Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

How do i get scrubber to **** water back up? - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Answers :

\015\012The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on the front of the dirty water tank is missing. The duct may have been removed to install the hose, and was not put back in place. It is a square plastic piece, about the size of a slice of sandwich bread, which slides into the front of the tank. A far less common reason for no pick-up is that the seal that the tank sits on has fallen off the motor cover suction tube. You will see a round tube on the bottom of the dirty water tank. This sits on top of a large rubber seal on the motor cover when the tank is in place. Be sure the seal has not fallen down into the hood.
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do i get scrubber to **** water back up? - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


\015\012The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My upright will not suck the water back up - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


ITS THE DUCT PIECE ON THE FRONT OF THE DIRTY WATER TANK (DWT). ITS NOT LINED UP. 1. TAKE LID OFF OF DWT2. SLIDE THE LITTLE SQUARE PIECE (5\\'X5\\'X1) (THE DUCT) ON THE FRONT OF THE DWT AS FAR UP AS POSSIBLE AND IF IT ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Is not sucking the water back up - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover spin scrub not giving water out - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My steam VAC upright wont **** up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common and simple problem with these involves the recovery tank. Take it off, remove the cover and check to be sure it fits snugly. All tabs must be locked front AND back. If this machine has tools you have to hook up in order to use you ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Brushes do not spin and not sucking up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Water hose keeps popping off? - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Try useing a small hose clamp on it. if there is room to get one on it. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

It is not dispensing water and solution - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Clean Water\012Solution Tank\012won't dispense.\0121. Clean Water Solution Tank\012not firmly in place.\0121. Make sure tank is securely locked in\012position.\0122. Clean Water Solution Tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Does not **** up the water after cleaning - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

IT WILL NOT PICK UP WATER - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common reason for this is that the lid is not fully seated on the dirty water tank. Be sure to hook the lid in front, and then snap it in place at the rear. Another problem could be that the duct is missing from the front of the tank. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Will no longer **** up the water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


\015\012The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Why it doesnt **** up the water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common reason for this is that the lid is not fully seated on the dirty water tank. Be sure to hook the lid in front, and then snap it in place at the rear. Another problem could be that the duct is missing from the front of the ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How to attach the stair scrubber attachment? - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The following Owners Manual shows the use of the product and acceessories:\015\012http://www.hoover.com/pdfs/manuals/F5914900.pdf\015\012\ ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The clean water tank is leaking terribly - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


This was a common problem for the models that were manufactured with a two piece tank. These tanks will have a colored soap container attached to a clear water tank. The plastic was too thin around the valves and would crack. You need a new style one ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

It doesn't seem to be picking up the water? - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Its not sucking any of the water up ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Won't pick up the water while cleaning - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Please check two three things:\015\012(1) Is the lid on the recovery tank aligned to the tank at rope seal of lid?\015\012(2) Is the rectangular panel in place in the front of the recovery tank, that connects the clear nozzle to the tank ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

It won't **** up the water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Suction blocked with hair or fibre. remove covers clean and re-test ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Will not **** up water. - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


\015\012The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Scrubber brush does not spin - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


There is a plastic piece on the back of the block brush (spin scrubbers) these wear out or break. You may need to replace the block brush. You can find the parts and a schematic below follow the link. Please don't forget to give positive feedback ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Cannot put back recovery tank front panel - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Steam vac sprays but won't suck up water... - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Will not dispense water on rinse cycle - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Upholstry brush will not dispense water, the suctin works and the floor cleaning part all works. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Need to install water supply hose - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Here is the manual > http://hoover.com/file/604/here is video instructions > ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How to clean the hood on hoover ls steamvac - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How to replace turbine on hoover steamvac - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1275 seconds