Having problems with your Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum ?

Mach 6 shuts off

\015 Has anyone found a definative casue of this?\015

Answers :

If the vac shuts off and then turns back on after waiting a while. could be a thermal fuse. it is in the motor compartment. recommend a pro shop service this issue.
Repair Help & Product Troubleshooting for Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

While vacuuming with my hoover mach 5 it all the sudden shut down


Hi, If it is warm to the touch, and it just shut down all of a sudden, I would say that the motor has an internal over load switch that is normally closed, and opened to stop from burning this vac out. It is a built-in safety. I would look at the rol ... Vacuums

Mach 4.7 runs for 2.5 minutes and shuts off


Did you use it to vacuum up fine materials like powder? If you cleaned the filters, but they are original to the machine, replace them. Try changing the bag to a fresh one as well. Beyond that, check how freely the brush turns. If it doesn't turn fre ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Vacume is a mach 4 cyclonic, it runs for about 8 minutes and then it shuts itself off? any idea?


The only thing I can think of from your additional comments is when it warms up something expands and it loses continuity of the circuit. Most likely the switch or the breaker. Another thing to check is if it has a hepa filter it may be clogged ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

It is a Hoover mach 5 runs a few minutes then shuts off no power [email protected]


This sounds like a thermal limiter issue, usually caused by restricted air flow. Investigate until you find a blockage. ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Hoover mach 6.9 shuts off - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

My Mach 5 after 10 minutes just shuts down. Once it cools down about 4 hours it works for 5 minutes.


... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

I have a Hoover Mach 3 Cyclonic bagless upright vacuum. It works for a room or two and then it just shuts off. Then it won't turn back on for hours. Any suggestions on how to make it stop doing this? The canister is cleaned out.


This vacuum is very picky about air flow clean the filters and that should do it ... Vacuums

On our Hoover U6445-900 (Mach 6.9) we replaced the small belt that goes to beater brushes in front of unit. Upon starting, the Hoover quickly got hot and smoky. We shut it off and looked things over carefully, but the second try also resulted in friction heat on the belt. Now it appears the belt may have stretched due to heat and the brushes won't spin. Any ideas?


Are you sure you purchased the right size belt..the friction you speak of is usually caused by a belt not being the right tightness or a jammed beater brush ... Hoover U6446-900 WindTunnel Bagged Upright Vacuum

I have a Hoover Mach 2.7 Windtunnel that shut off during use and wouldn't turn back on. Was doing kitchen floor and running fine. Though a breaker tripped but didn't...what could it be?


Hello, \015\012\015\012It sounds like your thermal reset switch inside of your Hoover may have gone bad. When a vacuum cleaner doesn't turn on it, it's either caused by one of four things. \015\012\015\012Ele ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Foaming When vacuuming the shampoo into the dirty water bucket. it foams up so bad, It will only hold 1 1/2 cups of water. its a 2 quart bucket. then the float shuts off the the air and I'm left with foam coming out of the bottom of the mach. on to my carpet.


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover Mach 5 model number u5194-900 series ZF12.O will vacuum for about 15-10 min then it shuts its self off and will not turn back on., I have cleaned out all the hoses, filters and cleaned off brush. What can I do to fix this so that it will **** into the chamber. The hoses get clogged and it doesn't appear to be sucking into the "bag area"


... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

Hoover Mach 4 Overheats and shuts down after a few minutes


You have lost air flow due to blockage. Look for blockage in the throat of the machine where dirt enters from the floor. Do this by removing the base plate or opening throat inspection flap if so equipped. Also detach the hose and drop a coin through ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

Mach 6 shuts off


If the vac shuts off and then turns back on after waiting a while. could be a thermal fuse. it is in the motor compartment. recommend a pro shop service this issue. ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

I have a Hoover Wind Tunnel bagless mach 4.7 vacuum that shuts off after about 30 seconds. I suspect it is overheating, but there are no clogged lines. The on/off switch is in good working order. Help!!


Is your filter clean? you should be able to see the pleats in the filter pretty clearly. also the metal screen that is next to the filter should be clean as well. if the problem continues it could be a faulty thermal protector ( a device that shuts t ... Hoover Vacuums

My hoover mach 6 bagless overheats, shuts off for about an 1 hr will run again, all filters are clean, no blocks in hoses, how can i fix this problem


This is telling you that there is poor air flow or a blockage somewhere. To simply check for proper suction, remove the accessory hose to see if there is normal suction, if not then your problem is further in the unit. Troubleshooting from there will ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

Hoover mach 3 cyclone vacuum shut off during useage. can't turn it on. cleaned it out and let it sit thinking overheated? this is 2 months old. help?


I had same problem. Turned out to be the filter that sits above the waste cannister. Remove the waste cannister. There is a little orange lever that releases the filter. It was caked with dirt not allowing any air flow causing the motor to overheat. ... Vacuums

Mach 5 hoover turns off


Just got a solution off another website. There is a pre motor filter about the dust collection container. I opened mine and it was very dirty. I washed the filter and you are supposed to let it dry out for 24 hours. Hopefully this will work. Ano ... Vacuums

I have a Hoover Wind Tunnel Supreme mach 3.9. It


Check the filter above the dirt tank. If you take out the dirt cup and look where in slides into the machine, there is a filter that is probably dirty. It can be cleaned or replaced ... Hoover Vacuums

Hoover mach 5 only used 3 times


If the filters are ok, and there is no clog in the hose or dirt inlet down by the brushroll, then the motor protector is probably bad. ... Hoover Commercial C1660-900 Bagless Upright Cyclonic Vacuum

Vax Mach 7 - the brush bar won't rotate but the belts are fine


... Vacuums

My vacuum cleaner will run for a few minutes and then shuts off. The plug light on the panel blinks. I thought the motor was shut, but after a long time it will turn on again, but again, only for a few minutes and then shuts off again. Any ideas? I bought an Oxygen Ultra a few years ago, but I don't like it nearly as much as the old Epic.


I know nothing about your particular vacuum, but many vacuum cleaners these days have\015\012safety cut out's, which causes the motor to do exactly what you describe. Sadly blockages, faulty switches, over stretched cables, carbon brushes etc c ... Electrolux Epic 6500 Vacuum

I have an easy flo vacuum model # 199C and it won't shut off. It started out as an intermitent problem but now will not shut off when the hose is unplugged, nor when the off/on switch on the main unit is shut off. the only way to get the motor to stop running is to unplug the unit. Any ideas?


Just had this same problem. I unplugged the low voltage signal wires and the vacuum stayed on. Thus eliminating the possibility of the signal wires shorting out somewhere. I'm not really sure which wire(s) were causing the problem. But when I disasse ... Easy Flo EF1500 Vacuum

The machine shuts off!! will restart after a few minutes, but shuts right off again


... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Acuum shuts down after few minutes but can be restarted but will shut down again


... Hoover U5750-900 WindTunnel Bagless Upright Vacuum

Shut off The vacuum cleaner was working just fine until it just shut off!! I tried a different wall outlet but still won't work!! Called Hoover and they just want you to bring it in and pay for repairs!! Seems like it should be simple...Anyone who can help?


From your description, you problem sounds like it could be an electrial one, not very hard to diagnose, but some dis-assembly is required. you would have to remove the hood, motor cover, turbine just to get to the motor. I would check the carbon brus ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0165 seconds