Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

Severe water leak at the bottom when turned on.

\015 When the holding tank is full and the machine is off, it will not leak. But as soon as I turn it on, water pours out of the bottom and the machine can\342\200\231t **** it up fast enough.\015

Answers :

It sounds like the tubing that is suppose to be hooked to two spray nozzles has come loose. You will have to take that dirt tank off, then turn the machine upside down and take the two screws out that hold the hood on from the bottom by the brushes, and then turn the machine back upright and take the screw from the top out. You should be able now to take the hood off and see all the tubing exposed. There is only one tube that goes to the spaying part in the front and see if it needs to be pushed back onto its' barbed fitting. Put that back on and put the hood back together. That should get you going.
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Severe water leak at the bottom when turned on.


It sounds like the tubing that is suppose to be hooked to two spray nozzles has come loose. You will have to take that dirt tank off, then turn the machine upside down and take the two screws out that hold the hood on from the bottom by the brushes, ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Bissell ProHeat 2x is pouring water out of the bottom anytime it's turned on. I had it in the shop for no water, took it back again for the same problem, took it back again because it had no suction, finally took it apart and found the problem with the suction and fixed it myself. Worked fine for a day and now it is constantly leaking water, if it's turned on, and is useless for anything except for making a mess.


Took the unit apart and discovered my heater had small pinholes in the metal and they had put in silicone, instead of a gasket, which didn't seal. So much for the place I took it to "saving" my heater for me. I repaired it myself by getting a few o ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have the Hoover Max Extract steam cleaner. It is about 2 years old. When I turn it off a lot of water immediately leaks out the bottom and continues leaking for some time. I looked underneath it to see if any hoses appear to be disconnected, but they don't appear to be.


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My vax rapide xl v027 leaks water from the clean tank through the rubber seal at the bottom of the tank. Seal seems ok but seems to rely on gravity. Leak is there weather or not its turned on


... Vacuums

NOTHING WORKS Used the unit 3 1/2 weeks ago, now it will not do anything except turn on. The water and shampoo will not dispense and the brushes will not turn. Is there some type of reset button that can be utilized????????? Have had unit for several years with only one other problem, the soap dispenser had to be replaced because it leaked. Teresa


Check the foam filter on the underside of the recovery tank lid, make sure that it has at least a 1/4 in. gap from the top. There also is a filter, from the bottom, it has a red frame, pull out far enough to clean it.\015\012On the bottom of t ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My kenwood steam mop makes for very wet mopping is this supposed to be? My floors are a lot wetter than when I use a traditional mop. When I fill the tank and turn it on the water seems to just leak from the bottom so I have only been half filling it and then the water light comes on within 2 mins of when steam starts to appear. What am I doing wrong??


... Vacuums

Using my hoover steam vac tonight and too much water coming out. once it's turned on, water and shampoo continuously come out underneath until tanks are empty. looks to be leaking from left side bottom as looking at it standing behind the unit


Make sure that you have filled everthing properly and the hoover steam is in a good condition. or check else is there any loose coonections in the bottom of the hoover, which makes the tank empty.if the problem persists take it to service. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

The clean water is leaking from the bottom somewhere when I turn it off and take a break.


Mine is as we'll.... don't know where to fix it... ... Rug Doctor Mighty Pro Mpc2c Carpet Cleaning Machine

Hoover F7458-900 Spin Scrub leaks water from bottom without pulling trigger when turned on.


The soap causes the valve in the trigger to stick u should be able to clean it by just using hot water and opening a closing the trigger. thank you josh ill be here for more info if that dont work ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover steamvac when I use it it leaks out of bottom. when it off an water in tank leaks out of bottom,when its off an I pull the triggar it flows big time out of bottom. tank doesnt leak when off sitting with water in it


Let me start out with an apology. I did not ask my question very well - and you did not answer it as I needed.\015\012If you wish, we MAY be able to communicate in your native language. We can do most indian languages, Turkish, Ukranian and s ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Black water leaks from bottom of ProHeat 2x


Probably be a rubber seal leak or crack at the soap water dispenser pump.\015\012If you can take it apart and it is the seal you should be able to reseal it with gasket seal from an auto parts store. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The Lower body of the Bissell QuickSteamer, water pours out from the body. Solution: I took apart the machine and there is a spring loaded valve with a rubber washer at the bottom. Think of the letter T upside down with the rubber washer on it. The washer stretches over the bottom and the spring creates a leakproof plug and won't allow water to pass till the button on the handle is pressed. This old washer came partially off and allowed water to leak. I purchased from the plumbing dept. a mi


... Bissell Vacuums

I have a Hoover F5411 steamvac Jr spot cleaner and it won't spray and one of the answers was to turn it over and try to turn the impiller to see if it turns. Where is the impille? Is it on the bottom of the top of the steamvac or on the bottom of the part that takes in the recover water?


