Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

Decrease in suction

\015 My brand new SteamVac was working fine and then in the middle of a job, all of a sudden the suction decreased significantly. The lid of the waste water tank is correctly fitted, and I have checked all the gaskets and seals. The motor is also getting hot pretty quickly. Could something have got into the motor?\015

Answers :

Check to make sure the round gasket seal, under the hood, is in place. It is a rubber seal that sits on the plastic pipe, under the corner of the recovery tank, when the tank is placed in to the foot. It seals the vacuum from the motor, to the tank.
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Decreased suction was using to vaccuum carpet and suction decreased..nothing plugging hose....suction remain at unit canister and exhaust is fine....suggestions??


You might have a clog, to try and unclog the lines, you need to unplug the unit, and remove the bag compartment. Then take a shop vac using the hose attachment hold it into the attachment door where there is low suction and try to draw the clog out t ... Broan-NuTone CV353 Central Vacuum

EF 1750 has lost suction power. There is a noticable decrease in suction power even at the power unit inlet.


Disconnect the actual pipe where it meets the vac. Then test the intake for suction. If you have poor suction still, check the intake itself from inside the vac body for blockage, then check the gasket on the pail for mis-alignement.If yo ... Easy Flo EF1750 Central System Vacuum

The model is Miele S538, but I did not see it on the list. The suction power button( ) increasing the power does not work. The suction power button (-) decreasing the power does work.


... Miele Leo S5381 Canister HEPA Vacuum Cleaner Bagged Vacuum

I have bought a shark cordless vacuum sv779z 14 from walmart, at first it worked well, but lately the suction is ok when i switch it on, and them immediately decrease until there is almost no suction. I don't know if its the battery or what i need to replace. When i call the customer care number listed on the instruction manual, they say that they don't have the model number on file and that i should call back in 7 days, which i have done several times, what should i do?


... Vacuums

My vacuum makes a wierd sucking and blocking sound when turned on and when you put the extension tube on the suction decreases...but when just the wand handloe is on the suction is excellent...we replaced the barrel thinking it was broken but that hasnt fixed the problem


You did not list the make and model of your unit, so it is difficult to hunt for problems.\015\012\015\012Check to see if any of the tube vents might be open. They should be closed when in use.\015\012Also check to see there are no holes in th ... Vacuums

The suction has decreased by about 50%. The brush


Check that there is nothing blocking the hose and that there are no obstructions around any of the filters, clean and replace filters too if possible. If you still find you have less than optimum suction , you may need to replace your motor. But it s ... Hoover Windtunnel Supreme U5280-900 Upright Vacuum

Decrease in suction


Check to make sure the round gasket seal, under the hood, is in place. It is a rubber seal that sits on the plastic pipe, under the corner of the recovery tank, when the tank is placed in to the foot. It seals the vacuum from the motor, to the tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Decreased hose suction with Windtunnel


There are very few things left to check. First verify that the filter is installed properly, in the dirt cup. second check to make sure the dirt cup lid is on and secure. Did you use water on the round dirt cup filter? if you have you will need to re ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Decreased suction and high pitch whine in motor


Clean out suction tubes ther is something caught in them ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Decreased wand suction


The blockage could be in the wand itself or in the entry duct of the machine. Take the wand off, look through it and if you can't see light coming through the other end, there is something stuck in the wand - take it out with a long object like a met ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

Decreased suction at hose end


Yes, the "door" on the angle hose might not closing properly\015\012when the vacuum is in the upright position (if you look at the vacuum\015\012from the back, this hose connects the back to the bottom of the vacuum\015\012and it has a "door" at the ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Motor is turning but making a whining noise and suction has decreased


... Rainbow E series Canister Wet/Dry Vacuum

My 8 yr old kenmore vacuum works well - however the hose has worn under the handle where there is a hole (resulting in decreased suction power). I'd like instructions on opening the handle and bypassing the worn piece of tubing rather than replacing it for $129. Some of the handle screws remove easily but the last one doesn't loosen easily.


