Having problems with your Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum ?

My cleaner lost it's vacum and won't **** up the water. I've cleaned the wire mesh by the spinny thing (it's green) and cleaned under side where the row of holes are. What can I do?


Answers :

If the motor runs, it will pull/****-up water unless there is a vacuum leak. This is usually caused by the lid on the recovery tank being crooked.When you put the lid on the recovery tank, you have to be sure that the front of the lid is properly engaged into the two tabs on the top of the tank. With the lid installed, if you can lift the front of the lid off the tank with two fingers, then the lid is not on correctly. Also, make sure the square duct that goes into the front of the tank is in place. You have to remove this duct to install the hose for doing function but must replace it to go back to the floor function.\015\012----------------\015\012Any time you aren't getting suction, the first thing to do is check the dirty water bin. Unlatch the back of the recovery tank part of the lid and remove. Reposition the lid matching the tabs on the front of the tank. Rotate the lid down on the tank making sure all sides are securely in place. A proper seal is important for peak performance. Also, make sure the latches securing the recovery tank to the main unit have been locked in place. Finally, check the recovery tank to make sure it is not full. When the recovery tank is full, the automatic "shut-off" mechanism will shut off the deep cleaner suction.----------------- This should help.Thanks.Helpmech.\015\012
Repair Help & Product Troubleshooting for Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My cleaner lost it's vacum and won't **** up the water. I've cleaned the wire mesh by the spinny thing (it's green) and cleaned under side where the row of holes are. What can I do?


If the motor runs, it will pull/****-up water unless there is a vacuum leak. This is usually caused by the lid on the recovery tank being crooked.When you put the lid on the recovery tank, you have to be sure that the front of the ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My Bissell Quicksteamer Model 1960-R won't spray cleaning solution. I have cleaned it and taken apart the whole thing. I can't find any problems. The holes are not cloged where the water comes out as I disconnected it and blew through it to be sure. The lines show water trying to go through. It is as if it doesn't have enough power to pump the water out when I squeeze the trigger. I am thinking it is the pump thing but can't find a replacement part for it.


... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

My Dyson DC25 got stuck and wouldn't return to the upright position, I figured out that one side had jumped the track and gotten stuck in the square hole below the track. I did not want to break the plastic to force it back, so I removed the screw on the right side that was holding the kick stand on and removed the kick stand, also a spring thing came out. Problem is, now I have no idea how to re-install the kickstand. Can't find a technical manual or video anywhere, it can't be very difficul


... Dyson DC25 All Floors Bagless Upright Vacuum

My Hoover Windtunnel, 12-amp, UGG16-900 (or U6616-900 - hard to make out the "G"s from the "6"s) suddenly lost suction this morning. The dirt collection thing is completely clean (I always clean it out after using), the side filter is dirty but not destructively so, and I can see nor feel any obstructions in the hoses. Should I take it in (a real hassle in NYC) or get a new dyson? LOL.


Usually on this machine the door/valve assembly is to blame. if something gets caught in the door/valve assembly it can break this part. you can take it in to see what the est. would be. hope this helps ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

The CV750 stopped working. It will come on sometimes but most of time it will not work. I installed new bag and cleaned filter. Green light on side of unit is on. Switch on side of unit will not make it come on either.


My CV750 comes on but makes a very loud noise. it sounds like something is stuck then it lets loose but the noise sounds terrible and the unit smells warm. I installed a new bag and cleaned filter. Green light on side of unit is on. Switch on side ... Broan-NuTone CV750 Central Vacuum

The dirt is clogged inside the bissel little green 1400-7 hand held cleaning head. How can I unclog? Can the plastic piece be removed asw for the dirt is stuck on the sides of the cleaning handle?


... Bissell 1400 Little Green Pro Canister Steam Vacuum

I have a Hoover Freespace Cyclonic 1800W Model No.TFS7182 013. (green) I have taken the filters out of each side to clean them and am confused about which filter goes on which side. I cannot find a users guide with diagrams anywhere!


... Hoover Vacuums

I have a Hoover Freespace Cyclonic 1800W Model No.TFS7182 013. (green) I have taken the filters out of each side to clean them and am confused about which filter goes on which side. I cannot find a users guide with diagrams anywhere!


... Hoover Vacuums

My brushes on my hoover streamvac will not rotate. I removed and cleaned assuring that the filter was also cleaned. The only different thing I have done is to insert the upholstery attachment and removed it after use (didn't work so well) suction seemed weak. I am also noticing that there is air being blown out of sides where the dirty water container is. (don't recall that in the past).


... Hoover F5900-900 Upright Steam Vacuum

My hoover spin scrub brushes stopped spinning and i have cleaned intake filter and tried to turn the thing that spins it...when brushes are off the hole turns then as soon as i connect brushes the brushes will not turn what else can i do!!???


... Vacuums

Filter I bought this Hoover a few years ago-- just now about to use it first time. I cannot find my user's manual and don't know how to change the filter-- or to clean it or whatever I am supposed to do with it. Also, there is a handle on one side of the unit that seems to be attached to an empty chamber or canister kind of thing. It looks like it should pull out, but it does not budge. I really would like to have a manual, but can't seem to find one. Is there a similar model that is still


This is not for the exact same model, but should help you out:\015\012http://edge.maytag.com/epipubs/56511B47.PDF ... Hoover U8143-900 Upright Vacuum

I have a bissell steam mop and it has been working fine but now there is a small hole in the side of the unit that the hot water and steam is shooting out of and it will not steam clean my floors. What should I do?


