Having problems with your Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum ?

I just put a new turbine on my steam cvleaner hoover of coarse, and when I pull the trigger in wash nothing happens. In rinse it's all right

Answers :

When you squeeze the trigger a cable is pulled which opens a small valve in the dispenser tank. Remove the tank and detach the valve. Soak the valve in clean warm water for an hour or 2 and reassemble. That should fix the problem.
Hi, the most common problem is going to be that you have a blockage this is a very common problem with this type of vac, now the blockage is usually caused by the cleaning solution turning to gel somewhere between the bottle and the jets where it comes out at the front of the vac.

The first thing you should try is tip the vac onto its back and look at the jets you need to get a small pin and poke it into each of these holes to remove any blockage, after doing this turn the vac upright then switch it on and give it a try, you may need to hold the button down for 2min or so to get the detergent to work its way through the pipes.

If after doing that you still have nothing coming out then the next best thing to try is empty all the cleaning sollution out of the vac and then fill this with hot not boiling water then let the vac stand for about 5 to 10 min then switch it on and give it another try for couple of minutes.

If after doing that it still dont work then this means your going to have to find the blockage now the most likely place for blockage is where the pipe meets the jets so you need to remove the bottom of the vac where the jets are and have a good look and see where the water is blocked now to remove this blockage you can just squeeze the pipe to force the blockage out, after doing this fill it back up with fresh hot water, you could also put a table spoon of salt in to break down any gel build up then give it another try for couple of minutes, this should now have solved your problem.

Let me know how you get on or if you need further assistance ok
Repair Help & Product Troubleshooting for Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I just put a new turbine on my steam cvleaner hoover of coarse, and when I pull the trigger in wash nothing happens. In rinse it's all right

When you squeeze the trigger a cable is pulled which opens a small valve in the dispenser tank. Remove the tank and detach the valve. Soak the valve in clean warm water for an hour or 2 and reassemble. That should fix the problem. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Won't spray. . .nothing happens when pull trigger. . .pump belt is ok. ..

I assume you've changed the flat belt and it's working o.k. So, the next thing to check is the bucket seat. When the bucket is set down into the machine, the bucket valve is opened by the center pin on the receiver in the floor of the machine. You sh ... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a dyson dc16 and when i pull the trigger all three lights come on but nothing happens from that point?

It needs charging . and if the lights dont light when you put it in the charger somthing is wrong with charger or battery ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have a new Hoover Dual V steam vac that I bought from a neighbor who only used it once. I have only used it once since then and it worked great. This time, because I am pregnant, I bought some non-toxic cleaner that was much thicker than the very watery Hoover soap. This vac has a wash option and a rinse option. The rinse option works (sprays and sucks properly), but the wash cycle doesn't at all-neither soap nor water comes out. Nothing comes out, but it still sucks. I took everything o

There's a powerful electric motor attached to a fan that sucks in air.Did you checked and cleaned that motor.If the dirt is got stuck up ion the motor then the motor will not spin as per its regular speed.For rinsing the motor spin on one cycl ... Vacuums

My Bissell model 8910 pro heat will pump solution or water for like the first couple times you pull the trigger as you can see the mixture window spinning. After that it stops spinning and nothing else will come out until you turn the machine off, and restart. Then again same process works for a couple trigger pulls then quits.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a Kenmore DuraPower Dual Cyclone Action 12 Amp that just randomly stopped right in the middle of vacuuming. I assumed the plug had come out of the wall so I went to check and this wasn't the issue. I tried multiple outlets and that wasn't the issue. I made sure nothing was stuck and there is nothing stuck. Nothing happens when I press the red "ON" button. What could this be? Thanks!

... Kenmore Vacuums

Producing steam i just got the shark assembled the mv2010, then it is not doing anything, it vacuumed just fine, but when i put the steam pad on it wouldnt ever produce steam or do anything,it felt like the water was heating up but even after it sat for 20-30 minutes when i pull handle back towards me nothing happens, no lights no steam no nothing, so why wont it work

This link is for the manualhttp://www.sharkclean.com/manual/MV2010_11_IB_ENG_110103.pdf ... Shark MV2010 Vac-Then-Steam 2-in-1 Vacuum and Steam Mop Purple

Shampooer I have a rainbow e series and my shampooer is not working. The tubes do not seem to be clogged and it sounds like it is trying to work but we cant get the water to come out. We pull the trigger and nothing no soap, no water, nothing. Can anyone help?

Aqua mates have an o-ringed valve assembly that go bad regularly reccoment having it replaced by local vac shop ... Rainbow E series Canister Wet/Dry Vacuum

I got a Dyson DC16 handheld cordless. Nothing happens when I press the trigger. When I take the canister off, I try and move the black "fan" thing but it won't budge. Should It move? How do I get the motor out?

Hi you have to take all the switch to bits which allows the cable to be free so you can get the motor out which is still tricky but i dont think this is the problem i think this dyson is a bad design its got printed circuits in that could be the prob ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

When i pull the trigger to spray solution onto the carpet nothing comes out. But it does work when i use the spot treat attachment.

... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Dc31 won't turn on. Battery is good condition. pull trigger and nothing.

