Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

My F7458-900 leaks water when using upholstery tools I do have good suction, but water comes out fast on the bottom of machine.


Answers :

This sounds like the hose connection valve is bad. The part is about $12 -15. I would take it into a qualified repair shop for repair. This type of repair is worth it.
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My F7458-900 leaks water when using upholstery tools I do have good suction, but water comes out fast on the bottom of machine.


This sounds like the hose connection valve is bad. The part is about $12 -15. I would take it into a qualified repair shop for repair. This type of repair is worth it. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Little green machine pro heat pet the collection tank wasn't collection and dirty water was coming out of the bottom. i took it apart, cleaned it up and put a new "duckbill" gasket in. then it quit spraying, but i think i got that working again. now after i spray and get a good foam on the carpet, i switch to suction and it seems very weak. i can see the water moving (trickling) from the head into the hose but it is not reaching the collection tank -- actually, i am not sure where its goin


... Bissell THE BISSELL LITTLE GREEN MACHINE Vacuum

The Lower body of the Bissell QuickSteamer, water pours out from the body. Solution: I took apart the machine and there is a spring loaded valve with a rubber washer at the bottom. Think of the letter T upside down with the rubber washer on it. The washer stretches over the bottom and the spring creates a leakproof plug and won't allow water to pass till the button on the handle is pressed. This old washer came partially off and allowed water to leak. I purchased from the plumbing dept. a mi


... Bissell Vacuums

My Bissell ProHeat 2x is pouring water out of the bottom anytime it's turned on. I had it in the shop for no water, took it back again for the same problem, took it back again because it had no suction, finally took it apart and found the problem with the suction and fixed it myself. Worked fine for a day and now it is constantly leaking water, if it's turned on, and is useless for anything except for making a mess.


Took the unit apart and discovered my heater had small pinholes in the metal and they had put in silicone, instead of a gasket, which didn't seal. So much for the place I took it to "saving" my heater for me. I repaired it myself by getting a few o ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water leaks out the bottom of vac have new tank but the water still comes out the bottom while running like it is automatic no control


Hi Steve I have the same problem can you help if you were able to fix? ... Hoover F7220900 SteamVac V2 Upright Vacuum

Using my hoover steam vac tonight and too much water coming out. once it's turned on, water and shampoo continuously come out underneath until tanks are empty. looks to be leaking from left side bottom as looking at it standing behind the unit


Make sure that you have filled everthing properly and the hoover steam is in a good condition. or check else is there any loose coonections in the bottom of the hoover, which makes the tank empty.if the problem persists take it to service. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Water leaking When I fill the canister portion with hot water and put it in my machine it immediately begins to leak out the bottom. It has just started doing this. Do I need to take it in for repair?


The water tanks on this unit have had a very bad history of leaks. Most of the repair people had never heard of this unit, but one did, and had a spare set of tanks. If the unit is still under warranty, it is worth your while to get a replacement u ... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

November 2008 I bought a Simac Stirella 9000D steam generator iron. Recently its been leaking water out the bottom of the regenerator. It makes a noise when it is trying to get the steam to the iron and it works then but afterwards when the noise stops it stops steaming and I find a puddle of water underneath the regenerator. Also a little steam comes out of the water tank at the top. I understand this is happening because of scale in the base unit. Can I get something to get rid of the scale? -


... Vacuums

Sudsy water leaking from bottom of machine. Also it is not sucking the water out of the rug properly. Any ideas???


Sounds like the same problem i am having you may need a new clean tank here is the manual for your machine http://www.hoover.com/pdfs/manuals/F5914900.pdfGodbless ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Lately we've been having plumbing problems to where our washing machine floods up our bath tub and toilet. And it happens while we have the washing machine on of course. Another problem is that whenever we are taking a shower our tub starts to clog up and water starts pouring out from the bottom of our toilet. We had a plumber come by to root out our pipes just last week and it was fine for about 3 days. And now the problem is back and driving me crazy. WHAT IS WRONG AND HOW CAN I FIX IT??