Hi,Have you tried spraying the stubborn screw with WD40 and let it soaked for a while? Other than these screws holding the handle together, there would no other way of opening it up. Hope this be of initial help/idea. ... Kenmore Vacuums

Dyson Clogged? I have a DC07 and i've noticed that the suction as decreased dramatically. Any suggestions on whats the problem? ty


Check the filter and look into doing this:\015\012\015\012http://www.fixya.com/support/t2936439-dyson_suffers_from_lack_suction ... Electrolux Guardian Bagged Canister Vacuum

The suction has dramatically decreased


IF you have a nutone VX series tank contact NuTone. your tank may be bad they will more than likely replace the whole tank under warrenty. ... Broan-NuTone VX475 Bagged Central System Vacuum

Low suction on Nilfisk King


... Nilfisk Family Vac Bagged Canister Vacuum

Little suction on Bosch formula hygenix hoover


... Vacuums

Dyson 18 losing suction


Check the HEPA filter if it has one. This bit of foam gets clogged over time and significantly reduces the suction especially if you've been vacuuming a lot of very dusty areas i.e. dust from building work etc. Just wash the filter with lots of water ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

Hi my dyson dc18 has great suction from wand but when you got to use the vac for floors little suction but wand still got suction even while vacuming floors is it suposed to stop suction from wand


My Dyson dc18 had the same symptoms. The wand worked well and the floor bar had no suction. After removing pieces & shoving my fingers into the machine (no blockage) I found the suction pipe rotates between two positions (floor and wand). It look ... Dyson DC18 all floors Bagless Upright Cyclonic Vacuum

I have a Dyson DC24/ all floors, serial number 530-US-D78353 that I have registered already w/ your company. The vacuum is generating suction from the main outlet (that goes to the canister)///but once I place the canister into position..there is no suction from the floor foot. The roller is working/spinning, but no suction..picks up nothing, I have cleaned and rechecked all filters and can not figure out why I suddenly have no suction. Appreciate your input and/or advise where there is a local


... Dyson Ball DC24 Bagless Upright Vacuum

No suction I am getting no suction on my central vac at the vac. I do not believe that the piping is plugged up, the vacuum is not creating suction. What are the causes of no suction at the vacuum and how do I take the top half of the Nutone central vac off?


Use the guide at builtinvacuum.com/flowchrt.html to find the issue and solution. Most likely you need to test it without any filter and be sure the bottom of the unit is attached :) To get access to the motors you need to unbolt the very top sides. ... Broan-NuTone CV350 Performance Bagged Central System Vacuum

Suction Cover The suction cover of my Eureka Deep Steam 2575A is broken - the tabs snapped off of the cover so I am unable to screw the suction cover back on. I need to purchase a new suction cover but can't find one anywhere. Anyone know what I can do? thanks


The exact same thing happened to me. i just called and ordered it from eureka. the number is 1-800-282-2886. the cover cost 13.07 and the s ... Eureka 2576A Steam Vacuum

Poor suction...continued Wow, thanks for answering so quickly! To answer your question, yes, there is suction at the screen, but it is very weak. I keep that screen clean. As a side note, I noticed that when I remove the top clear plastic cover (that would be part # 37 on the diagram, as far as I can tell) there is decent suction coming from the intake there--part 36? 30? it's hard to tell. But with the cover on, I feel no suction (from where it sucks up the water directly from the carpet),


Wish I had it in my shop, it is hard to figure your problem. I do know that you must have something out of place and you may have to take it apart to find it. You may feel some suction there at the top of the clear nozzle, but maybe it isn't strong ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

No suction I just replaced the bag, and normally after this I have a lot of suction. Now that I have changed the bag I have less suction that I had before. Not even enough to picj up dog hair. I snaked he hose and checked all of the connections. It seems to have an air leak but no amount of tape will fix this. I cleaned the filer as well with warm water and dried it and re installed but still absolutely no suction. I am ready to throw it out! Any suggestions would be appreciated


1, Does the blower (discharge) side blow bunches of air??Yes: Something is clogged from the bag to the hose end. Try blowing out the hose from the discharge side.Or: The bag is not properly seated. Make sure that the plastic piece is ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Lost suction my DCO7 lost suction in the hose I started taking it apart and cleaning it and looking for clogs (probably more than I should have) and when I put it back together it has awesome suction in the hose but no suction in the base. It just pulls the pine needles up (christmas tree) but they never appear in the "bag" compartment and when I look they are just all gathered in a clump in the bottom by the brush.


Hi.\015\012\015\012Remove the sole plate turn the 3 plastic screws to unlock & lift off.\015\012\015\012Now remove the blockages that have accumilated from the oppening of short clear hose.\015\012Check you can turn ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0407 seconds