Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

Hoover steam vac spin scrub leaking cleaning solution

\015 The steam vac I have is leaking cleaning solution from the bottom of the vac even when I'm not pressing the solution trigger. It does this whenever it is on or off. Anytime there is fluid in the vac. I can't figure out if it is clean solution or dirty water but it never used to do this. I haven't used in in about a year and I think I have it put together correctly. What would cause this?\015

Answers :

The hose leading from the tank to the sprayer head on the bottom of the unit, or the tank is not seated properly or the tank has a hole or crack
There is a seal that is located where the transfer hose connects to the actual filling tank. this will need to be replaced. also, make sure the trigger isn't getting stuck slightly in the open position.
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover steam vac spin scrub leaking cleaning solution


The hose leading from the tank to the sprayer head on the bottom of the unit, or the tank is not seated properly or the tank has a hole or crack ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover steam vac spin scrub will not suction up the cleaning solution . Why is there no suction?


P{margin-top:0px; margin-bottom:0px;}\015\012Hello, Thank you for your recent e-mail. I am sorry to read about the problem that you are having with your cleaner. Please make sure your recovery tank and lid are installed correctly and ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Steam Vac Spin Scrub Carpet Cleaner won't suck


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=618767&thid=728884\015\012Hoover Steam Vac Spin Scrub Carpet Cleaner won't...\015\012Posted by hoofbeats1 on Jul 01, 2008 ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My Hoover Steam Vac Spin Scrub aw/ Clean Surge


Greetings,\015\012\015\012A few more things that you can try on your SteamVac. First remove the dirty water solution tank from the machine completely. You should see where the solution tank was just sitting, a plastic casing with a wh ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover Steam Vac Spin Scrub aw/ Clean Surge


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a hoover f7222-900 Steam Vac Spin Scrub. I


... Hoover F7222-900 SteamVac Upright Vacuum

I have an older model F6056-900 Hoover steamvac Spin Scrub Cleaner. My first problem was that I loaned it out to a friend. Anyway she ran over the hose (used for attachments) with her car. I tried using the cleaner for carpet cleaning this morning but when I tried to put the solution tank into place...its loose...won't snap back in like it used to. When I can get it somewhat in place the solution just complete drains out through the bottom fo the tank. The leak is where the small hole on the bot


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Can't find info for hoover steam vac spin scrub model # F5905900 on Hoover website, doesn't show that model number at all...looking for mesh (kind of cone/cylinder shape) that goes in dirty water tank (I think) and also the tool (wand) that slides into front to clean it out. It doesn't pull all the water up very well and the filter has been missing for some time. I don't know if that has anything to do with it or not. As far as the wand tool goes, I have taken the cover off at this point and


The cleanout tool is part # 43514001. The filter is # 90001398. Be sure to leave a 1/2 inch gap between the top of the filter and the bottom of the lid. If you need a manual, try model F5914-900 0r F5912-900 on Hoover.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Steam Vac Spin Scrub Carpet Cleaner won't suck


Had my steamvac spinscrub for 3 days now. it will not **** up why? ... Hoover F5906-900 Upright Steam Vacuum

How do I hook up the upholstery cleaning attachment on my Hoover Steam Vac spin & Scrub


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Leaking Solution Tank/Seal Install - Hoover Steam Vac


Not sure this will help, but we have a Hoover Steamvac F5843 and our valve seal seemed to have shrunk so the tank was leaking. Bought a new seal and had the same problem. How to install? There weren't any instructions or pictures of the part(s) invol ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover steam vac spin scrub model 4060-900 brushes are not spinning and I have lost the manual. Any ideas. Thanks. [email protected]


The problem I found with one a neighbor was tossing out is the bearings in the part that drives the brushes were stuck. Lubing them up solved the problem, but took a bit of work to get into. This also provides a good chance to clean the crud out of ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Steam Vac clean water tank valve leaks


A) make sure that there is not a place for a stair attachment. If\015\012there is make sure air is not leaking through where the attachment goes\015\012on because of damaged or misplaced fitting.\015\012\015\012b) some steam ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My hoover steam vac spin doesnt pump solution


It's probably the pump motor seized and needs oiling this video will give you instructions.. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover steam vac dual v clean water and detergent tank leaks water before attached to the vac and during cleaning


This is a common problem with the earlier models which had a separate soap tank glued to the clean water tank. The plastic was too thin beneath the valve on the clean water side and would develop cracks. You most likely will need a new one piece tank ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Routing of cleaning solution hoses on hoover steam vac


... Hoover Vacuums

Hoover Steam Vac Spin Scrub


Remove the brush block, is the shaft on it or broken off. Replace the block if broken off. Turn unit over, with brush block removed, handle tilted back, is the square hole turning, if not then the turbine is bad, this is what turns the brushes. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Instructions on how & how much cleaning solution on steam vac


Http://www.hoover.com/pdfs/manuals/F5914900.pdf ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Steam Vac V2 Deep Cleaner leaking clean water


Fill the tank and determine if the plastic is leaking, or if the valves are leaking. if the tank is cracked, it would need replaced. There is an improved design now available.\015\012\015\012You may cycle the valves on the bottom with t ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Do not know how to use Hoover Steam Vac Spin Scrub


Hoovers website, Hoover.com has them free to print. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac clean water reservoir leaking.


Take the clean water tank out and look on the bottom for a fitting that screws on make sure its tight.also inside of that fitting trhere should be a washer or an oring to keep it from leaking.if thats not the problem then your pump mightbe leaking.fo ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Clean Water Leaking from Hoover Steam Vac


... Hoover F5826-900 SteamVac Upright Wet Washer

I have a hoover steam vac LS 3600 and i attached the tool to clean my couch. the tool is sucking but no solution is coming out. i checked the hose and everything looks ok but no solution will come out of the sprayer.


There is a small pump inline of the spray unit. This is normally a coil type reciprocating type and most often this can be dirty or faulty.\012So remove pump and check it on table to see if this works, if not clean or test coils for continuity. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steam vac dual Model # F74310-900 - Brushes won't spin. i've cleaned the little screen per owners manual and still no fix. What else could it be? I can spin the brushes by hand if i remove the assembly.


... Vacuums

Suction button Although my Hoover Spin scrub is working perfecting dispensing the solution, when I go to suck up the solution from the carpet--I am having problems with the RED suction button that keeps popping up. I have to stop the cleaner and lift up the dirty water container to break the suction. Ive tried cleaning the netting that is encased around it, but still no luck. Any help would be appreciated! Thanks


This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1164 seconds