Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

I don't know where to put the water?

\015 I tried putting the water in the top tank, but it didn't work, so I transferred it to the bottom tank, and it's still not working?\015

Answers :

The clean water goes on top. You want to check your bottom tank and make sure the lid is not lose.
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I just got this euro pro shark steam mop. I dont have a manual for it so i dont know much about it. I put water in it and it heats up but when you start to use it. It makes a gurgling kind of sound and steam comes out, but not very much i dont think and on the floor you can't hardly tell where you went over the floor at cuz it's not very wet at all. So is it suppose to make a gurgling sound and should'nt the floor be alittle wetter?


Call Shark. They have good cust. support. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm


I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Water? I want to clean my couches but I don't know were you put the water not the old water I know where you put the cleaner but don't water supposed to be mixed in with the cleaner?


There are two tanks on that machine. The lower tank is the recovery for the dirty water and the upper tank is for the clean water solution. You mix the detergent with the clean water and away you go. ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

I don't have instructions for the Rainbow shampooer. I'm not sure how much water to put in, or whether I put water in both reservoirs. Does anyone know?


Water only goes into the cub in the handle. The dirty water gets put into the bowl on the canister part. ... Rainbow Vacuums

I HAVE A BISSELL PROHEAT CARPET CLEANER 7920 I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I HAVE A BISSELL PROHEAT CARPET CLEANER I DISSEMBLY IT TO CLEAN IT. I DON'T KNOW IF I PUT THE HOSES BACK IN THE RIGHT LOCATION BECAUSE AFTER I PUT IT BACK TOGETHER IT'S LEAKING WATER ALL OVER THE FLOOR BUT IT WILL RECOVER THE WATER FROM THE FLOOR AND THE SOLUTION WON'T SPARY OUT I THINK THE HOSES ARE NOT IN THEIR RIGHT LOCATION TO STOP THE FLOW WHEN IT'S NOT SUPPOSE TO BE COMING OUT CONSTANTLY HELP PLEASE IS THEIR A HOSE DIAGRAM FOR THE HOSES INSIDE THE CARPET CLEANER


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I lost the instruction manual and dont know how to put the string in or how to put anything together can u please explain to me how to put the brother xl3750 sewing machine together


Here is a link to your manual:homeappliance.manualsonline.com/manuals/mfg/brother/xl3750.htmlAll you have to do is ... Vacuums

I put boing water in my water tank for my bissel quick steamer it does not want work right any more i need to know how much would it cost for a new water tank, and how i might be able to order one, as well as a free manual


Hi and welcome to FixYa. I am Kelly \015\012\015\012Here are all the parts for your machine. \015\012Click on "read more" for price details \015\012\015\012 ... Bissell 8930M Upright Steam Cleaner

We have bissell pro heat and I have put new belts on and took off the top plastic cover I blew out the lines and I still can't get it to pump water or solution. The red little spinner flow indicater does'nt get water, if I pour water into it it runs out the front. I guess I don't know what else to do. The machine worked fine the last time we used it about 6 months ago. Any suggesttions?


Did you check and make sure the belt is still on right? They do come off from time to time.There are like 6 long screws holding the top cover to the bottom. The are real pain in the behind to put back together once you take them off. T ... Bissell Vacuums

I HAVE A HOOVER STEAM VAC SPIN SCRUB CARPET SCRUBBER. I KNOW HOW TO PUT THE WATER IN. I CAN'T REMEMBER HOW TO **** THE WATER BACK UP. PLEASE HELP


Hi,\015\012\015\012Please check the related links…\015\012\015\012http://www.ehow.com/way_5 ... Hoover Vacuums

D.d vaccum i have a dirt devil dynamite...i bought a new for it i put it on and not even 1 minute of using it the belt broke again!!!!i dont know whats going on do i have 2 put it on a certain way does it need grease or what!