Mine TOO. Is it possible that it needs a new filter? they are available on amazon for $14. ... Bissell 1867 steamMOP Stick Vacuum

I have a dc17 and there is a clog in it. I have taken the brush off, cleaned the hose, but there is something up inside the hose on the side that I can't get to. how to I take things apart so I can see to unclog it.


On the back of the vaccuum theres is a screw with a ubend hose...did you remove that? I have had things stuck in there which stopped suction? you may want to check that. also take the wand off and look through to make sure you can see light throug ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Would like a copy of the Bissell Big Green Clean machine 1670 -E instruction leaflet, I recall it was only a few sides long, unfortunately a friend i loaned it to lost it and I just wondered if anyone could help? Thanks


... Bissell Vacuums

Hi my dyson is not sucking up very well when i put it on its side and switch it on the brushes are not going round when i put the white dail to on at the bottom the brushes go round but it makes a terrible noise i have cleaned the brushes checked the soleplate is on correct and taken the clear hose off and checked for splits the suction is there when i have been checking these things hope you can help thx


Hi there,Sorry to hear you're experiencing a problem with your cleaner. Please get in touch with us, free, on 08002980298 (UK), or 1866MYDYSON (US). We can run through some checks over the phone and provide you with the assistance you nee ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My bissel 310-3150 will not dispense cleaning solution, hence it will not suction up water. Red spinny thing will spin a couple of revolutions, then quit. When that stops, everything stops. What can I do to fix this? Unemployed so repair shop is out. DIY fix is needed.


... Bissell 1693 PowerSteamer Upright Vacuum

On the little green cleaning maching there is a pin hole in cap where it screws on when I try to put solution on machine it runs all over


This link is for the manualhttp://ecx.images-amazon.com/images/I/91pVWnod6GS.pdf ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

I took the cover off the brush so I could cut off all the hair that was wrapped around it (vacuum was working fine, I just noticed the hair). I pulled the brush/spinner thing off one side, cleaned everything, popped it back in where it belonged, and tried to make sure the belt was in the proper alignment. However, when I turned the vacuum on, it makes a horrible noise like I'm sucking up rocks. What have I done wrong in putting it back together? It seemed simple...


The ends of the brush roller have to go in in a certain position.each end has a different look.make sure the match up to the seats on the roller guides and make sure the belt is centered.the belt will center itself by turning the roller by hand in on ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

My irobot Dirt Dog won't go into a cleaning cycle. It is charged, but when i hit the clean button it does nothing. new battery installed a week ago. the LED lights under the "clean" button are flashing in sequence, "Green, Green+Red, Green". Then the sequence immediately stars over. Can someone help me?


Hi, A very common problem with the I robot is the wheels on the underside become clogged with dust and dirt. Turn the device over, and remove the bottom cover that is covering the wheels. At this time, remove the dirt and blockage from the wheels, an ... iRobot 1100 Dirt Dog Bagless Robotic Vacuum

In the undercarriage where the green cage that is to open when the yellow tabs are pressed will not open. the right side will unlatch but the left one wont unlatch.


... iRobot Roomba 530 Robotic Vacuum

My bissell brush band has come off and wont stay on thus the brush will not turn, there is also a black arm type thing on a spring inside (on both sides) on the pump belt side it has broken - the side where the brush belt is, help im searching for parts and a way to fix it but im getting no joy, incidentley the brush belt thickness looks way to thick for the small thickness for the brush belt cog (?) to stay on........am i missing something? so i need to get the arm thing replaced plus find a


... Bissell ProHeat Deep Cleaner Upright Vacuum

Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.


How many times does the red light blink before it pauses? ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

I suspect that "the thing" where the coffe is put in and the water pushes through is not clean enough. Water seems to go/come beside the "thing" I alsohave the feeling that there is coffee in the water tank where I suppose itt should not be. so howdoI clean the thing?


Put in vinegar and run a couple of brews vinegar only(not coffee) till the vinegar is clear when done,(use white vinegar)only so you can see when its clear,then run a brew of clear water to remove vinegar taste this will delime and clean out coffee m ... Vacuums

Hi, we have a Sunbeam electric blanket model no. BLO750 and type 696. It's a double blanket with dual control that can be used for different settings on either side. Both sides have been working ok but last night one side wouldn't heat and the green light kept flashing and now, whatever we do the green light keeps flashing except, when we set the control to "off". We can't find our Owners Manual to see what we are doing wrong, can you help please...or can you advise us where we may be ab


... Sunbeam Vacuums

Not sucking from bottom into bag, but blows out the side filter,..yet it DOES **** FROM HOSE ATTACHMENT. How can this be?...the.belt is fine recently replace, the rollers clean..I can feel anything i


Here is a diagram ,it's probably the hose behind the brush bar thats blocked.http://www.vacsite.com/en/bissell-parts-1/bissell-parts/3522-powerf ... Bissell 3522 PowerForce Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0782 seconds