Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

My steamvac will not **** in it just blows air out and does not pick up the water solution once it has been sprayed on the carpet.


Answers :

I finally remedied this "no suction" problem with mine. At front of recovery tank is a plastic panel that can slide up and down. Make sure that front panel is pushed COMPLETELY down when cleaning floors.
Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank.
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My steamvac will not **** in it just blows air out and does not pick up the water solution once it has been sprayed on the carpet.


I finally remedied this "no suction" problem with mine. At front of recovery tank is a plastic panel that can slide up and down. Make sure that front panel is pushed COMPLETELY down when cleaning floors. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Replaced the pump for a 9300 M Bissell Proheat 2x as the water solution was not releasing to the carpet. Once rehooked the lines the solution appears to be coming from the water tank and returning to the used tank and bypassing spraying on the carpet. How can I be sure the hoses are hooked up correctly?


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Bissell Pro Heat Pet will spray water but not pick it up when cleaning the carpet. Is there anything I can do to fix it? The furniture attachment hose picks up water well. It seems like it could be a bit more powerful of a draw on water. I don't know it that has something to do with why the floor cleaning sucktion doesn't work. Thank you for your time. Jenn


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bissell Vacuums

My Vax Rapide carpet washer sprays the water solution perfectly on to the carpet but will only **** up the dirty water when in the upright position which is labour intensive.


... Vacuums

Cleaner will not dispense the water from the tank. It solution is dispensed but not the water from the blatter. It also picks up water from the carpet.


Check hose for a clog ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a Vax Rapide Powerglide carpet cleaner. It sprays the solution on to the carpet perfectly but will only suck up the dirty water when in the upright position.


... Vacuums

My carpet cleaner won't pick up the dirty water... it works fine to spray out, but not to pick up


... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

My shampooer only sprays a single stream of shampoo and water whenever I use it on the carpet... That and I can't get it to lay a nice even layer of shampoo to soak in and then pick it up...it always does a single heavy stream and tries sucking it up immediately after it's sprayed out?


You are probably missing the foam screen on the tank outlet. There should be a plastic disk with a fine screen in it on the tank outlet. If the screen is missing, foam will not be produced; and just soap water will be sprayed out. Sometimes the scree ... Kirby Shampooer Shampoo Hose G3 Ultimate Diamond Vacuum

My Bissel ProHeat carpet shampooer is not spraying to the floor. I have checked the hoses best I can and they appear to be clear, no clogs. The nozzles don't looked clogged either. The above floor hose does spray water. I definitely have not gotten my money's worth from this machine. Any solutions?


... Bissell 9200 Upright Vacuum

Bissell carpet cleaner does not spray water only cleaning solution. Water does not leave bladder.


... Bissell 8910 ProHeat Clear View Upright Vacuum

My hoover max extract carpet cleaner won't release the cleaning solution. It's just spraying out the clean water and not mixing with the cleaning solution.


... Hoover F6055-900 SteamVac Maxextract LS Wet/Dry Vacuum

I have a Bissel 9300-C 0714 BC Carpet Shampooer. It was working great and all of a sudden it stopped working. It still sucks up dirty water but it does not spray water onto the carpet. I can get it to spray water through the smallest hand attatchment but not through the large hand held piece on the base of the machine. I really hope you can help me, I am a dog groomer and I really need my machine to work properly. I can get it to spray water out of the smallest hand attatchment but that's all t


The spray jet has become clogged from the soap.... just clean it out. same thing happened to my attachment. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I posted my problem earlier today that I was having with my Bissell Little Green Machine not dispensing solution, but sucked up no problem. Someone said that the most common problem was a blockage. We put hot water in the reservoir for 15 minutes as advised and it still will not dispense. The fluid is now ''dribbling''so it is better. It is just not spraying. We are able to blow from the end and make bubbles in the reservoir which shows us it is not blocked. Any other suggestions?


Okay. I fixed this on mine. Undo the screws on the handle, right by the trigger. You pull the tubes off the little valve. Push on the button and see if you can blow through the valve. If not, push a pin around in the valve (with it pushed into the ... Bissell 1720-1 Little Green Wet/Dry Vacuum

The carpet cleaner will not spray water or soap solution


Open and clean the snoozle /hose from any debris or dust.2) fill the solution until the signal of the recipient.3) See if the motor is running o.k or repair. ... Bissell 2X Proheat 9200 rug cleaner

My Bissell ProHeat Upright Carpet Cleaner will not spray water or solution. I have filled the bladder; I have filled the formula tank; I have reseated the tank; and I have turned the unit off and then on again to reprime the trigger. Nothing has worked. Any suggestions?


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Its not sucking up the water off the carpet , no suction , it's spraying , the scrubbing brushes are spinning , I can feel air blowing out of the side, I don't know if i usually feel that are not


Hello. Take out your recovery tank, remove the lid, and re-attach lid rolling it from the front to the back, there are two tabs on the tank that the lid has to be aligned with, you will hear it "click" when it is tight. I think this might be the tri ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a 1697 powersteamer and it will not pick up the water after its been sprayed on the carpet--------Suckers Broke!


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

Unit heats, sprays solution out, but will not vacuum water back up from carpet.


There could be a couple of things wrong with this... first, make sure that the hose/floor selector is set to the floor setting. second, make sure that the rubber seal is there on the unit between where your clean/dirty water t ... Bissell 7950 ProHeat Upright Wet/Dry Vacuum

My carpet cleaner is not spraying out water or solution. motor is working, heater is working but nothing coming out when i press the button


Check if bottom of solution tank and/or lines are gummed up. Clean and blow out lines and inspect check ball assembly.\015\012Hope this helps. Could use more info.\015\012Bob ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

I have a bissell proheat 2?X carpet cleaner, the solution and water does not spray out on the upright machine, but the hand held one is working. How do I fix this please.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

The water sprayes out but will not pick up and go into the tank. It leaves the carpet soaked.


When such a problem occurs there are a couple of things which should be checked.Generally the vacuum does not pick up water as a result of low pressure in the suction. The suction hose should be checked for holes and proper connectivity. The se ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

I own a Bissell Proheat Pet Model 8910. After just a few uses and changing both the brush and pump belts (trying to resolve problem) carpet doesn't get wet any longer. Carpet solution comes out normally but the water barly leaves the section of the tank I fill water into, resulting in carpet recieving to much solution and not enough water. Any advice?


... Bissell 8910 ProHeat Clear View Upright Vacuum

Bissell will spray water when set to water rinse, but as soon as it is set to light, normal, or heavy cleaning, there is no spray. I have tried priming but to no avail. I put plain water in the solution tank to test without ay success. It is like it loses it's prime whenever you try to use a solution mix. Once you set it back to water rinse only and go through the priming steps, it is OK. Any help would be appreciated. Thanks.


Please check the following with liquid in both tanks.\012 \012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\012- Check for ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Bissell Pro 2x carpet cleaner. The water heats properly as well as spraying the cleaning product. However, when I go to suction the water from the carpets, the 2 in 1 water tank bladder works properly but there is no dirty water outside the bladder. I have only used this carpet cleaner ~ 5 times and in the beginning I had to empty the suctioned water quite frequently as it was dirty and it could not not hold any more water. So I have done 1 room and all the dirt remains in the carpet


Check that the suction cone is not blocked. Check that the filter or hose to the bladder isn't blocked as well. ... Vacuums

My hover extract deep cleaner won't spray water or cleaning solution


... Hoover F7431-900 SteamVac Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0759 seconds