Having problems with your Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum ?
Leaking solution tank / m/n f5881-900
\015 After installing filled solution tank onto scrubber unit, the solution drains out the bottom of sweeper.disassembled entire unit. checked all hoses,\015\012valves,manifolds,fan and all connections and found no obvious problems.\015\012all other functions seem to work properly. thank you\015
Check th reservior unit, part #43516008, is the solution tank seal that sits on top of the reservior unit ok and in the right position? Is the control rod, inside the handle releasing when yuou release the trigger? Are the hoses attached to the reservior unit. May have to replace the reservior unit. Also check the valve at the bottom of the tank to make sure it isn't stuck open. Push it and see if it comes back down. Here is a picture that may help:
Repair Help & Product Troubleshooting for Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Leaking solution tank / m/n f5881-900
Check th reservior unit, part #43516008, is the solution tank seal that sits on top of the reservior unit ok and in the right position? Is the control rod, inside the handle releasing when yuou release the trigger? Are the hoses attached to the res ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum
I have a hoover F5915-900. Today when I got it our to use it I noticed that it was leaking. I did some troubleshooting, but not sure where to go from here. The solution tank leaks out if the recovery tank is connected also. If I remove the recovery tank and leave the solution tank on it does not leak. Any suggestions would be appreciated.
It dont shamppoo my carpet dont come out or **** it up the hose for funture workes good no sham pooer for rugs ... Hoover F5915910 Upright Steam Cleaner
I have an older model F6056-900 Hoover steamvac Spin Scrub Cleaner. My first problem was that I loaned it out to a friend. Anyway she ran over the hose (used for attachments) with her car. I tried using the cleaner for carpet cleaning this morning but when I tried to put the solution tank into place...its loose...won't snap back in like it used to. When I can get it somewhat in place the solution just complete drains out through the bottom fo the tank. The leak is where the small hole on the bot
... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
Hoover Steamvac Model C3820 Clean Solution tank leaking
You need some inexpensive parts.\015\012\015\012\015\012\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 ... Hoover C3820 SteamVac Upright Wet/Dry Vacuum
Bissell Powersteamer 1695 The cleaning solution tank does not leak until I attach it to the machine. Then the solution pours out , looks like from the fittings where the liquid would go to be pumped out. I bought the used, I wonder if if could be needing a washer/gasket sort of thing?
Hi gownzilla,The solution cap has a spring loaded fitting so that when you put it in upside down, the projection in there in the machine pushes up on the fitting to release the solution when you pull the trigger. It could be that the proj ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum
Hoover steamvac dual v w/autorinse widepath model f7245900 leaks cleaning solution on bottom of tank when filling
... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
I HAVE A BISSEL 5200 FLIP IT AND WHEN CLEAN WATER TANK IS ON THE MACHINE AND IT IS BEING USED AS DRY VAC ALL THE SOLUTION LEAKS OUT. I TRIED TIGHTENING THE CAP , I CHECKED FOR CROSS THREADING , I HAVE TRIED EVERYTHING I COULD THINK OF THAT IT COULD BE NOTHING FIXED IT. MY FRIEND HAS ONE AS WELL AND HERS DOES THE SAME THING. IS IT A MANUFACTUER DEFECT?
Yes, they pretty much all leak, that can be chalked up to lousy manufacturing. Sorry. ... Vacuums
I have a Bissell proheat 2x and it leaks water around the wheel area and drains the solution tank quickly.
Check to see if the seal came off the tank and stuck in the dock ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!
Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
Leaking Solution Tank/Seal Install - Hoover Steam Vac
Not sure this will help, but we have a Hoover Steamvac F5843 and our valve seal seemed to have shrunk so the tank was leaking. Bought a new seal and had the same problem. How to install? There weren't any instructions or pictures of the part(s) invol ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
Leaking tank After I put the water in the tank and put the tank in its spot, water leaks from the bottom of the tank. Also from the detergent tank.
