Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

Hoover Steamvac hose won't spray water

\015 My Hoover Steamvac hose has good suction but won't spray. Water trickles out even after running two tanks of hot water/vinegar mix. It seems to lay down water pretty well using as a a carpet cleaner. I did take apart the hose valve to check it but it appeared clean.\015

Answers :

SOLUTION#1 If the attachment wont spray water, the white plastic nozzle tip may be clogged. Take the brush attachment off, remove the two screws from the gray retaining cover (BE CAREFUL THE WHITE TIP UNDER THE BLACK PLASTIC TRIGGER MECHANISM IS SPRING LOADED and WILL GO FLYING). The trigger mechanism can be taken apart by lifting the black part off (may have to slide it back slightly), remove the spring from the white plastic valve insert, then take a flat screw driver and carefully pry the two white pieces apart and blow out both ends. You may have to find a hair size piece of wire to push threw it to clear it. The whole process is really simple once you take it apart and see how it works. Putting it together is in reverse order. The white piece will only go in to the black part one way and with the spring on you need to push it through the hole and the trigger part hooks on, slide it back on to the hose, then while holding it all, and put the gray retaining cover back on. Sounds more difficult than it really is. If your not mechanically inclined take some pictures as your taking it apart to refer to.
Solution#2 If the nozzle and trigger are clear, with the trigger assembly off the hose, plug the hose into the shampooer and turn it on (if the hose inside the suction hose is clear you should start seeing water flowing out the hose. If not run a piece of wire through that hose to unclog it. If its still not flowing then the Pump on the unit needs to be replaced.
Solution #3Cost Around $20 with shipping online. Google your make and model, and upholstery attachemnt pump. Mine was called AP4561692 (43582018) PUMP ASSM, from http://www.appliancepartspros.com/. (there real good about the live chat and helping you find the part).There are Youtube videos on taking apart the shampooer, which is pretty easy. The one place that might give you problems after you get down to taking the pump off, there is only one screw holding but there is on the bottom side of the pump a black bump that clips in to the base of the shampooer and you need to stick a screw driver from the bottom up and pry the base one way and pull the pump the other to unhook it.
Http://www.hoover.com/pdfs/manuals/F5914900.pdf
\015\012
\015\012
\015\012Before using tool
\015\012It may be necessary to remove air from
\015\012the system (“prime the pump”) so the
\015\012clean solution will flow to the tool. Follow
\015\012these steps:
\015\0121. Attach tool to hose and turn the carpet
\015\012cleaner ON.
\015\0122. Put the tool on a hard surface or
\015\012against your hand to block off the suction.
\015\0123. Wait a few seconds (can take up to
\015\01215 seconds). Then squeeze the trigger
\015\012and begin cleaning.
\015\012
\015\012GOODLUCK!!!!
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover Steamvac hose won't spray water


SOLUTION#1 If the attachment wont spray water, the white plastic nozzle tip may be clogged. Take the brush attachment off, remove the two screws from the gray retaining cover (BE CAREFUL THE WHITE TIP UNDER THE BLACK PLASTIC TRIGGER MECHANISM IS SPRI ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steamvac ultra hand tool doesn't spray water from hose - it has steady stream instead of spray


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Upholstry attachement Hi, I have attached my upholsty hose, but it will not suck up the water. The hose is spraying correctly. Can you help. I have a Hoover SteamVac Supreme. Thank you, Sarah


The hose end should have a duct on it that you insert in front of the dirty water tank. It must be down all of the way so it will seal. This is where your suction starts from. Acouple of other reasons could be the dirty water tank lid is not locke ... Hoover F5832-910 SteamVac Supreme Vacuum

Brushes wont turn and wont spray water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover steamvac maxextract 60 wont spray clean water


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Hoover Steamvac Upholstery Cleaner will not spray water.


In my case when I pulled the trigger on the upholstery hose I barely got a drizzle of water. After looking at the parts online I realized the valve assembly on the spray end of the hose consisted of a black valve housing, with an inner spring and a w ... Hoover F5832-910 SteamVac Supreme Vacuum

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

My Hoover Steamvac Widepath will NOT pickup the water after dispensing. I checked the hose inside the cleaner, there was a cut in the hose so I put electrical tape and completely sealed the cut. Still will NOT pick up water. I can't find any other problems with the hose. Any suggestions?


HelloHere are some suggestions you might want to follow to solve this problemFirst double check if there are other cuts in the hose or any sort of blockage or clogging in the hose and be sure to remove any form of debris ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

The Hoover Steamvac Widepath will NOT pick up water. The dispenser with cleaner DOES have water. The TANK that would receive the dirty water is NOT full. All tanks are on properly and the machine will still not pick up the used water. I found a tear in the interior hose leading to the receiving tank and repaired throughly with electrical tape. Still will not pick up the water. Any suggestions?


Sounds like a clogged air path (no vacuum action) from the floor pick-up to the collection tank. Take the tanks off and deal with the vacuum problem alone. The collection tank should have a air exit vent--is it clear? Check the interior hose that you ... Hoover F6213-900 SteamVac Agility TurboPOWER Steam Vacuum Vacuum

My hoover steamvac wont **** up dirty water float


This will also happen if the recovery tank lid is not securely latched or the lid gasket is bad and is leaking air. No vacuum, and the tank overflow ball snaps into place. I had a tank lid latch fail, and the symptoms you report were identical. ... Hoover F7431-900 SteamVac Vacuum

I have a Hoover F5411 steamvac Jr spot cleaner and it won't spray and one of the answers was to turn it over and try to turn the impiller to see if it turns. Where is the impille? Is it on the bottom of the top of the steamvac or on the bottom of the part that takes in the recover water?


... Vacuums

Hoover max extract hose wont turn off - Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

Hoover maxextract 77 wont suck up the water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover attachment hose is not spraying - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover F5915905 wont spray tool attachment - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Hoover spin scrub wont spray water


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steamvac not ejecting spray of water


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My hoover steamvac spinscrub wont **** up water


ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. 1. TAKE LID OFF OF DWT2. SLIDE THE LITTLE SQUARE PIECE (5'X5'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS POSSIBLE AND IF IT BEN ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Hoover steamvac ultra. The handheld hose


If you have installed the hose properly, try to hold your hand over the suction end with the cleaner on to prime the water in the hose. There is no way to dissasemble the hose. You could have a possibility of a few thing that have failed, \015\ ... Vacuums

Hoover steamvac won't spray water on carpet.


Check the ank valve to make sure when you push it in that water is coming out. The reservior asm, (the tank bottom sits on this)is bad or the rod in the handle isn't pushing the reservior asm when you squeeze the trigger.\015\012\015\012 ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Will not spray water anymore - Hoover F5411 SteamVac Jr. Canister Vacuum


Ours was not clogged. We took the impeller mechanism off the bottom and spun the little impeller. It would spin fine upside down but not right side up (the way it sits on the machine). We looked at the metal shaft and saw it had slipped out of pla ... Hoover F5411 SteamVac Jr. Canister Vacuum

It wont **** water up - Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum


Try putting the recovery tank on again. check the filter screen at the bottom by the brushes and in side of the recovery tank screen. worst case, it will be the rubber grament under the recovery tank, to get to it you will have to.... remove the reco ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

My steam VAC upright wont **** up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common and simple problem with these involves the recovery tank. Take it off, remove the cover and check to be sure it fits snugly. All tabs must be locked front AND back. If this machine has tools you have to hook up in order to use you ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Steam vac sprays but won't suck up water... - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Water wont spray from fabrac cleaning hose - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


Roller wont turn ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0979 seconds