Having problems with your Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum ?

Why is there no water collection in the dirty water holder?


Answers :

First make sure the unit is dispensing water, if so then check to make sure the lis on the lower tank is snapped on properly and that the front duct panel is installed. the front panel duct MUST be installed for floor operation to extract the solution from the floor.
Repair Help & Product Troubleshooting for Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Why is there no water collection in the dirty water holder?


First make sure the unit is dispensing water, if so then check to make sure the lis on the lower tank is snapped on properly and that the front duct panel is installed. the front panel duct MUST be installed for floor operation to extract the solutio ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Does the dirty water go into the bladder? I thought that the bladder was the holding tank for dirty water. Any water (very little) was collected and sat on top of bladder. Any advise is appreciated


... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Little green machine pro heat pet the collection tank wasn't collection and dirty water was coming out of the bottom. i took it apart, cleaned it up and put a new "duckbill" gasket in. then it quit spraying, but i think i got that working again. now after i spray and get a good foam on the carpet, i switch to suction and it seems very weak. i can see the water moving (trickling) from the head into the hose but it is not reaching the collection tank -- actually, i am not sure where its goin


... Bissell THE BISSELL LITTLE GREEN MACHINE Vacuum

Vax is dispensing from clean water tank but dirty water tank is not collecting anything


... Vacuums

My 2X Bissell carpet cleaner is not sucking the water back up after dispensing. I do not have any dirty water collected around the bladder. How do I fix that?


If the carpet cleaner is not sucking any water, nine times out of ten, the culprit is the lid on the lower recovery tank. The lid on the lower tank (or dirty water tank) needs to hinge at the front and snap down at the back in order to cr ... Bissell Vacuums

No dirty water in the collection tank. It sucks up the water, but it seems to be leaking back out


... Bissell 2X Proheat 9200 rug cleaner

Cant locate owners manuel for bissell proheat complete pet 2x does solution go in small tank and hot water in bottom tank ?????where does dirty water collect ??


... Vacuums

Tank not collecting dirty water


You most likely have a break in your suction hose. check at the base where it attaches. When you bring back the handle release, you can see lt. If you have the type that has the external plug in for the water, then you probably don't have the hose ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My recovery tank is not collecting dirty water need answer on how to fix it? Thanks


Hoover carpet cleaner does not pick up water ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Not spraying or collecting dirty water


It may be the pump thats blocked or needs replacing this video will show you how to dissasemble the machine..http://www.youtube.com/w ... Bissell 12005 Spot Bot Handheld Vacuum

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

I used the Scooba 390 for the first time this weekend and it seems that the robot had problem sucking up the dirty water from the floor. When I emptied the dirty water tank, there was hardly any dirty water. Can you please let me know what can cause this problem?


... Roomba iRobot Scooba 390 Floor Washing Robot

The cleaner/water solution dispenses into the carpet, cleans it, pulls out the pet hair, but no dirty water goes into the dirty water reservoir! is all this dirty water going into my carpet?


The pet hair may be clogging the water return inlet I suugest you clean the bushes and inlet as well ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My bissell pro heat does not **** up the dirty water anymore at least the dirty water tank does not fill with dirty water


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have a Bissell Steam Cleaner that is not sucking up the water when cleaning. I used a full container of water and when it was empty I emptied out the water, only to find very little dirty water in it. I noticed the window, as i used it, seemed like it wasnt sucking up the water. I took the plastic cover off to clean it (it didnt look very dirty in the first place), an i noticed that the grey plastic flap was on but not moving up or down. I thought there may be dirt in it that prevented it from


... Bissell Vacuums

DIRTY WATER THE FRESH WATER AND SOLUTION COMES OUTON TO THE CARPET, BUT NO DIRTY WATER IS COMING INTO THE CANISTER.


Remove the dirty water tank and see if the front nozzle is fitted correctly, also see if the filter is clean on the dirty water tank ... Bissell 1770 Quicksteamer II Upright Vacuum

We just took our dirt devil Platinum Force Carpet Shampooer Model CE7900 out of the box - first time used. It puts soap and water down fine, but we can't get any dirty water picked up. None of the trouble shooting suggestions in the manual apply. HELP! (We had only the power on when trying to pick up the dirty water.)


... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

Don't know how to take dirty water canister out


The dirty water container just lifts out, but it can be very stubborn sometimes. You might have to wiggle it a little to loosen, then pull straight up (perpendicular to the floor). Hope this helps! ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

My bissell steam cleaner Model #9200P purchased 12/12/12 and only used once does not soak up the dirty water from the carpet. The bladder dispenses water and the solution is dispensed but the dirty w


Hi Barbara. I understand how frustrating no suction can be when you're trying to clean. Here's a quick link to troubleshooting steps to assist you: \015\012 ... Bissell 2X Proheat 9200 rug cleaner

Hoover Max Extract 77 fills the dirty water tank with clean water from the clean tank.


... Hoover Vacuums

The suction on my Hoover Spin Scrub 50 is suddenly not working. This is the 2nd or 3rd time I've used it and until now it has done a great job. But now it leaves my carpets soaking wet with no hope of drying and no dirty water is being suctioned into the dirty water tank. Help!


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How do i disengage the dirty water tank from the machine to empty dirty water.


There are two colored levers on the left and right side of the tank, simply pull them outward and then lift the tank off of the machine. \015\012 \015\012-OR-\015\012 \015\012There is a handle on the top of th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Shampooer instructions..... I have a Kirby Generation 3 with the shampooer. it has been awhile since i have used it and i sort of remember how to attach it but i was wondering this vacuum has a tray and i assume it is for sucking up the dirty water but when i went to use it no dirty water was going into the tray.....help what did i do wrong......thank you for your time...............spanny


Try this link....http://reviews.ebay.com/KIRBY-CARPET-SHAMPOOER-INSTRUCTIONS-MANUAL-DIRECTI ... Kirby Generation 3 Bagged Upright Vacuum

After shampooing carpet there is no dirty water in dirty water dispenser


Normally this is caused by the dirty water reserves lid is not seated properly. Take the lid off completely. Make sure there is no residue on the\015\012rubber part that seals the tank. When putting the lid back on, put the\015\012back hinges on firs ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

It won't suction the dirty water up to the container. I have ck'd the lid for the dirty water several times. Any other suggestions?


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1111 seconds