Possible tree roots best thing is to hire a plumber with a camera snake ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

Water and cleaner not coming out, The machine is only 6m old and was working fine, I have cleaned every where I can to see if there was a blockage but nothing is working. The heater is working, there is a suction but the water and soap will not realease when triger is pulled. it will not work on on the tool spay.


Check the complede length of the hose. You may find a crimp in the most inconvenient place. You say you cleaned everything ... can you blow through the hose where the cleaner comes out? (don't drink anything!) ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I am having those same problems , brushes are not agitating . leaking water from the bottom of the unit , the suction is week it is not pulling the water out of the carpet .


... Eureka Atlantis 2595A Upright Wet/Dry Vacuum

The clean water is leaking straight out through the bottom of the machine. This just started out of the blue. I cannot use the machine because of this. Any ideas?


It sounds as if the reservoir is stuck open. If you look behind the upper tank, you will see a rod that opens the reservoir when the handle release is squeezed. This part may need replacement. ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

My hoover steam vac is leaking. the water seems to come out where it should by the brushes but it all leaks out even when not depressing the button. seems to be suctioning fine.


The problem you describe is a bad resevoir. I have replaced a few in this model series. Take it to an authorized dealer for repair. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Have a bissell pro steam cleaner the suction is great but the water leaks out the bottom I think it should spray from the front and the soap cleaner won't dispense from the bottle so I have to mix the soap cleaner in with the water Any solutions


Use this guide!\015\012http://newzealand.bissell.com/images/IncludeContent/Service_Center_Help ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My kenwood steam mop makes for very wet mopping is this supposed to be? My floors are a lot wetter than when I use a traditional mop. When I fill the tank and turn it on the water seems to just leak from the bottom so I have only been half filling it and then the water light comes on within 2 mins of when steam starts to appear. What am I doing wrong??


... Vacuums

When I squeeze the trigger, water won't come out of my Bissell PROheat2X carpet cleaner. The beater bar rotaotes, and there seems to be suction. Nothing comes out the bottom.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Severe water leak at the bottom when turned on.


It sounds like the tubing that is suppose to be hooked to two spray nozzles has come loose. You will have to take that dirt tank off, then turn the machine upside down and take the two screws out that hold the hood on from the bottom by the brushes, ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Leak from bottom of machine


... Hoover F7220900 SteamVac V2 Upright Vacuum

Water leaking out bottom with hose attached


The water hose plugs into the solution valve-pressure on the side of the noozle(bottom). There may be a water line that has come loose there, you will have to take the top off to get to it.\015\012 ... Hoover F7220900 SteamVac V2 Upright Vacuum

Not spraying solution or water from bottom or tools. Upon starting of machine, it spays a small amount, then appears to loose suction from tanks


... Bissell 7950 ProHeat Upright Wet/Dry Vacuum

Leaking water and soap from bottom rear of machine. How do you disassemble to find the problem?


VERY CAREFULLY! ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Vax carpet washer deluxe leaks from bottom of water tank, somewhere between coming out of the tank and going into the jet to squirt on the floor. pissing me off - any help would be great!


Just stripped VAX rapid carpet cleaner model v-025 down found out the internal plastic water valve keeps sticking in open position causing the water to free flow on the carpet when it should be closed pop the water flow regulator part out of housing ... Vacuums

My dyson 25 animal has lost suction from the floor portion of the machine. All the hot hair is coming off the front bottom part, by the ball. Its as if the connection of air has been disconnected. The attachment works fine, though.


You have a serious clog that must be removed. It is somewhere between the floor and the bag or where ever the dirt goes. Clear it and you will be back in business.\015\012\015\012Thanks for using fixya.com ... Vacuums

My problem is the leak is right where clean water tank sits, its on the bottom where it attaches to machine!!! i went through the booklet for instruction , i found nothing! what could it be?


Dirty, damaged, or missing gasket under tank mounting point. Possible damage at tank under-surface. ... Hoover F5906-900 Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1000 seconds