push down on the black pin from inside the tank. This will lower the solution release mechanism and the solution will dispense. I found this solution on this website and it to ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

No Suction Hoover H3000 floormate does not have enough suction. Brushes and squeegee recently replaced. No Clogs: filter and tank are clean.


The water channel hose could be torn. you can check by removing the lower tank and tilting it backwards, it is located in the lower section. could also be the filter cover. it is needed for full suction control. ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My hoover floormate h3060 has not been used for some time, when I went to use it, it would not dispense the cleaner..The last time I used it, I used a mixture of amonia and borax. I think the hose is clogged. What should I do??


You most likely have either a clogged screen at the bottom of the fill tank or the jets that spray fluid are clogged. You can unscrew them and power a paper clip through them. If the hoses are by chance clogged which doesn't happen often, Pull one of ... Hoover H3060 FloorMate SpinScrub 800 Upright Wet/Dry Vacuum

Hoover floormate model FH40010 brushes don't spin


Here is the manual > http://hoover.com/file/597/ ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover upright 2000w, HL2005 001 problems:the hoover made a pop sound & turned off. Tried leaving it for 30 mins as suggested in the manual but it still won turn on. Really cannot afford to buy a new 1 & would like to fix it. partner is an electrician so if we have some guidance as to what the problem may be i am confident we can fix it. the hoover is only 18 months old so not very old at all.


... Vacuums

Hoover floormate spin brushes will not lower - Hoover Floormate H3000 Upright Wet/Dry Vacuum


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover 3010 FloorMate Plus not dispensing liquid


With the tank off, can you see if the rod in the handle is hitting the spot where the tank sits on, if not then there is a problem in the handle. If it is, then the reservior asm may be bad, it is what the tank sits on. ... Hoover H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum

My hoover floormate will not dispense water - Hoover Floormate H3000 Upright Wet/Dry Vacuum


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover floormate Hi, I'm not sure what the model number is on my Hoover Floormate, but I can't get the cleaning liquid to dispense. The vacuum(dry pickup works fine). The handle squeezes without a problem. It used to work without a problem and then I didn't use it for awhile. When I came back to it, it wasn't working. Thanks, Alissa


The tank sits on what is called the reservior asm. it is actuated by the control rod inside the handle. With the tank off, watch and see if you can see that rod hitting the reservior asm when you squeeze the trigger. If it is moving up and down on ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover Floormate Does anyone know how to remove the handle on the Hoover floormate? I need to repack and return it. Thanks


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover floormate won't turn on - Hoover Floormate H3000 Upright Wet/Dry Vacuum


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover Floormate--Does not pick up water. - Hoover Floormate H3000 Upright Wet/Dry Vacuum


First make sure that you are getting suction from the bottom of he machine. Most of the time the squeegee is worn out which does not allow it to pick up the water like it use to. Turn over the machine and inspect \015\012the squeegee. If it looks ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover floormate handle release pedal broken. Need diy repair information.


... Hoover Vacuums

Hoover FloorMate will not dispense cleaning solution


... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My hoover floormate leaks continuously


Go to Lowes or Home Depot and buy a No. 6 o-ring. It goes over the nipple which connects to the detergent reservoir. ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My hoover deep cleaner is clogged


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0469 seconds