Did you check the brush roll, if the ends aren't turning freely, then it needs to be replaced also. ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

Hello, my names Travis. I was contacting you in concern of my Kenmore Quick Clean 12AMP Vacum Cleaner. My girlfriend took the bottom off the vacum and removed the belt because the vacum wasnt picking up. I know have a new belt i just dont know where to put it on the vacum to reinstall it


Look for grooves on the motor shaft and on the brush shaft. ... Kenmore Quick Clean 30012 Vacuum

Have a bissel proheat plus. There is no water flow. It has been used once,but was not flushed with water. Tried to fix it myself. Don't know if it is put together correcly. Or sommthing may be plugged up.


If the belts are new and it still doesn't spray then its probably a clogged heater core, it isn't easy to unclog so i would take it to a bissell repair center. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Bissell powersteamer i have a bissell powersteamer my aunt gave me, but do not know how to operate it to put the water and cleaning solution in it. please let me know how to operate. or how can i get the operation guide or manual


BISSELL User's Guides can be downloaded at www.bissell.com\012On the front page under Customer Service click on User's Guides and enter the model number of your unit.\012User Guide will be displayed as a PDF file. ... Bissell 8806 Powersteamer Upright Vacuum

Using machine.. i dont no how to put water on the machine i dont even no how to use it..


Here's the link for Bissell 1699\015\012\015\012http://www.bissell.com/images/UserGuides/7901_1008.pdf\015\012\015\012If it i ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Bissell Powerease Lighweight Deep Cleaner. (Shampooer) After I fill the solution tank with the solution and water, I put it in it's slot, but all of the contents just come flowing out. I have only used this machine twice and it worked ok. You are supposed to press the trigger and the solution sprays out and then release the trigger when you want it to stop. But like I said, now I just put the tank on and all the contents come flowing out. I don't know what's wrong or how to stop it.


... Vacuums

I need to know what compartments to put the water in, and to put the cleaning solution in.


Hi There,The Larger compartment is for the clean water, and the secondary tank attached to the larger tank in the back of it is where the shampoo goes. This machine is handy as it will automatically mix the two solution tanks together f ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

I don't know where to put the water?


The clean water goes on top. You want to check your bottom tank and make sure the lid is not lose. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Dont know how to put the shampoo system together on my kirby g6..


Http://reviews.ebay.com/KIRBY-CARPET-SHAMPOOER-INSTRUCTIONS-MANUAL-DIRECTIONS_W0QQugidZ1000000000459499 ... Kirby G6 Bagged Upright Vacuum

No suction i have been using mine for like a year or so. today i went to use it and then no suction. the water comes out but it wont **** it up. I haven't had any problems till now. I cleaned the little red filter but still nothing. I dont wanna take it apart with out knowing what im looking for.


I had exactly the same problem with my five-year old my Bissell 7920, and it's probably a broken pump belt.  See page 19 of your instruction manual for how to replace.  The Bissel ProHeat belt accessory pack costs $3.99 and you get a pump b ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Belt broke I have a bissell powersteamer and a belt broke and came out the bottom of it. I dont know how to put one back on it


There should be an access panel on the top side of the cleaner. Pry this open with a screw driver and this should get you access to the area where the belt can be changed. ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

We have a bissell and it the one to clean the carpet how do we use it i no to put hot tap water and turn it on and hold the grey thing to make the soap come out but nothing is picking up well i dont see nothing


Take this link to Bissel website, select your model and download yor free operation manual.\015\012\015\012http://www.bissell.com/ ... Vacuums

How do i use the shampooer on kirby i have so many parts and dont know wher to begin to put them


I would contact Kirby directly:http://www.kirby.com/Portals/0/contact_us.html ... Kirby Ultimate G Bagged Upright Vacuum

I dont know the order of the hoses so that i can put it back together


I really don't know what vacuum you have, starting from the vacuum find the one that will snap into the vaccum itself (its normally the wider hose).Then size wize, they should graudaly get smaller on most vacuums.if all the hoses a ... Vacuums

Bissel steamer I took the base of the steamer apart and had trouble putting back together. The switch assembly the adjusts the flow of soap came apart. I dont know how to line up the the black valve to the switch. [email protected]


You can do this Jeremy just be take your time be patient and keep trying! ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0475 seconds