... Dyson DC31 Bagless Handheld Vacuum

Hoover Savvy The red light for the dirt finder is on when pushing forward and the green light is on when pulling it back. This happens all the time. It's like the dirt finder sensor isn't working right. It seems to be picking up good and we keep the filter clean.

Does this happen at both Dirt Finder Sensitivity settings? ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

I bought a new Bush MP2200BUK 2GB MP3 Player today and havent a clue how to download music from my laptop to my mp3 player and donw know if i have installed it right nothing is happening and dont know if i can download music from my frostwire (music download)

Does anybody know where i can get a new front cover for my 8gb bush mp3 player ... Vacuums

When in the wash mode it does nothing, but the rinse works just fine. what do I need to do. I have cleaned this also. Hoover F7220-900 steam vac v2

There are two possible causes:\015\012\015\012(1) defective switch in handle (not likely), or\015\012\015\012(2) defective electric solution valve in the base of the unit that switches the solution dispense ON and OFF. This r ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not

Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

This is the first time I'm using my Mr Coffee Frappe maker and after plugging in the machine and pushing the power button, nothing happens. Should the red light come on right away?

Yes you should get some kind of power indicated that power is on the machine i would first check the circuit breaker and then assure that you have power coming out of the outlet after which you could then use a multimeter to folow where you do have p ... Vacuums

I have a Miele S318i canister Vacuum clean and when i turn it on nothing happens if i pull on the extension cord there is intermittent contact and the motor runs sporadically.

... Miele S318 Bagged Canister Vacuum

I have a Rainbow Aqua Mate II and have it all hooked up but water will not come out of the white tank. I am using the trigger but nothing is happening.

It sometimes takes a good soaking with water in the tank for a while. Maby a Week or longer, and it also takes a little running time. Not more than 10 minutes at a time, then cool for 30 minutes inbetween runnings, for the water to pump out of them. ... Rainbow E series Canister Wet/Dry Vacuum

Hoover steam vac..F7452-900. not working in wash-auto rinse mode

It is not the pump. If it sprays on rinse the pump is fine. An easy test is to plug in the accessory hose and the spray nozzle hose. If it shoots liquid, there is no pump problem.You have a bad solenoid. There are two solenoids that control water ... Hoover F7452-900 SteamVac Upright Vacuum

My dyson dc 16 hand held vacume stops & starts while in use, each time you pull the trigger it will start again but then stops after a short while untill i pull the trigger again.

Cutting out can be due to a few things , motor overheating due to dirty filter, Faulty mains cable or plug..sealed type also..Faulty Switch/trigger.May need to seek pro help to fix. ... Vacuums

Henry hoover Hi all, I bought a spares/ repairs Henry on ebay having been told there was no cable rewind and believing that since I had a spare one in the shed it would be an easy fix. However, poor Henry had his cable replaced to find when plugged in, he tries to start but nothing happens. The motor turns once and just cuts out. If you turn it on and off again it happens again. One whir and turn of the motor, then nothing. It blew the fuses out in the kitchen first time too, so could it be a re

Hi it can be the connector at the end of the Henry cable inside the cable rewind unit happened to us! ... Numatic Henry Bagged Canister Vacuum

I am trying to disassemble a electrolux 2100. I have looked at instructions given by Chemist 1961 and others. On the side, I have removed the rubber covers over the plastic rails but I can't remove the plastic rails that hold the rubber covers on. If I am right, these rails should just slide right out and the outer casing should come part.....or am I doing something wrong. I have pulled and pulled the rails and they don't budge. The rear end won't pop off. Help!

There's a tab at the back of the rail that needs to be released. Turn the vacuum on it's side, slip the tip of a standard screwdrive into the space between the rail and the back of the vacuum, and tap lightly with a hammer. Tap toward the front of ... Electrolux Lux 5500 Canister Vacuum

Steam doesn't come out anymore when I pull the trigger. I think the water in the tank is getting hot, but when I pull the trigger, only a little water comes out. No steam

Try putting some white vinegar in the tank to dissolve any hard water deposits. You should use only distilled water in this machine. Don't try to clean anything with the vinegar in it, but take it outside to run the vinegar through. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Brookstone Wet/Dry handheld vacuum. When I toggle the switch on or off, nothing happens. If I leave it on the charger and do this, nothing happens (so I don't think it's the battery). It seems like it's a few years old, but I can't be sure as I got it for free from someone's yard sale leftovers. They didn't have an option for "Brookstone" in the product selection, so I just chose the first one.

I realize this is an old post, but I also picked up the same item & \012have the same problem. Anyone know the fix? It's a Brookstone \012SKU#411884. I purchased it in an auction, brand new in the box. The \012filter is clean and shows no sign of ... AEG Vacuums

I was vacuuming and noticed that the bag needed changing. the red light with the ! inside the triangle also came on. When the bag was changed, the vacuum would not restart. The red light came on. Tried the reset button but nothing happened. Tried unplugging and re-plugging in and nothing happened. Replaced all the filters and still it wouldh't start. So I brought it downstairs and tried one more time to get it to start. it worked! Is there something wrong with the vacuum cleaner? Was it overheat

It was overheated that is why it worked downstairs after cooling off. ... Miele S548 Bagged Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0569 seconds