Having problems with your Hoover S3765-040 WindTunnel Bagless Canister Vacuum ?
Cord rewind hoover s3765
\015 Cord rewind hoover s3765 stuck pulled out wont go back\015
Remove the 5 Phillips-head screws carefully without stripping the heads. There are 2 at the front bottom, 2 at the top back (above the wheels), and 1 at the back beneath the dustbin. After the screws are loosened/removed, you can remove the top cover of the vacuum (be careful with the attached wiring harness). Then remove the black plastic cover over the cord rewind wheel, and you can easily remove the wheel. Pull the cord out a bit to give yourself some slack. You should be able to free the jammed cord and then reassemble the vac.
I would take the unit to a local repair shop one with free estimates, sometime they just get locked up. could be a cheap fix. However if not they should be able to give a repair cost and if it's to much simply shop around worst case your not out any $$$$ good luck..
Repair Help & Product Troubleshooting for Hoover S3765-040 WindTunnel Bagless Canister Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
THE ELECTRICAL CORD DOES NOT REWIND COMPLETELY ... WHEN REWINDING IT LEAVES ~ 3FT OUT OF THE CANISTER ... I have cleaned the cord & made certain that the cord is not kinked or twistedc
I have the same problem but i dont know how to open it i see no screws only the rubber band that goes around it unless theres a way how to do it ... Kenmore Magic Blue 24195 Bagged Canister Vacuum
The cord on my electrolux Epic 6500 has been pulled too far out and will not rewind. How can I access the cord reel to rewind?
There are two keys holding the body together, underneath the bumpers on the side of the vac. With the bag door open these keys when gripped with pliers will slide forward to release the body panels. Before opening the vac, gently push the ... Electrolux Epic 6500 Vacuum
The cord rewind button for my electrolux vacuum cleaner is stuck so it always rewind the cord. how to fix it?
... Electrolux Vacuums
Bosch canister vac BSG81313. Took cover off to remove lots of hair, dirt etc from running without bag in place. Everything went back together OK, but cord reel spring went zip when cover was removed. How do I rewind the spring so there is tension when the cord is pulled out ? Wound cord back onto reel, but reel just clicks ever revolution etc...no tension when cord is pulled out of vac. Bob
The spring inside the hub of the cord wheel has escaped from the locking tab. You must completely dismantle the vacuum to access the cord wheel - take it out, reattach the spring and reassemble the unit. All you need is a phillips screwdriver, a pai ... Vacuums
Cord rewind The power cord is jammed and won't go in or out. I can't find a way to get the cover off to have a look at it. Any suggestions please? Power cord jammed won't go in or out. Can comeone tell me how to undo the casing to get to the power cord?
Which model do you have.. ... Vacuums
Cord won't rewind on Hoover Deluxe Elite Rewind vacuum
Cord rewinder on a Electrolux model C102J vacum cleaner
Hi there Johnd, SmartAlec from Nelsonvacuums.com.au here. I fix vacuums full time for a living and the first time i had this problem with the australian version of this vac ... Electrolux EL7055A Bagless Canister Vacuum
Hoover UH70120 WindTunnel TSeries problems with the cord. im a tech savy guy and have been trying to fix a cord after it was pulled to far out and now wont auto retract, but just cant find a way to pull the cord rewind mechanism out to work on it. Any advice
You will probably have to replace the cord winding mechanism. I have never had any luck trying to repair one. Cord retracters are great when they work but it seems like they always go bad before too long. On many units you can't even replace the cord ... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner
Hi , I have replaced the electric cord on Electrolux Lux Royal vacuum , but the rewind that retracts the cord does not pull it in . The coil spring looks ok but it will not pull the cord back in , any suggestions please . Thanks Dave Ryder
Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=564353\015\012Generic problem for all Vacuums\015\012Hi, I have replaced\015\012Posted by dryder on May 02, 2008 ... Vacuums
Problem with cord rewinding mechanism on my Nilfisk King!Whilst repairing broken cord(successfully)the metal coil thats part of that mechanism sprang out!Can someone out there tell me how to put it back together again PLEASE.I would so like my cord to be able to retract again
Vacuum won't start unless I press down on the cord rewind area
... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner
Automatic Cord Rewinder is not rewinding anymore
I had the same problem - the power cord for my Hoover Elite Upright (U5507900) was stuck a few inches out and wouldn't go any further. But when I unscrewed the rewinding mechanism, the cord had clearly gotten twisted and partly buried under itself s ... Hoover Elite Rewind Bagless Upright VacuumVacuum
Automatic power cord rewind on Hoover S3630 vacuum is veru weak
... Hoover S3630 WindTunnel Bagged Canister Vacuum
Barrel Dyson DC08 Origin cord rewind button is stuck.
... Dyson Vacuums
S444i just would not switch on. When I took it apart I sprung the rewind coil on the cord retracter and I can't get it back together. Now I have 2 problems!! It won't start and the rewinder
... Miele Vacuums
I have a Hoover Deluxe Elite Rewind w lifetime Hepa filter and automatic rewind cord 24ft. but recently it is not vaccuming as sufficent as it did last time used, which is once per week. I do not see where anything is clogged, please advise..
Make sure the hose is installed in the foot when using for the floor. check the belt. when working properly, you should see dirt spin in the dirt cup. ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum
I'm trying to replace the power cord on my Hoover Telios vacuum cleaner. I have the machine open on the floor, but can't work out how to find the terminals on the cord rewind reel - they seem
... Hoover Telios Canister Vac Vacuum
Cord doesn't rewind - Eureka AirSpeed Rewind Cyclonic Bagless Upright
... Eureka AirSpeed Rewind Cyclonic Bagless Upright
Cord rewind The power cord is jammed and won't go in or out. I can't find a way to get the cover off to have a look at it. Any suggestions please?
A bit late for the original questioner, but perhaps this will help someone else.\015\012\015\012There are many models of the Hoover Telios. This solution applies to the T5603 at least, but perhaps not to all models... sorry, I don't know about ... Hoover S3330 / S3332 Straight Suction Telios Bagged Canister Vacuum
Can,t make my rewind cord-rewind --How do you take the back off???????.SOOOOO------I can check the problem----need respond ASAP!!!!!!!!
This is a tricky job and will require a new winder mechanism. Take it to a repair shop and ask for a quote. ... Vacuums
Hoover windtunnel cord rewind stuck
... Hoover UH70120 WindTunnel TSeries Rewind Bagless Upright Vacuum Cleaner
How to replace cord rewind on model 116.29319800
... Kenmore Vacuums
Hoover rewind cord stuck
... Hoover WindTunnel Pet Rewind Upright Vacuum
Pwr cord rewind reel
You have to pop the grey button off for the cord rewind. There is one more screw under there. You have to be very careful, because you can break one of the tabs that hold the button on. In fact, it is almost a garuntee. There are three tabs that stic ... Hoover S1361 Bagged Canister Vacuum
Cord rewind nonoperational
Sounds like the spring is either over stretched or broken. you may have to have the spring replaced ... Bosch BSG71360UC Bagged Canister Vacuum