(1) Does water or chemical leak from the tank when filled, but before it is installed? If not, then the tank is OK.\015\012(2) If the tank is not properly aligned to the lower handle when assembled and latched, the black rubber seals on the ha ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
Water pours from solution tank of Hoover F6020-900
... Hoover F6020-900 SteamVac Upright Vacuum
My steamvac leaks from the clean water tank
Try to look for small holes or cracks and even the tank.use clamps to make sure your hose is firmly attached. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum
Picture you sent for me is not the same model as I have mine is a dual vac v carpet cleaner with the solution tank on the side of clean water tank so I need to know how much solution to put in solution resevoir.
The solution tank injects the cleaner depending on the selection you have make such as light or heavy. You fill the tank with cleaning solution. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
Hoover steamvac when I use it it leaks out of bottom. when it off an water in tank leaks out of bottom,when its off an I pull the triggar it flows big time out of bottom. tank doesnt leak when off sitting with water in it
Let me start out with an apology. I did not ask my question very well - and you did not answer it as I needed.\015\012If you wish, we MAY be able to communicate in your native language. We can do most indian languages, Turkish, Ukranian and s ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
I am using my Hoover Steamvac FH5001 for the first time. It worked great until I had to empty the dirty water tank and refill the solution tank. Now it will not spray solution. I have double checked to make sure both tanks are inserted correctly, but to no avail.
Check all o rings to see if they are seated correctl= on the hoses that were disconnected. If not you will not receive suction to spray ... Vacuums
I have the Hoover max Extract 77 and when I'm cleaning the carpet, the clean water tank leaks on the floor, even if I'm not squeezing the trigger. The clean tank doesn't leak when I fill it, but once I place it where it fits and start using the vacuum, the clean water drains out on the floor. The dirty tank fills up, so the suction works, but, I don't know what is going on?
... Hoover Vacuums
Bissell Powerease Lighweight Deep Cleaner. (Shampooer) After I fill the solution tank with the solution and water, I put it in it's slot, but all of the contents just come flowing out. I have only used this machine twice and it worked ok. You are supposed to press the trigger and the solution sprays out and then release the trigger when you want it to stop. But like I said, now I just put the tank on and all the contents come flowing out. I don't know what's wrong or how to stop it.
Cleaning solution leaks
It could be the lid on the container. If it isnt lined up absolutely perfect it tends to leak. You could make it tighter with a bit of ptfe tape. As these containers go into the machine lid down this is here mine leaks if Im not very careful. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum
Leaking clean water solution. Hoover Steamvac Duo Deepcleaner.
... Hoover F5520 SteamVac Duo Upright Wet Washer
Hoover steam vac leak from the bottom when tank has water in it when not running but tank is not leaking
The tank is not sealing to the black rubber ring seal on the lower handle. make sure this seal is not displaced. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum
Replaced the pump for a 9300 M Bissell Proheat 2x as the water solution was not releasing to the carpet. Once rehooked the lines the solution appears to be coming from the water tank and returning to the used tank and bypassing spraying on the carpet. How can I be sure the hoses are hooked up correctly?
Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
Bissell Pro-Heat 7901-1 no cleaning solution is pumped out. The flow indicator is spinning and the belt is spinning the beater bar. Have cleaned the flow indicator, checked vavles in the solution tank and water tank and they are working properly. Also checked the trigger to make sure it works okay. Any ideas?? Moody Fan
Bissell Pro Heat shampooer - Fill the soap dispenser with extremely hot water and shampoo with only water for a few minutes. There is often dried soap in the lines. Make sure that all filters are clean. Press the soap container and the water conta ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
Water tank valve is leaking out of the bottom of the tank. The water leaks on the floor.
It could be a cheap fix. There should be a rubber o ring that's worn or ate away by chemicals.\015\012I'm hoping the tank isn't cracked.\015\012Remove o ring. Contact repair place. O ring shouldn't be more than 5.00. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum
My Hoover SteamVac is spitting out dirty soultion from the recovery tank, it seems. I have removed the clean solution tank and turned it on to **** up what was soaked into my carpet and it just kept spitting out slowly. When I first turn it on, it spits out a tremendous amount. What could be causing it to spit out solution?
... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum