Having problems with your Hoover SteamVac F5914-900 SpinScrub Upright Vacuum ?

When the water sprays out leaves water lines on carpert . shouldn't the water spread out


Answers :

Http://www.youtube.com/watch?v=QBtWcC4gqjY

I found this solution on youtube. I believe the vacuum motor for the pump is not working and needs to be cleaned and oiled. See the video.
I Am having the same darn problem...Grrrr...Can anyone help???
Repair Help & Product Troubleshooting for Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When the water sprays out leaves water lines on carpert . shouldn't the water spread out


Http://www.youtube.com/watch?v=QBtWcC4gqjYI found this solution on youtube. I believe the vacuum motor for the pump is not working and needs to be clea ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Bissell carpet cleaner does not spray water only cleaning solution. Water does not leave bladder.


... Bissell 8910 ProHeat Clear View Upright Vacuum

My shampooer leaves a line of water. doesn't spray the area


Make sure you have the proper dispense of shampoo in your tank. Also try taking the speed down a little. If that does not work look at the video for further instructions ... Kirby Ultimate G Bagged Upright Vacuum

The water sprayes out but will not pick up and go into the tank. It leaves the carpet soaked.


When such a problem occurs there are a couple of things which should be checked.Generally the vacuum does not pick up water as a result of low pressure in the suction. The suction hose should be checked for holes and proper connectivity. The se ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

DZ9080 IRON IS NOT VERY OLD, BUT HAS HEATING AND STEAMING PROBLEMS. IT MAY BE ALL HEATING RELATED! MY WIFE WILL SOMETIMES JUST LEAVE IT "ON" FOR TWO HOURS AND THEN IT WILL START STEAMING AGAIN. I CANNOT MAKE SENSE OF THE HEATING INDICATORS; SOMETIMES IT WILL STAY GREEN NO MATTER WHERE YOU SET THE DIAL ---- AND IT DOES NOT FEEL HOT! WHEN I TRIED IT AGAIN TODAY, THE SHOT-OF-STEAM WORKED FOR A WHILE (AND THE SPRAY WORKED), BUT THEN ALL IT WOULD DO IS DRIP WATER AT THE TIP WHEN TIPPED DOWNWARD.


I couldn't find any warranty information on this iron, but I suspect that the heating element either has a faulty connection or part of it has cracked, making contact at time, but poor contact at other times. The unit will have to be taken apart an ... Rowenta Vacuums

I have a Bissel 9300-C 0714 BC Carpet Shampooer. It was working great and all of a sudden it stopped working. It still sucks up dirty water but it does not spray water onto the carpet. I can get it to spray water through the smallest hand attatchment but not through the large hand held piece on the base of the machine. I really hope you can help me, I am a dog groomer and I really need my machine to work properly. I can get it to spray water out of the smallest hand attatchment but that's all t


The spray jet has become clogged from the soap.... just clean it out. same thing happened to my attachment. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Have a Bissell Proheat2 will not spray water from the carpet power head but sprays from tools setting Does anyone know how to get water to spray or clean out water


I had this problem. It was small pieces of debris that got into the solution lines and clogged all the nozzles. There is a nozzle for the handheld attachments, one on the front of the machine for spraying spots and two nozzles underneath just behind ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell will spray water when set to water rinse, but as soon as it is set to light, normal, or heavy cleaning, there is no spray. I have tried priming but to no avail. I put plain water in the solution tank to test without ay success. It is like it loses it's prime whenever you try to use a solution mix. Once you set it back to water rinse only and go through the priming steps, it is OK. Any help would be appreciated. Thanks.


Please check the following with liquid in both tanks.\012 \012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\012- Check for ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Bissell proheat My Bissell won't dispense cleaning formula but it sprays water and sucks up the water. The attachments spray water but not the soap also. how to fix?


First is the smart mix valve turning like it should? If it is then replace the soap dispensor. Also is the gasket on the valve at the bottom of the bottle? ... Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum

The unit (9400-3) is not spraying water from the lower deck but will spray from the hand held wand. Checked water levels and water/soap dispenser valves which seem to be working fine. Spray nozzles are not blocked. Where do you look now.


Same problem i have got, spent one day on the bloody thing but of no use, the only solution is to spray water from bucket and use the cleaner to **** it up. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My bissell carpet shampooer won't spray out water


The tubes inside the machine are probably clogged. Dismantle top hood and disconnect the three lines at the pump, open up entire top housing and inspect heater. Disconnect two tubes and heater and blow out with air compressor. That will spray all the ... Bissell Carpet Cleaner Powerbrush Deep Cleaner Vacuum

Re. Proheat / Protech model No spray happens, I have made sure both the water bag is full & the cleaning fluid are both fully located, the water does seem to be getting into the carrier without having been sprayed.


Usually when it doesn't dispense water that means that the pump belt is worn. Here are the belts you need to replace and the manual:Biss ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

The tool attachment for the hose on my Bissell ProHeat 2X CleanShot won't spray soap or water. The bristles on the tool rotate without a problem and the suction is working fine, it just won't spray water when I pull the little gray trigger on the tool.


Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My bissell 1699 series will not spray water, the flow indicator barely moves, but when left tank on it leaked all over floor, so the water when left unattended came out. When I first hooked up the machine black stuff was on my carpet when I first sprayed.


... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Bissell proheat pet 8910 series won't spray any water from the base but it sprays water from the hose


... Bissell Vacuums

Why won't my machine spray water and why won't the cleaning fluid spray with the water?


Good to know that it worked.but keep updated with further queries if any.Disassembling and reassembling made the difference.As it can be some loose part or any component internally got stuck causing the no spray problem and when you Disassembled and ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water does not spray out on my model 8920. I cleaned many a things. The water does spray out of the tool position. Betty


Hi,\015\012\015\012Removed the water reservoir, which exposes the 2 main water sprays mounted above the rollers. Using, pliers, I carefully slid the clips back. Gently but firmly removed the two red nozzles. ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

My Bissell carpet cleaner will not spray water out the bottom but will spray water out of the hand held thing. What could be the problem and how do I fix it


Hey here is a guide on how to fix your problem.\015\012http://newzealand.bissell.com/images/In ... Vacuums

Water will not spray from floor nozzle but will spray from upholstery nozzle--solenoid broken? Bissell proheat 2X--took apart water is to the solenoid but not past it


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Water spray The water from the bottom of my carpet cleaner is not spraying. It comes out in lines and this doesn't clean the carpet evenly.


Are the brushes turning while you are shampooing? If not then this could be the problem. The turbine is what turns the brushes, it may have gone bad. ... Hoover V1 SteamVac SpinScrub Vacuum

Little green machine pro heat pet the collection tank wasn't collection and dirty water was coming out of the bottom. i took it apart, cleaned it up and put a new "duckbill" gasket in. then it quit spraying, but i think i got that working again. now after i spray and get a good foam on the carpet, i switch to suction and it seems very weak. i can see the water moving (trickling) from the head into the hose but it is not reaching the collection tank -- actually, i am not sure where its goin


... Bissell THE BISSELL LITTLE GREEN MACHINE Vacuum

Unit does not spray water for deep cleaning. One can hear the motor running of the ''spray'' action, but no water comes out. I have followed the DVD instructions exactly. Please advise Thanks Anne


Sounds like you have an air lock in line before motor. turn unit upside down and disconect hoses. reconnect and try again with plain water. good luck ... Vacuums

My bissell proheat 12 amp will not spray water on to the carpet,nor will the hand tools spray water?


The water is pumped via the belt that drives the pump. Remove the belt pump on the left side of the unit using a screwdriver and prying upward in the slot in the rear of the belt cover. The belt cover has holes in it. Check to make sure the belt is ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

It leaves water after finished. That's the first time I use it but it leave water on the floor and it stops.


According to iRobot make sure that the Scooba is clean, including the parts (vacuum hose & filter, bottom roller)\015\012Make sure the battery if fully charged, and that you let it complete the cycles! ... iRobot 5800 Scooba Vacuum

Me bissel 9200 won't spray water from bottom....and water gets to nozzle but also won't spray out.


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0480 seconds