... Vacuums

Hi my proheat bissell 7901 stopped pumping water to the floor, but it pumps water from the hand hose. I read the manual and followed how to check belt and the flat belt on right side of shampooer is fine and I turned on and it turns and so do the brushes at the bottom of the machine. I was reading online and I guess there's two belts on this machine? where can I find the other belt to see if it needs replacing. I guess it's a ribbed belt? that is the water pump belt?


Just taken ours apart with the same problem... found it was caused by the 2 halves of the main casing coming apart in the area where the upright pedal release is. I found this to be due to the upper casing having broken in 2 places - the bottom of th ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Envirosteamer 300 leaking water. Older yellow model. I put water in it and as soon as it heats up, all the water leaks out the bottom, and it barely gets warm! It worked fine before. Could it be seals need replacing or something? Thanks!!


... Eureka Enviro Steamer 370 Upright Vacuum

I have a sta rite (pentair) cristal high rate sand filter model T-200-BP-1....its leaking water thru the top of the valve, where the valve cover screws on the valve body assembly. it leaks water out where they go together around the screws. Also when i vacuum it, everything that i vacuum gets washed back in the pool when its on the filter position. Also the backwash leaks when its turned 2 the filter position, does it supposed to do that?...the only way i have gotten it to stop is to put a seper


... Vacuums

Water tank valve is leaking out of the bottom of the tank. The water leaks on the floor.


It could be a cheap fix. There should be a rubber o ring that's worn or ate away by chemicals.\015\012I'm hoping the tank isn't cracked.\015\012Remove o ring. Contact repair place. O ring shouldn't be more than 5.00. ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

I have a Eureka Atlantis carpet cleaner and a little water always leaks out of the bottom. Recently, the head of my handheld upholstery cleaner keeps leaking water. How do I get it to stop? Thanks.


... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

Bissell spotbot: leaking the dirty water from bottom. I took the bottom plate off and there is a really crappy rubber seal. I think it is leaking from there.


I had the same issue. After some research, I determined I was missing a black "duckbill" gasket on the bottom of the dirty water collection tank.\015\012\015\012This caused reduced suction, and for the water to pool at the botom of the s ... Bissell SpotBot Robotic Wet/Dry Vacuum

Leaking tank After I put the water in the tank and put the tank in its spot, water leaks from the bottom of the tank. Also from the detergent tank.


(1) Does water or chemical leak from the tank when filled, but before it is installed? If not, then the tank is OK.\015\012(2) If the tank is not properly aligned to the lower handle when assembled and latched, the black rubber seals on the ha ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I was vacuuming today, and it was doing fine, then all of a sudden the motor kicked up a notch or two, then I heard the LOUDEST POP!!!...I turned it off, went and unplugged it, took off the top of the canister, then took the water pan to empty it, because I seen something on the bottom, as I was pouring the water out, I seen on the bottom, ALOT of, what looked like, small bands of metal...could you tell me what may have happened..??


It's possible the fan on the motor has disintgrated. If this is the case replace the motor. ... Rainbow E series Canister Wet/Dry Vacuum

Water leaks out the bottom of vac have new tank but the water still comes out the bottom while running like it is automatic no control


Hi Steve I have the same problem can you help if you were able to fix? ... Hoover F7220900 SteamVac V2 Upright Vacuum

Water leaking When I fill the canister portion with hot water and put it in my machine it immediately begins to leak out the bottom. It has just started doing this. Do I need to take it in for repair?


The water tanks on this unit have had a very bad history of leaks. Most of the repair people had never heard of this unit, but one did, and had a spare set of tanks. If the unit is still under warranty, it is worth your while to get a replacement u ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi


Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

Water leaking from bottom and hose not connected


The hose just pushes on. You will have to take the top cover off to rehook up the hoses. There are scres on the bottom, then where the dirty water tank sits, there tabs that you have to unhook, then the cover will come off. Note: the filter inside ... Hoover V1 SteamVac SpinScrub Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0742 seconds