Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

It is not dispensing the shampoo on to the carpet.

Answers :

\015\012Firstly, please ensure that there is shampoo in the tank and the tank is correctly and fully inserted. There are 2 ways to dispense shampoo on to the carpet:
\015\0121. Use the solution trigger on the underside of the handle (numbered 2 in the picture below)
\015\0122. For tough stains use the "Clean Surge" button to dispense extra shampoo (numbered 3 in the picture below
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not

Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Wertheim w2550 carpet cleaner won't dispense shampoo

... Vacuums

Royal MRY7910 not dispensing water or soap? - Royal Vacuums Royal Procision MRY7910 Carpet Injector Vacuum Extractor, Shampoo Soap Dispenser, Brush On Off, Rinse, Finger Control, 8Hose, UphTool, 32Cord 7A 5YR

... Royal Vacuums Royal Procision MRY7910 Carpet Injector Vacuum Extractor, Shampoo Soap Dispenser, Brush On Off, Rinse, Finger Control, 8Hose, UphTool, 32Cord 7A 5YR

How to get my Bissell carpet shampooer to dispense shampoo

... Bissell 94Y2 Lift-Off Deep Cleaner Carpet Shampooer

After shampooing carpet there is no dirty water in dirty water dispenser

Normally this is caused by the dirty water reserves lid is not seated properly. Take the lid off completely. Make sure there is no residue on the\015\012rubber part that seals the tank. When putting the lid back on, put the\015\012back hinges on firs ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Bissell shampooer 1697-W. Will not dispense water to shampoo carpets....

That means that the pump belt is worn and needs to be replaced. Here is the belt you need and a manual you can view:Bissell Proheat Belt ... Vacuums

It is not dispensing the shampoo on to the carpet.

Hi,\015\012\015\012Firstly, please ensure that there is shampoo in the tank and the tank is correctly and fully inserted. There are 2 ways to dispense shampoo on to the carpet:\015\012\015\0121. Use the solution trigger ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My shampooer is fairly new (less than a year old) and I have only use it a couple of times. Yesterday when I went to shampoo my carpet it dispensed the soap but it wouldn't draw up the dirty water into the reservoir. Also the brushes are not moving. I cleaned out the filter and looked for debris but found none. What can I do?

Is it still under waranty? ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Bissel shampooer I have a bissell shampooer powersteamer power brush model 1694-W. I cant get it to dispense water onto the carpet anymore. I think it's because I let my 3 year old ride on it while I was shampooing. I assume I have depressed some special little part that is now broken or mashed or something. Stupid I know....

Yes there is a belt on the side that will need to be changed ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Carpet shampoo system


Royal carpet extractor 7910 won't dispense clear water

... Vacuums

Kirby Shampoo system not dispensing foam

Few possible causes1. Valve under the sponge (water tank) is clogged. Replacement HERE.2. Tray is now lo ... Kirby Ultimate G Bagged Upright Vacuum

For the first time, I tried using my Kirby Sentria shampoo attachment. I've lost the manual but found instructions online for making the swap from regular vac to shampoo-er and got it all assembled. The foam laid down just fine, however, when I run the vac back over the foam to pick it up, there is not a stitch of water showing up in the tray. First I thought maybe it was bc I hadn't put that much of the foam/water onto the carpet, but 12 hours later, the carpet is still wet in spots. Clearly

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=638285\015\012Generic problem for all Vacuums\015\012For the first time, I\015\012Posted by MHicks on J ... Vacuums

My Bissell proheat 2x model 9200 is not dispensing cleaning solution. I hold the trigger and the carpet doesnt get wet at all. i poured water on the carpet and it sucks it up. the cleaning solution does mix with the water but it not being dispensed on the floor.

Hi, \015\012when last did you service the machine?\015\012\015\012i believe should service the machine.\015\012try to open the machine.\015\012\015\012when opening make sure you notice where the part you are remov ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Shampoo dispenser I have a bissel turbo shampooer and it is not dispensing shampoo. any troubleshooting ideas

Just about ready to Throw the thing into the street and clean the floors the way my GRANDMOTHER DID .... ON my KNEES with a WOODEN BRUSH !!! NO ANSWERS ON THIS PAGE .... ... Vacuums

My carpet cleaner (bissell proheat plus) is not steaming, dispensing cleaner. Seems like there's a little thingy that should be spinning or turning..... When I work a small area of carpet, it just leaves behind dry blobs of carpet gunk like pet hair. I had to use a carpet sweeper to clean up. FYI - I filled the cleaning fluid container and after trying to clean the carpet, it did empty out but the carpet isn't wet. Any tips? The manual doesn't help.

You need to replace the pump belt. Here is the belt you need:Bissell ProHeat Belt ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Carpet Shampoo machine won't work

... Bissell Vacuums

When i shampoo my carpet, the solution is coming out , but I can't **** up the solution into the tank so therefore the water/solution stays on the carpet. What do I do.. I did one carpet last week and it was fine but not now.

Check to make sure your front panel is installed in the front of the recovery tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Make sure the lower tank lid is on securely, clean the intake filter on the top right of the machine. ensure the front panel is installed (the square to remove for hoe use). this has to be in place for carpet operation ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a very old kirby generation 3 unit that converst to a carpet shampooer. I was attemtping to shampoo the carpets but it does not seem to be picking any of the water back up out of the carpet. What am I missing?

Make sure the belt on the carpet shampoo aggitator is good, (could be stretched or broken) recommend replacing that belt. also make sure your fan in the front of the machine doesnt have any chips or cracks around the center. (this will cause lower su ... Vacuums

When I try to shampoo the carpet everything is working except it wont shampoo

... Vacuums

Hoover steam vac model 5853-900 has 5 brushes/cleaning dispensers, am only getting 2 small trickles of fluid when I dispense fluid onto carpet

The brushes come off, they are clipped on as an assembly if you look at the bottom of the machine you can see where the cover for the vacuum slot that brings up the water clips on too. If you remove that you can see the clips that hold the brush uni ... Vacuums

My Kirby shampooer - G4 - hardly used any water from the tank and no suds at all. Pet hair did blow out of the small slotted holes in the tray as I moved the shampooer back and forth, but the carpet was basically dry. I did vacuum before shampooing, so the brush part seemed to work great during shampooing, but no water! The small screen was stuck in the crook of the hose that attached to the tank so I did get that out and put it on the small hole on the tank, but it didn't make any difference. I

Few things:Make sure the sponge and the valve under the sponge (water tank) is clean.Make sure you follow the instructions (f you do not have the manual you can find one ... Kirby Ultimate G Bagged Upright Vacuum

Cleaning Solution The cleaning solution is not foaming properly. When cleaning the carpet only a very light foam is being dispensed from the unit onto the carpet.

Is the little suds screen missing from your shampooer tank? It should be covering the hole that the hose plugs onto. Sometimes they also get lodged in the hose sideways. ... Kirby G4 Bagged Upright Vacuum

My Bissell Proheat Turbo puts out too much water and cleaner and won't **** it back up like it should. Also when I use the attachments dirty water runs out the the hose when I am done. It's used a lot, I shampoo all the carpets about 2 times a month and I shampoo the funiture 1 time a month. I bought it about 3 months ago.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0457 seconds