Having problems with your Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum ?

Brushes do not turn - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Answers :

Check the brush block to see if the shaft that goes into the turbine broke off, replace brush block if it did. If ok, then the turbine may be clogged up, either clean it out or replace the turbine.
Repair Help & Product Troubleshooting for Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover max extract brushes not turning - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brushes do not turn - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Check the brush block to see if the shaft that goes into the turbine broke off, replace brush block if it did. If ok, then the turbine may be clogged up, either clean it out or replace the turbine. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brushes wont turn and wont spray water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brushes will not rotate on my steam vac - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


I'm sorry to tell you that you have a broken drive brush. One of the brushes has a stem, and that stem is broken. See if you can remove the brush assembly - I believe it pulls straight down. See if one of the stems is a little longer than the othe ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brush won't spin - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


It's more than likely that you have to clean the brush and its mounts mainly from hair, but also other dirt. Then it should be fine. You might want to disassemble the piece to get a better access, but only if you are confident, because it's important ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My brushes wont spin and i dont know why - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Your belt has broken and therefore the brush isn't spinning. You can find any vacuum belt at www.vacbelts.com. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a Hoover SteamVac Duo Deep Cleaner, model #F5520. The brushes won't turn and it won't release solution. There IS suction. Any ideas what could be the problem?


... Hoover F5520 SteamVac Duo Upright Wet Washer

HOOVER STEAMVAC Model# F5842-9RM 120v 12 amp Carpet Cleanerworks well. Hooked up upholstrey attachment, used it. Reassembled to standard operation, the aggitator brushes do not work. I dis assembled brush insert verything good. ran cleaner and the square hole that the bushes insert into did not rotate with cleaner on. turned off lightly tried to turn mechinism in machine no luck. Reassembled aganin, reinserted cleaning tool, then disconnected it. agitator still doesn't work. toggled switch


... Hoover Vacuums

We have a Hoover upright vacuum cleaner, model Core 7. There is a switch that turns on and off the brush drive. This operates via a cam with a bearing putting pressure on the final drive belt to engage the brush head. My brush head is not turning and with the lever set to engage the drive there is still considerable slack in the final drive belt. There appears to be only a bearing deflecting the belt, should there be a pully or other device mounted on this bearing? There is so much slack a


Yes, there should have been a white plastic sprocket on top of the bearing - in its channel the belt would sit. Unfortunately no parts are available for this unit that can be bought retail - only available by order to dealer repair shops.\012\012\012 ... Hoover Vacuums

Brand new Hoover Max Extract Deep Cleaner brushes won't turn. Read manual. Checked filters - all clear. Set Spin Scrub Mode Selector to a scrub setting. Brushes still won,t turn. However the brushes on the Spin Scrub hand tool rotate.


... Vacuums

Hoover steamvac dual v not dispensing water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Dirty water not returning in hoover steamvac - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Recovery lid not on correctly ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover carpet cleaner not picking up water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Brushes wont turn hoover f7412900 steam vac - Hoover SteamVac V2 6-Brush Widepath F7426-900 Vacuum


... Hoover SteamVac V2 6-Brush Widepath F7426-900 Vacuum

Belt replacement on a hoover steamvac - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

F5808 hoover steamvac - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover F6207-900 SteamVac Agility - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My Hoover spin/scrub floor cleaner has stopped scrubbing- the brushes spin for a few seconds right after turning it on, then stop until I turn it off and then on again. How can I fix this? I do not have a lot of money. I have taken off and cleaned the brushes and bottom vacuum opening.


Hi giacoma11,The common cause for this problem is the belt of your vacuum. It could be that the belt came loose or already worn out and needs replacement. To check if the belt is loose all you need to do is unscrew the bottom of the vacuu ... Hoover H3060 FloorMate SpinScrub 800 Upright Wet/Dry Vacuum

I have a Hoover steamvac Dual V carpet cleaner Model No. F7427-900. This is a spin scrub upright. My brushes will not work. We think the white square that the brushes fit up into in the center of the brushs is not turning. Can you help me.


You are on the right track! Place a screwdriver (flatbladed) into the white drive square and try to turn it. If it is locked up the drive assembly is your problem. It is very common for these parts to lock up because of the moisture involved with ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My carpet cleaner will not pick up water. - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Check to make sure that the recovery tank lid is fastened down all of the way around. Also if the foam filter on the bottom of the tank lid, make sure there is at least a 1/4 inch gap from the top of the lid. The wire screen filter is plugged, from ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Nozzles are clogged and brushes won't turn. - Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

I have a Hoover SteamVac Carpet Cleaner with Clean Surge. I lent it to my mother who used it without the brush attached underneath. Now it doesn?t **** up water and the brushes don?t turn. Any idea what would?ve broken? Is there a belt that would have burned out? The motor? Anthing I could fix myself, or would I need service for this?


If you go to this URL:\015\012\015\012http://www.vacpartswarehouse.com/Hoover-F7452-s/811.htm\015\012\015\012you will an exploded view of your Hoover. By going down the pictures you will be able to see the internal parts of the unit and ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Cleaner does not get up water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


\015\012The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on th ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Machine will not vacuum up the water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Could be a few thingsLook for suction at the head. Turn it on and cover the opening with your hand. You should feel suction. If not something is plugging it or one of the following. You can usually see a clog as the cover is c ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover steam vac v2, brushes won't turn. - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Hello,The Hoover SteamVac's are notorious for \015\012this exact problem. There are several things that can be causing this \015\012probelm.First, what you'll need to do is take the brush block \015\012out of the machine. To d ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1778 seconds