Having problems with your hoover steam vac dual v ?

why is my steam vac leaking cleaning solution

I bought a new part for it and it still leaking.

Answers :

Repair Help & Product Troubleshooting for hoover steam vac dual v

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover steam vac spin scrub leaking cleaning solution


The hose leading from the tank to the sprayer head on the bottom of the unit, or the tank is not seated properly or the tank has a hole or crack ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My steam vac leaks cleaning solution from the bottom


Where the water tanks fits into the body there is a valve that is suppose to keep the solution in place until the trigger is pulled. That valve has gone bad and will need to be replaced. To replace it, take the tank off, pop off the body handle hou ... Hoover F5872-900 SteamVac Wet/Dry Vacuum

Leaking Solution Tank/Seal Install - Hoover Steam Vac


Not sure this will help, but we have a Hoover Steamvac F5843 and our valve seal seemed to have shrunk so the tank was leaking. Bought a new seal and had the same problem. How to install? There weren't any instructions or pictures of the part(s) invol ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Steam Vac clean water tank valve leaks


A) make sure that there is not a place for a stair attachment. If\015\012there is make sure air is not leaking through where the attachment goes\015\012on because of damaged or misplaced fitting.\015\012\015\012b) some steam ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My Hoover steam vac dual v clean water and detergent tank leaks water before attached to the vac and during cleaning


This is a common problem with the earlier models which had a separate soap tank glued to the clean water tank. The plastic was too thin beneath the valve on the clean water side and would develop cracks. You most likely will need a new one piece tank ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover steam vac clean water reservoir leaking.


Take the clean water tank out and look on the bottom for a fitting that screws on make sure its tight.also inside of that fitting trhere should be a washer or an oring to keep it from leaking.if thats not the problem then your pump mightbe leaking.fo ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Steam Vac V2 Deep Cleaner leaking clean water


Fill the tank and determine if the plastic is leaking, or if the valves are leaking. if the tank is cracked, it would need replaced. There is an improved design now available.\015\012\015\012You may cycle the valves on the bottom with t ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Routing of cleaning solution hoses on hoover steam vac


... Hoover Vacuums

Instructions on how & how much cleaning solution on steam vac


Http://www.hoover.com/pdfs/manuals/F5914900.pdf ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brushes on Hoover Steam Vac F7441-980 do not turn.Brush control on;drive pin present;filter intake clean; Drive mechanism doesn't appear to be turning. Also when spraying on cleaning solution, spray comes out in streeks rather than the width of nozzle. JBB


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a hoover steam vac LS 3600 and i attached the tool to clean my couch. the tool is sucking but no solution is coming out. i checked the hose and everything looks ok but no solution will come out of the sprayer.


There is a small pump inline of the spray unit. This is normally a coil type reciprocating type and most often this can be dirty or faulty.\012So remove pump and check it on table to see if this works, if not clean or test coils for continuity. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I just bought a hoover steam vac model F5914900 and the clean water tank is leaking. I tried pressing the clean surge button and the trigger button that was suggested by someone else but it won't


Go to Hoover.com and find a local Service Station. They will replace it at no charge. MUST be a warranty location to get it free. Take your sales slip with you. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Steamvac The last several times that I have used the steam vac to clean the carpet, I've noticed that the solution is not coming out as a spray. Instead it is a steam. Is this normal or is something wrong? Thanks for your help..


You might try running a solution of vinegar and water thru it to clean out the lines and spray nozzles. Also are the brushes turning when you are using it, that could also be the problem. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover steam vac model 7210-900 problem: when i install canister of cleaning solution it immediately starts flowing out of the outlets where the brushes are located. any idea on solution to thisproblem?


Http://hoover.com/support/video-instruction-guides/ and see the video respectively according with your model, use the common sense for troubleshooting.God bles ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Clean Water Leaking from Hoover Steam Vac


... Hoover F5826-900 SteamVac Upright Wet Washer

Steam vac When the cleaning solution is despened it is coming out in a stream not in a spray. Is this normal or is something wrong? Thanks for your help..


Either the nozzles are clogged, or the brush block is not turning. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Cannot find out where to buy the cleaning solution that comes with the Hoover steam vac. Live in Bend, OR.


You dont have to use the hoover stuff,run down to your local home depot and by the zep brand it cost cheaper cleans better and youll get more for your money ... Hoover Vacuums

My Steam Vac F59149 will not vacuum up the cleaning solution. I have checked the usual culprits. The dirty water tank is empty, the yellow float is not up too high. This is a relatively new appliance, so the way for the water is not blocked, there is just no suction. The warm air is blowing, the brushes are spinning. What next?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I HAVE A BISSEL 5200 FLIP IT AND WHEN CLEAN WATER TANK IS ON THE MACHINE AND IT IS BEING USED AS DRY VAC ALL THE SOLUTION LEAKS OUT. I TRIED TIGHTENING THE CAP , I CHECKED FOR CROSS THREADING , I HAVE TRIED EVERYTHING I COULD THINK OF THAT IT COULD BE NOTHING FIXED IT. MY FRIEND HAS ONE AS WELL AND HERS DOES THE SAME THING. IS IT A MANUFACTUER DEFECT?


Yes, they pretty much all leak, that can be chalked up to lousy manufacturing. Sorry. ... Vacuums

The unit is a hoover steam vac LS 3600. the unit will put the cleaning solution down but will not vacum it up off the carpet.


... Hoover Vacuums

My brand new Hoover Steam Vac SpinScrub leaks from the bottom as soon as I insert the clean tank.


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Need instructions for filling the Hoover Steam Vac Spot with cleaning solutions


Hi There,Here's a link to the owners manual for your Hoover F5505 Steam Cleaner that will explain step by step how you can add water & cleaning solutions and carpet shampoo. I hope that this was helpful to you. If it did help you, ... Hoover F5505 SteamVac Spot Vacuum

My Hoover steam vac spin scrub will not suction up the cleaning solution . Why is there no suction?


P{margin-top:0px; margin-bottom:0px;}\015\012Hello, Thank you for your recent e-mail. I am sorry to read about the problem that you are having with your cleaner. Please make sure your recovery tank and lid are installed correctly and ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac, brushes won't rotate, have cleaned filter by brushes, removed brushes and they rotate okay when off steam vac, tried to ajust level for carpet cleaning and brushes still don't move


There are three things to check when experiencing 'no spin' on the cleaning brushes. 1) Check the small pull out filter screen under the machine. It must stay clean for air to pass to the turbine which powers the brushes. 2) Check that the long shaft ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0798 seconds