Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

My spin scrub was working fine last time...this time I pulled it out (we have had it about 6 months) and it is only blowing air, not sucking back in. Is there a setting that is incorrect?


Answers :

Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank.
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My spin scrub was working fine last time...this time I pulled it out (we have had it about 6 months) and it is only blowing air, not sucking back in. Is there a setting that is incorrect?


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Kenmore upright progrssive intell clean. For some reason it isn't sucking when I use it to vacuum. When I use attachments they work fine, but when I plug the hose back in after using the attachments and turn it back on it makes a weird noise and I can feel air blowing out of the back. Can you help me resolve this problem?


You have the answer and just don't know it. You are there so keep looking. Somewhere between where the suction hose connects with the lower hose and the power-head. There is a blockage, you may need to turn the unit upside down and look there or try ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have a Kenmore upright progrssive intell clean. For some reason it isn't sucking when I use it to vacuum. When I use attachments they work fine, but when I plug the hose back in after using the attachments and turn it back on it makes a weird noise and I can feel air blowing out of the back. Can you help me resolve this problem?


Open this manual to page 18 and clean all the filters listed to restore air flow.http://www.managemylife.com/mmh/lis_pdf/OWNM/L0908343.pdf ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have a bissell power force vacuum and I just pulled the bag out to change it and when I put it back in it began blowing air out the filter on the side and is no longer sucking


Hello,\015\012Try checking the attachment hose for clogs. It should come completely off of the vacuum with just a few screws. Also, check the little hole underneath the brushroll where the dirt goes in. Hope this helps...\015\012Marci ... Vacuums

Seals leaking Where the canister meets the machine, the seals are leaking, blowing whatever manages to get sucked up right back into the air. I can't see anywhere to buy new seals. What to do?


Hi.\015\012\015\012If you live in the UK I can help you.\015\012\015\012http://dysonmanuals.inc.io/\015\012\015\012Chris. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My bissell carpet cleaner is blowing air and not sucking


... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

My vacuum blows air instead of sucking air. I have a dirt devil swivel guide. I got something stuck in the brush spinner, got it out...but now the vacuum doesnt suck stuff up anymore.


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=571660\015\012Generic problem for all Vacuums\015\012My vacuum blows air instead\015\012Posted by katweaver3 on ... Vacuums

Modeol116.30012000, changed hepa filter, bag. vacuum seems to be blowing air instead of sucking dirt up. The bag collapses when turned on instead of blowing up with air. any ideas as to what is wrong? Thank you


... Kenmore Vacuums

Bissell proheat blowing out air instead of sucking in air


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

My Kirby vacume not sucking air..just blowing out air..Why?


Check hose connections ... Vacuums

Dysin vacuum blows air instead of sucking it!


If it is blowing air, then it is still clogged up somewhere, you didn't give your model number, but some of these have removable covers on each side and on the back. Also make sure that all covers are back on securely. ... Vacuums

Is there a switch that reverses from sucking air in to blowing air out


No there are NOT switch Normally this motor from AC, doesnot have this device for reverse. Only you can do it by open the motor and chaging the connectionsNow you must shure the a) hose is clogged b) bag is clogged c) or there another thing maybe ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Suction stopped. Roller and belt working-in fine order. Checked hoses have not found any blockage. Blowing out air or sucking so little can't feel it with hand on hose end. Help!


Either a blockage or the main air filter is blocked , some it can be washed and others it must be replaced I would check the owner manual and look at the filter, foam ones can and usually have instructions where they install to wash them. ... Hoover Tempo Widepath Upright Vacuum - Blue

I recently purchased a house with a Filter Queen Central cleaning system model FQ-7500. My problem is that instead of sucking air it blows the air out. How do I reverse the air flow?


Never seen this model but it is on of two things,the hose is hooked up wrong or the motor is either switched in reverse or the motor has been reversed with wire leads ... Filter Queen Majestic Canister Vacuum

Why is my Miele vacuum blowing air out instead of sucking in?


... Miele S251i Plus Bagged Canister Vacuum

It seems to blow air out instead of sucking up


Remove the bag on top and the plate on the bottom. Clean out the air passages, top and bottom, looking for a clog. When it seems clear, turn on the vacuum to see if air is moving through. Don't allow a full bag to remain in place Check the brush on t ... Hoover Tempo Widepath Upright Vacuum - Blue

HOOVER SPINSCRUB WONT SUCK UP WATER...BLOWING AIR OUT


ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. \015\0121. TAKE LID OFF OF DWT\015\0122. SLIDE THE LITTLE SQUARE PIECE (5'X5'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS PO ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Oreck XL is blowing air out rather than sucking dirt in.


... Oreck XL Ultra Bagged Upright Vacuum

Dysin vacuum blows air instead of sucking it!


Dysons aren't supposed to clog up, but they do. There a number of ports you can open to see if there are clogs in any of them. Usually a clog is why it will blow air and debris out instead of sucking. You just need to find it. ... Vacuums

Vac blows air out rather than sucking air in.


CHECK OUT MY TROUBLESHOOTING GUIDE....\015\012\015\012http://reviews.ebay.com/COMMON-PROBLE ... Kirby Ultimate G Bagged Upright Vacuum

Vacuum is blowing air out instead of sucking air in


... Panasonic MC-V7309 Vacuum

Hi I’ve got a Panasonic vacuum cleaner MC E468 1600W a few years old now but works well up to recent problem. Not picking up I checked the obvious things and found excessive air being sucked in around the hose housing at the back of the vacuum (as it enters the waste bag) On inspection it appears to me as if there should be some sort of gasket that may have perished and been sucked in, however I can’t identify any such part. Any thoughts on what the problem/solution may be will be appreciate


The hose on the back might be loose - check to see that the hose is not obstructing anything where it screws in at the back - or indeed the screws may be loose themselves; some of the MCE 468 models had an additional ring washer that sits between the ... Panasonic Vacuums

My Eureka 4870 has no suction on the floor or hose setting, white air blows out the front filter. Further, the roller does not move when on the floor setting. The belt is in good condition and I cannot find any blockage in the hoses. Any ideas?


Suction problems on the Eureka 4870: after cleaning all accessible piping; cleaning the motor filter; changing the bag and replacing hepa filter the final problem was found. Removal of the motor cover revealed that the rubber gasket that fits over th ... Eureka Smartvac 4870 Bagged Upright Vacuum

My Vacuum DC-17 has just quit sucking. It has been making quite a racket since I had the belt changed at a repair shop several months ago. I was told that the belt was a new design and figured that was why it was making so much noise. it seemed to work fine, was picking up dirt and all, but today, when I started vacumming, I noticed it was not sucking air either with the belt engaged or not. My vacuum is approx. 5 years old.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a Pelonis Dehumidifier Model MDF 1-20AE. I am not sure how to set the proper settings. It seems the unit is working but blowing out hot air which making the room rather hot. (My previous old dehumidifier did not have this problem.) Is there a User Manual that I can download on line? Thank you very much.


... Pelonis Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0469 seconds